National Semiconductor SC/MP

PMOS SC/MP die (ISP-8A/500)

The SC/MP from National Semiconductor is an early microprocessor, which became available in early 1974. The name SC/MP (pronounced "Scamp") is an acronym for: "Simple Cost-effective Micro Processor".

It features a 16-bit address and an 8-bit data bus. The program counter will roll-over on 12-bits (4096), there are separate instructions to alter the program counter to set the upper 4-bits, which are subsequently output on the address bus along with status signals. This provides a memory map of 16 pages each of 4 KB. Internally it provided five registers plus the program counter, but no stack pointer.

SC/MP unusual features

An advanced and unusual feature for the time, is the ability to release the buses, so that they can be shared by multiple processors. The linked datasheet shows an implementation with three SC/MP in a multi-processor configuration.

SC/MP increments the program counter before fetching the instruction, so that on reset it actually starts executing instructions from location 0001. This also needs to be taken into account for calculating displacements, since the offset will be added to the program counter which will be still pointing to the location of the displacement and not the next instruction.

To minimize chip count in control applications it has dedicated serial input and output pins to allow implementation of serial communications in software without the need for a UART (this feature was removed in the later SC/MP III).

Implementations

NMOS SC/MP-2 die (ISP-8A/600)

INS 8050 ISP-8A/500 SC/MP-1 Clocked at 1 MHz, first implementation (P Channel MOS technology)

INS 8060 ISP-8A/600 SC/MP-2 Clocked at 4 MHz (internally 2 MHz) first N Channel MOS version (single +5V supply)

INS 807x SC/MP-3 Clocked at 4 MHz (internally 2 MHz) included variations with up to 4 KB ROM (optional onboard BASIC (NIBL))

Uses

The SC/MP was also used as the basis of a single board microcontroller produced by Science of Cambridge (later Sinclair Research Ltd) called the MK14. Montgomery Elevator Co of Moline IL (later purchased by KONE, Inc) used the SC/MP as the basis for its first micro processor based elevator controller released in 1975. There are still many of these units running in buildings across the U.S.A.

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.