Tremolo

Tremolo notation  Play  and compare with  normal technique .

In music, tremolo (Italian pronunciation: [ˈtrɛːmolo]), or tremolando ([tremoˈlando]), is a trembling effect. There are two types of tremolo.

The first is a rapid reiteration:

• of a single note, particularly used on bowed string instruments by rapidly moving the bow back and forth and plucked strings such as harp, where it is called bisbigliando (Italian pronunciation: [bizbiʎˈʎando]) or "whispering". Tremolo picking, in which a single note is repeated extremely rapidly, is also possible on classical guitar, acoustic guitar and electric guitar.
• between two notes or chords in alternation, an imitation (not to be confused with a trill) of the preceding that is more common on keyboard instruments. Mallet instruments such as the marimba are capable of either method.
• a roll on any percussion instrument, whether tuned or untuned.

A second type of tremolo is a variation in amplitude:

• as produced on organs by tremulants
• using electronic effects in guitar amplifiers and effects pedals which rapidly turn the volume of a signal up and down, creating a "shuddering" effect
• an imitation of the same by strings in which pulsations are taken in the same bow direction
• a vocal technique involving a wide or slow vibrato, not to be confused with the trillo or "Monteverdi trill"

Some electric guitars use a (misnamed) lever called a "tremolo arm" or "whammy bar" that allows a performer to lower or raise the pitch of a note or chord, which is known as vibrato or "pitch bend". This non-standard use of the term "tremolo" refers to pitch rather than amplitude. True tremolo for an electric guitar, electronic organ, or any electronic signal would normally be produced by a simple amplitude modulation electronic circuit. Electronic tremolo effects were available on many early guitar amplifiers. Tremolo effects pedals are also widely used to achieve this effect.

History

Although it had already been employed as early as 1617 by Biagio Marini and again in 1621 by Giovanni Battista Riccio,^[1] the bowed tremolo was invented in 1624 by the early 17th-century composer Claudio Monteverdi^[2][3] and, written as repeated semiquavers (sixteenth notes), used for the stile concitato effects in Il combattimento di Tancredi e Clorinda. The measured tremolo, presumably played with rhythmic regularity, was invented to add dramatic intensity to string accompaniment and contrast with regular tenuto strokes.^[3] However, it was not till the time of Gluck that the real tremolo became an accepted method of tone production.^[4] Four other types of historical tremolos include the obsolete undulating tremolo, the bowed tremolo, the fingered tremolo (or slurred tremolo), and the bowed-and-fingered tremolo.^[5]

The undulating tremolo was produced through the fingers of the right hand alternately exerting and relaxing pressure upon the bow to create a "very uncertain–undulating effect ... But it must be said that, unless violinists have wholly lost the art of this particular stroke, the result is disappointing and futile in the extreme," though it has been suggested that rather than as a legato stroke it was done as a series of jetés.^[3]

There is some speculation^[6] that tremolo was employed in medieval Welsh harp music, as indicated in the transcription by Robert ap Huw.

Notation

In musical notation, tremolo is usually notated as regular repeated demisemiquavers (thirty-second notes), using strokes through the stems of the notes. Generally, there are three strokes, except on note which already have beams or flags: quavers (eighth notes) then take two additional slashes, and semiquavers (sixteenth notes) take one.

In the case of semibreves (whole notes), which lack stems, the strokes or slashes are drawn above or below the note, where the stem would be if there were one.

Because there is ambiguity as to whether an unmeasured tremolo or regular repeated demisemiquavers (thirty-second notes) should be played, the word tremolo or the abbreviation trem., is sometimes added. In slower music when there is a real chance of confusion, additional strokes can be used.

If the tremolo is between two or more notes, both notes are given the full value of the passage and the bars are drawn between them:

In some music a minim-based (half note) tremolo is drawn with the strokes connecting the two notes together as if they were beams.

Bowed string instruments

Violin fingered tremolo; notice the joining of strokes and stems is different for different time values, and that some notes shorter than eighth notes are written out, such as the last thirty-second notes on the last beat of measure three:

Fingered tremolo notation^[7]

Violin bowed-and-fingered tremolo, notated the same as fingered tremolo but without slurs and with stacc. above the staff:

Bowed-and-fingered tremolo notation^[8]

See also

• Arpeggio, a chord played one note after the other
• Flexatone
• Leslie speaker, a rotating speaker horn

References