Physical layer

In the seven-layer OSI model of computer networking, the physical layer or layer 1 is the first and lowest layer.[1] This layer may be implemented by a PHY.

The physical layer consists of the networking hardware transmission technologies of a network.[2] It is a fundamental layer underlying the logical data structures of the higher level functions in a network. Due to the plethora of available hardware technologies with widely varying characteristics, this is perhaps the most complex layer in the OSI architecture.

The physical layer defines the means of transmitting raw bits rather than logical data packets over a physical link connecting network nodes. The bit stream may be grouped into code words or symbols and converted to a physical signal that is transmitted over a hardware transmission medium. The physical layer provides an electrical, mechanical, and procedural interface to the transmission medium. The shapes and properties of the electrical connectors, the frequencies to broadcast on, the modulation scheme to use and similar low-level parameters, are specified here.

Within the semantics of the OSI network architecture, the physical layer translates logical communications requests from the data link layer into hardware-specific operations to cause transmission or reception of electronic signals.

Physical signaling sublayer

In a local area network (LAN) or a metropolitan area network (MAN) using open systems interconnection (OSI) architecture, the physical signaling sublayer is the portion of the physical layer that:[3][4]

Relation to Internet Protocol

The Internet protocol suite, defined in RFC 1122 and RFC 1123, is a high-level networking description used for the Internet and similar networks. It does not define an equivalent layer that deals exclusively with hardware-level specifications and interfaces, as this model does not concern itself directly with physical interfaces. Several RFCs mention a physical layer and data link layer, but that is in the context of IEEE protocols. RFC 1122 and 1123 do not mention any physical layer functionality or physical layer standards.

List of services

The major functions and services performed by the physical layer are:

The physical layer is also concerned with:

Technologies

The following technologies provide physical layer services:

Network equipment

The following network equipment provides physical layer services:

See also

References

  1. ↑ Banzal, Shashi (2007). Data and Computer Network Communication. Firewall Media. p. 41.
  2. ↑ Iyengar, Shisharama (2010). Fundamentals of Sensor Network Programming. Wiley. p. 136.
  3. ↑  This article incorporates public domain material from the General Services Administration document "Federal Standard 1037C".
  4. ↑ "physical signaling sublayer (PLS)". Retrieved 2011-07-29.
  5. ↑ Bertsekas, Dimitri; Gallager, Robert (1992). Data Networks. Prentice Hall. p. 61. ISBN 0-13-200916-1.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.