Railway electrification in New Zealand

Railway electrification was initially adopted by the New Zealand Railways in New Zealand for long tunnels; the Otira Tunnel, the Lyttelton Rail Tunnel and the two Tawa Tunnels of the Tawa Flat Deviation. Electrification of Wellington suburban services started with the Johnsonville Line and Kapiti Line out of Wellington from the 1930s. Auckland suburban services were electrified in 2014–15. Electrification of long distance services on the North Island Main Trunk (NIMT) dates from 1986, although Kiwirail is now considering diesel operation of the NIMT. New long tunnels eg the Rimutaka Tunnel and the Kaimai Tunnel were operated by diesels, and the Otira and Lyttelton Tunnels have converted to diesel operation.

From 1908 to 1953 there was an electrified mine railway from the Stockton mine on the West Coast of the South Island.

Earlier NZR electrified routes from 1923 to the 1940s operated at 1500V DC, but the NIMT (1986) and Auckland suburban services (from 2014) use 25 kV AC; all with overhead catenary supply. The use of 16 kV AC (at 16.7 Hz) for the NIMT was proposed in 1950.

History

Stockton mine railway

The Stockton mine railway was, in 1908, New Zealand’s first electric railway. It carried coal from the Westport-Stockton Coal Companies mine to the NZR railhead at Ngakawau on the West Coast of the South Island from 1908 to 1953, when it was replaced by an aerial cableway. The line was 10.5 km long, with 2.4 km in two long tunnels. The system used 275 v DC from a low overhead line via trolley poles, and 915 mm gauge track. The seven locos were of low built “mine” type. ^[1]

Otira and Lyttelton Tunnels

An Eo class locomotive as used at Otira at the Ferrymead Heritage Park

The first NZR line to be electrified in New Zealand was the Otira Tunnel in 1923. This long tunnel (8.55 km) with a steep gradient (1 in 33) could not have been worked by steam. In 1916 there was consideration of electrification of the entire 100 km section with steep grades from Jackson (West Coast) to Springfield (Canterbury), but in 1923 just the Otira-Arthur’s Pass section (14 km) was electrified. ^[2]

In 1929 the Lyttelton Line through the Lyttelton Rail Tunnel was electrified. This tunnel (opened in 1867) was short and had a lesser gradient than Otira (0.3%) but replacement of steam operation was desirable. ^[3]

The Merz & McLellan Report

The 1925 report by the English consulting firm of Merz & McLellan was commissioned by the Minister of Railways Gordon Coates to investigate electrification of suburban services in the four main centres of Auckland, Wellington, Christchurch and Dunedin. For Christchurch it recommended electrification of the\ Lyttelton Line but not the main lines north and south. Now only Auckland and Wellington have suburban passenger services. The firm’s partner Charles Merz of Newcastle-upon-Tyne had reported on Melbourne suburban electrification in 1908 and 1912. ^{[4] [5]}

Wellington electrification

Several Wellington lines were then electrified: in 1938, the Johnsonville Line; and from 1940 the Kapiti Line section of the NIMT north of Wellington to Paekakariki through the two Tawa Tunnels which were part of the Tawa Flat Deviation. This line also had steep gradients (1 in 57) on the bank from Paremata up to Pukerua Bay. ^[6]

An EM Ganz-Mavag EMU on the Hutt Valley Line near Epuni, 2003

In February 1946 it was decided to electrify the remaining Wellington suburban lines to the Hutt Valley as there was a shortage of coal for locomotives, and also to replace commuter steam trains with EMUs, as the Hutt Valley was now largely residential with new state housing replacing market gardens. When the extra EMUs arrived in 1949 they were initially used for the Kapiti Line to Paekakariki while the Hutt Valley lines to Upper Hutt and Melling were electrified. So in the Hutt Valley, EMUs were supplemented in peak periods by older carriages hauled by electric locomotives until they were replaced by the Ganz-Mavag EMUs from 1986. ^[7]

An FP class Matangi EMU at Khandallah on the Johnsonville Line, 2011

The Johnsonville and Melling lines were short branch lines which were originally part of the main line (NIMT) north and the Hutt Valley line to the Wairarapa, until the lines replaced by deviations. The sections of these lines that were retained were mainly used for suburban commuter services, with initially some stock traffic to Johnsonville (later to Raroa). ^[8]

Dieselification

For two new long tunnels, diesel operation was more economic than a short electrified section; the Rimutaka Tunnel (1955) and the Kaimai Tunnel (1978). The Rimutaka Tunnel required an intermediate ventilation shaft. From 1967 diesel locomotives (Da class) replaced electric locomotives (Ew class) on freight trains south of Paekakariki on the Kapiti Line after the track in some older tunnels was lowered, so diesels could run under the catenary into Wellington.

On two existing electrified tunnels the electrified section was only a small part of the total line. Hence the Lyttelton Rail Tunnel was operated by diesel locomotives from 19 September 1970. The Otira Tunnel was long and steep, so for dieselisation from 1997 a door and special ventilation fans were fitted (electrification of the whole 100 km Springfield to Jackson section with its steep gradients had been considered in 1916 and in the 1950s; possibly using 50 Hz AC not DC).

Electrification of the NIMT

In 1950 electrification of the entire North Island Main Trunk (NIMT) from Auckland to Paekakariki (the terminus of the Wellington electrification) was proposed by the General Manager F. W. Aickin, with 16 kV AC (at 16.7 Hz) used for the 657 route miles or 1,000 km of track. The system would have been similar to that used in Northern Europe (also low-frequency but at 15 kV AC). While the NIMT represented only 12% of the network length, it carried 40% of the system tonnage (13% more than total South Island tonnage). A hundred Bo-Bo locomotives would be required, and in Auckland there would be suburban electric services to Henderson east of Auckland and to Papakura 34 km south of Auckland. A report by two Swedish engineers (Thelander and Edenius) was also obtained. Their report said electrification was a matter of necessity and estimated greater capital cost saving with AC electrification instead of DC (1500 V or 3000 V) than Aickin had allowed for. But the proposal was dropped in favour of dieselisation, with the first mainline DF class diesel locomotives arriving in 1954.^{[9] [10][11]}

In 1974 a study was undertaken to consider the looming problem of "traffic saturation" on the mountainous central section, particularly the Raurimu Spiral. In 1975 the study recommended electrification using 25 kV AC, but with decline in traffic was dropped. But in the late 1970s with the "oil shocks" of 1973 and 1979 the Third National Government embarked on several projects to reduce dependence on imported oil.^[12]

A NIMT EF locomotive in Bumble-Bee livery

Electrification of the 412-km centre section of the NIMT was one of the Think Big projects, and probably the most successful of them. The project was approved in December 1981; specifications were prepared in 1982 and tenders let in 1982–83. Other works improved the line by easing curves and gradients and replacing signalling. Work started in late 1984 and was completed in 1988—though on 24 June rather than March as planned—with a train traversing the whole section. Brush Traction supplied 22 EF class locomotives; the design was scaled up to the Eurotunnel Class 9 locomotives supplied by Brush for the Channel Tunnel.^[13]

In December 2016 Kiwirail announced that it proposed to dieselise this section of the NIMT due to the age of the present electric locomotives and the cost and time delays in changing locomotives at each end of the electrified section at Te Rapa and Palmerston North.^{[14][15][16][17][18]}

Electrification of the Auckland suburban network

A new AM class electric multiple unit at Puhinui in 2013, introduced as part of railway electrification in Auckland.

The extensive suburban rail network around Auckland which had been operated by steam and then by diesel was electrified using 25 kV AC between April 2014 and July 2015. Electrification goes 34 km south to Papakura, and there are no immediate plans to extend further south on the NIMT to Pukekohe or as far as Hamilton (the Waikato Connection and earlier Auckland-Hamilton passenger services have not succeeded).

Existing systems

Auckland metro

All electrified lines in the Auckland metro area uses the 25 kV 50 Hz AC system.

The system is fed from Transpower's 220 kV grid at two locations: Penrose and Southdown

North Island Main Trunk

The North Island Main Trunk uses the 25 kV 50 Hz AC system.

The system is fed from Transpower's 220 kV grid at four locations: Hamilton, Taumarunui, Tangiwai, and Bunnythorpe.

Wellington metro

All electrified lines in the Wellington metro area use the 1500 V DC system.

• Johnsonville Line: completed 2 June 1938
• Kapiti Line: Wellington Station to Paekakariki completed 1940; extended to Paraparaumu March 1983; extended to Waikanae 20 February 2011.
• Hutt Valley Line: Wellington Distant Junction to Taita completed 14 September 1953; extended to Upper Hutt 24 July 1955
• Melling Line

Woburn traction substation on the Hutt Valley Line

The Wellington metro system is fed by 18 traction substations, taking power from Wellington Electricity's (Welllington metro) or Electra's (Kapiti Coast) 11 kV distribution networks. There are also a number of cross-tie substations, which do not feed electricity into the lines but perform switching functions.

Traction substations

Further reading

• Churchman, Geoffrey B. (1995). Railway Electrification in Australia and New Zealand. Sydney & Wellington: IPL Books. ISBN 0-908876-79-3. 
• Leitch, David; Stott, Bob (1988). New Zealand Railways: The First 125 years. Auckland: Heinemann Reed. ISBN 0-7900-0000-8. 
• Sinclair, Roy (1987). Rail: The Great New Zealand Adventure. Wellington: Grantham House. pp. 86–91. ISBN 1-86934-013-2. 
• Pierre, Bill (1981). North Island Main Trunk: An Illustrated History. Auckland: Reed. ISBN 0-589-01316-5. 
• Redward, Roger (1974). Railway Electrification in New Zealand: An illustrated survey. Wellington: Southern Press. 
• Pickering, A J; Spicer, I D (ed) (1970). Pioneer Electrics: A survey of railway electrification in the South Island:. Christchurch: Tramways Historical Society. CS1 maint: Extra text: authors list (link)

References