Staebler–Wronski effect

The Staebler–Wronski Effect (SWE) refers to light-induced metastable changes in the properties of hydrogenated amorphous silicon.

The defect density of hydrogenated amorphous silicon (a-Si:H) increases with light exposure, causing an increase in the recombination current and reducing the efficiency of the conversion of sunlight into electricity.

It was discovered by David L. Staebler and Christopher R. Wronski in 1977. They showed that the dark current and photoconductivity of hydrogenated amorphous silicon can be reduced significantly by prolonged illumination with intense light. However, on heating the samples to above 150 °C, they could reverse the effect.[1]

Explanation

Some experimental results

Suggested explanations

The exact nature and cause of the Staebler–Wronski effect is still not well known. Nanocrystalline silicon suffers less from the Staebler–Wronski effect than amorphous silicon, suggesting that the disorder in the amorphous silicon Si network plays a major role. Other properties that could play a role are hydrogen concentration and its complex bonding mechanism, as well as the concentration of impurities.

Historically, the most favored model has been the hydrogen bond switching model.[6] It proposes that an electron-hole pair formed by the incident light may recombine near a weak Si–Si bond, releasing energy sufficient to break the bond. A neighbouring H atom then forms a new bond with one of the Si atoms, leaving a dangling bond. These dangling bonds can trap electron-hole pairs, thus reducing the current that can pass through. However, new experimental evidence is casting doubt on this model. More recently, the H collision model proposed that two spatially separated recombination events cause emission of mobile hydrogen from Si–H bonds to form two dangling bonds, with a metastable paired H state binding the hydrogen atoms at a distant site.[7]

Effects

The efficiency of an amorphous silicon solar cell typically drops during the first six months of operation. This drop may be in the range from 10% up to 30% depending on the material quality and device design. Most of this loss comes in the fill factor of the cell. After this initial drop, the effect reaches an equilibrium and causes little further degradation. The equilibrium level shifts with operating temperature so that performance of modules tend to recover some in the summer months and drop again in the winter months.[8] Most commercially available a-Si modules have SWE degradation in the 10–15% range and suppliers typically specify efficiency based on performance after the SWE degradation has stabilized. In a typical amorphous silicon solar cell the efficiency is reduced by up to 30% in the first 6 months as a result of the Staebler–Wronski effect, and the fill factor falls from over 0.7 to about 0.6. This light induced degradation is the major disadvantage of amorphous silicon as a photovoltaic material.[9]

Methods of reducing the SWE

References

  1. Staebler, D. L.; Wronski, C. R. (1977). "Reversible conductivity changes in discharge-produced amorphous Si". Applied Physics Letters. 31 (4): 292. Bibcode:1977ApPhL..31..292S. ISSN 0003-6951. doi:10.1063/1.89674.
  2. J. M. Pearce, J. Deng, M. L. Albert, C. R. Wronski, and R.W. Collins, "Room Temperature Annealing of Fast States from 1 sun Illumination in Protocrystalline Si:H Materials and Solar Cells", 31st IEEE Photovoltaic Specialists Conf. Proc., (IEEE, 2005) pp. 1536-1539, 2005.
  3. J. Deng, J.M. Pearce, V. Vlahos, R.W. Collins, and C.R. Wronski, "Characterization of the Bulk Recombination in Hydrogenated Amorphous Silicon Solar Cells", Mat. Res. Soc. Symp. Proc. 808, A8.8, 2004.
  4. S. Y. Myong, S. W. Kwon, J. H. Kwak, K. S. Lim, J. M. Pearce, and M. Konagai, "Good stability of protocrystalline silicon multilayer solar cells against light irradiation originating from vertically regular distribution of isolated nano-sized silicon grains", 4th World Conference on Photovoltaic Energy Conversion Proceedings, p. 492, 2006.
  5. S. Y. Myong, K. S. Lim, J. M. Pears, "Double amorphous silicon-carbide p-layer structures producing highly stabilized pin-type protocrystalline silicon multilayer solar cells", Applied Physics Letters, 87(19), 193509 (2005); 87, 259901(2005).
  6. Kołodziej, A. (2004). "Staebler-Wronski effect in amorphous silicon and its alloys". Opto-Electronics Review. 12 (1): 21–32. Retrieved 31 October 2015.
  7. H.M. Branz, The hydrogen collision model: Quantitative description of metastability in amorphous silicon, Phys. Rev. B, 59 5498, 1999.
  8. Uchida,Y and Sakai,H. Light Induced Effects in a-Si:H Films and Solar Cells, Mat. Res. Soc. Symp. Proc., Vol. 70,1986
  9. Nelson, Jenny (2003). The Physics of Solar Cells. Imperial College Press.
  10. M.J.M. Pathak, J.M. Pearce and, S.J. Harrison, “Effects on Amorphous Silicon Photovoltaic Performance from High-temperature Annealing Pulses in Photovoltaic Thermal Hybrid DevicesSolar Energy Materials and Solar Cells, 100, pp. 199-203 (2012). arXiv.
  11. Staebler-Wronski effect in amorphous silicon PV and procedures to limit degradation, EY-1.1: 28 October 2005, Benjamin Strahm, Ecole Polytechnique Fédérale de Lausanne, Centre de Recherches en Physique des Plasmas(Power Point Slide Show)
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.