Relative growth rate

Relative growth rate (RGR) is growth rate relative to size. It is also called the exponential growth rate, or the continuous growth rate. In terms of differential equations, if is the current size, and its growth rate, then relative growth rate is . If the relative growth rate is constant, i.e., , it is not difficult to verify that a solution to this equation is . When calculating or discussing relative growth rate, it is important to pay attention to the units of time being considered.[1]

For example, if an initial population of bacteria doubles every twenty minutes, then at time it is given by the equation where is the number of twenty-minute intervals that have passed. However, we usually prefer to measure time in hours or minutes, and it is not difficult to change the units of time. For example, since 1 hour is 3 twenty-minute intervals, the population in one hour is . The hourly growth factor is 8, which means that for every 1 at the beginning of the hour, there are 8 by the end. Indeed, where is measured in hours, and the relative growth rate may be expressed as or approximately 69% per twenty minutes, and as or approximately 208% per hour.[1]

In plant physiology, RGR is a measure used to quantify the speed of plant growth. It is measured as the mass increase per aboveground biomass per day, for example as g g−1 d−1. It is considered to be the most widely used way of estimating plant growth, but has been criticised as calculations typically involve the destructive harvest of plants.[2] Another problem is that RGR nearly always decreases over time as the biomass of a plant increases, but traditionally this has been ignored when modelling plant growth. The RGR decreases for several reasons - non-photosynthetic biomass (roots and stems) increases, the top leaves of a plant begin to shade lower leaves and soil nutrients can become limiting. Overall, respiration scales with total biomass, but photosynthesis only scales with photosynthetic biomass and as a result biomass accumulates more slowly as total biomass increases.[3] The RGR of trees in particular slow with increasing size due in part to the large allocation to structural material of the trunk required to hold photosynthetic material up in the canopy. A novel approach to separate size effects from intrinsic growth differences is implemented and described in detail in Philipson et al. (2012).[4]

RGR is calculated using the following equation:[2]

Where:

= natural logarithm

= time one (e.g. in days)

= time two (e.g. in days)

= Size at time one

= Size at time two

References

  1. 1 2 William L. Briggs; Lyle Cochran; Bernard Gillett (2011). Calculus: Early Transcendentals. Pearson Education, Limited. p. 441. ISBN 978-0-321-57056-7. Retrieved 24 September 2012.
  2. 1 2 Hoffmann, W. A.; Poorter, H. (2002). "Avoiding Bias in Calculations of Relative Growth Rate". Annals of Botany. 90 (1): 37–42. PMID 12125771. doi:10.1093/aob/mcf140.
  3. Paine, C. E. T.; Marthews, T. R.; Vogt, D. R.; Purves, D.; Rees, M.; Hector, A.; Turnbull, L. A. (2012). "How to fit nonlinear plant growth models and calculate growth rates: An update for ecologists". Methods in Ecology and Evolution. 3 (2): 245. doi:10.1111/j.2041-210X.2011.00155.x.
  4. Christopher D. Philipson, Philippe Saner, Toby R. Marthews, Reuben Nilus, Glen Reynolds, Lindsay A. Turnbull, Andy Hector (2012) Light-based regeneration niches: evidence from 21 dipterocarp species using size-specific RGRs. Biotropica. doi:10.1111/j.1744-7429.2011.00833.x http://onlinelibrary.wiley.com/doi/10.1111/j.1744-7429.2011.00833.x/abstract;jsessionid=49E8727AE3DD4F0E2A0BD887E972B84F.d03t03
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.