Passive matrix addressing

Passive matrix addressing is an addressing scheme used in early LCDs. This is a matrix addressing scheme meaning that only m + n control signals are required to address an m × n display. A pixel in a passive matrix must maintain its state without active driving circuitry until it can be refreshed again.

The signal is divided into a row or select signal and a column or video signal. The select voltage determines the row that is being addressed and all n pixels on a row are addressed simultaneously. When pixels on a row are being addressed, a Vsel potential is applied, and all other rows are unselected with a Vunsel potential. The video signal or column potential is then applied with a potential for each m columns individually. An on-lighted pixel corresponds to a Von, an off-switched corresponds to a Voff potential.[1]

The potential across pixel at selected row i and column j is

and

for the unselected rows.[2]

Passive matrix addressed displays such as Ferro Liquid Display do not need the switch component of an active matrix display because they have built-in bistability. Technology for electronic paper also has a form of bistability. Displays with bistable pixel elements are addressed with a passive matrix addressing scheme, whereas TFT LCD displays are addressed using active addressing.

See also

References

  1. ↑ "First-Hand Histories: Liquid Crystal Display Evolution - Swiss Contributions". Engineering and Technology History Wiki. ETHW. Retrieved June 30, 2017.
  2. ↑ P. M. Alt, P. Pleshko Scanning limitations of liquid-crystal displays, IEEE Trans. Electron Devices, vol. ED-21, pp. 146–155, Feb. 1974.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.