Shot grouping

Two shot groupings obtained with different firearms at different distances.
The group on the left measures about 13 mm and was fired at about 45 meters, which equals 13 mm/45 m = 0.29 mils ( 1⁄2 in group at 50 yards, approx. 1.047′×50/100 = 0.524′).
The group on the right measures about 7 mm and was fired at about 90 meters, which equals 7 mm/90 m = 0.08 mils (0.3 in group at 100 yards, approx. 1.047′×0.3 = 0.314′).

In shooting sports, a shot grouping, or simply grouping, is the placement of multiple shots on a target, taken in one shooting session. The tightness of the grouping (the proximity of all the shots to each other) is a measure of the precision of a weapon, and a measure of the shooter's consistency and skill.[1][2]

Tightness of shot groupings are calculated by measuring the distance between bullet holes on the target (center-to-center) in length measurements such as millimeters or inches. Often that measurement is converted into angular measurements, such as milliradians or arcminutes, which also takes into account the firing distance to the target. Thus, by using angular measurements, one can compare the relative tightness of shot groupings fired at different distances.

Uses of the term

For firearms that shoot one round at a time, a shot grouping test can be used to measure the accuracy of the shooting system: the weapon's mechanical precision and the uniformity of the ammunition. The weapon is fixed into position on a test mount, and aimed at a target. Multiple shots using rounds from the same type and batch are fired to observe how the weapon groups the shots. If a person holds the weapon and shoots it, the grouping measures the combination of the person's skill and the weapon's accuracy.[2]

In shotgun shooting, the grouping is also called the pattern. The pattern is the spread of shot from a single shotgun shell, measured as the smallest circle containing all the shots on the target. The barrel of a shotgun is designed to deliver a wide or narrow grouping, depending on the expected use. Shooting at close range indicates a cylinder bore barrel to deliver a wide grouping, while for hunting at longer distances such as 50 yards or meters, a choke is recommended for a tighter grouping.[3]

In archery, a shot grouping is the result of one person shooting multiple arrows at a target. A tight grouping indicates consistency in form.[4]

Firearms

Diagram illustrating the relationship between distance, group size on the target (subtension) and angular group size.

Mean point of impact (MPI) is the calculated center of the grouping, which is the average center of all the shots, and is not necessarily located at a hole in the target.[2] The size of the grouping is described as the smallest circle containing all the shots.[5]

A "flier" is a shot from the same shooting session that is farther from the general shot group, considered to be outside of the grouping. Such shots may be the result of an unexpected gust of wind, a muscular flinch of the person shooting, or it may indicate a problem with the firearm mechanism. Rarely, it may indicate inconsistency in the ammunition.[6] Single fliers may be discounted when evaluating a grouping, but if fliers occur often, then the problem should be traced to its origin.[2]

While target shooting with a handgun, if a grouping is consistently off-center then the shooter is instructed to alter the body angle or the stance, rather than shifting the arm, wrist or hand, which should remain in position.[7]

Metric units

When using SI units, shooting accuracy is measured in milliradians by measuring the group size in millimeters (or in centimeters and multiplying by a factor of 10) and dividing by the range measured in meters.

Since shot grouping are small angles, the linear formula above can be used as a good approximation for group sizes in mils. The error of assuming that 0.1 mil equals 1 cm at 100 meters is about 1 × 10-7 (or 0.00001 %).

Imperial units

When using imperial units, shooting accuracy is measured in minutes of arc (symbol ′, sometimes called "minutes of angle" or short "moa") by measuring the group size in inches, multiplying by a factor of 100 and dividing by the range measured in yards.

The linear formula above for measuring group sizes in arcminutes is less precise than using milliradians together with metric units, but can still be a good approximation depending on the demands for precision. The error of assuming that 1′ equals 1" at 100 yd is about 4.5 %.

When shooting at a target 100 yards away, 1′ is a circle of approximately 1.047 inches in diameter,[8] while at 100 meters, 1′ is approximately a 29.1 millimeter circle. The arcminute is an arc-based measurement, with 1′ equal to one minute of one degree. The two-dimensional circle surrounding a shooter always has 21,600 arcminutes because there are 60 minutes in each degree, and 360 degrees in the circle.

Benchmarks

A big-game hunting rifle is considered accurate if its shots fall within 1.5′ (≈ 0.5 mil), while a rifle intended for small animals is expected to have an accuracy of 1′ or less (under 0.3 mil).[1] Handguns are typically less accurate; at a shooting distance of 25 yd, a grouping is considered acceptable for self-defense if the shots fall within a circle of 4 to 5" which is 15′ to 19′ (equivalent to a grouping of 100-150 mm at 25 meters, which is 4-6 mils).[9] Expensive and well-machined match-grade pistols demonstrate a higher accuracy than normal handguns, capable of groupings of 1.25" at 25 yards, which is about 5′ (equivalent to about 30 mm at 25 meters, which is 1.2 mil).[10]

Archery

With the increased element of human skill in archery, a grouping on target is more a measure of the archer's skill. If an archer is not getting a consistent grouping, then their basic form needs work. If an archer's arrows are grouping on target but off center, this shows consistent basic form, with better results achievable after slight adjustments.[4][11]

On the equipment side, bow stabilizers have been used since the 1960s by tournament competitors and by bow hunters to counteract the torque of shooting the arrow. A tighter grouping may be achieved with such a stabilizer, which adds mass extending outward on a moment arm, usually mounted perpendicular to the bow riser, aligned with the arrow path.[12][13][14]

Example groupings

References

  1. 1 2 Matunas, Edward (2003). Do-it-yourself Gun Repair: Gunsmithing at Home. Woods N' Water. pp. 65–6. ISBN 978-0-9722804-2-6.
  2. 1 2 3 4 Watson, David (2014). ABCs of Rifle Shooting. F+W Media. pp. 196–8. ISBN 978-1-4402-3897-0.
  3. ↑ Moller, Cliff. "Understanding Shotgun Chokes, A brief explanation by Briley". Briley Manufacturing. Retrieved August 10, 2015.
  4. 1 2 Engh, Douglas (2005). Archery Fundamentals. Human Kinetics. pp. 72–3, 86. ISBN 978-0-7360-5501-7.
  5. ↑ Gilbert, Randall (2003). A to Z Guide to White-tailed Deer and Deer Hunting. Woods N' Water. p. 87. ISBN 978-0-9707493-9-0.
  6. ↑ McDougall, Len (2013). The Self-Reliance Manifesto: Essential Outdoor Survival Skills. Skyhorse. pp. 172–75. ISBN 9781628733006.
  7. ↑ McGivern, Ed (2007). Ed McGivern's Book of Fast and Fancy Revolver Shooting. Skyhorse Publishing. p. 214. ISBN 978-1-60239-086-7.
  8. ↑ Dexadine Ballistics Software - ballistic data for shooting and reloading
  9. ↑ Campbell, Robert K. (2009). The Gun Digest Book of Personal Protection & Home Defense. Krause Publications. p. 31. ISBN 978-0-89689-938-4.
  10. ↑ Shideler, Dan; Sigler, Derrek; Ramage, Ken (2008). The Gun Digest Book of Tactical Gear. Gun Digest Books. p. 87. ISBN 978-0-89689-684-0.
  11. ↑ Haywood, Kathleen; Lewis, Catherine (2013). Archery: Steps to Success (4 ed.). Human Kinetics. p. 42. ISBN 978-1-4504-4468-2.
  12. ↑ Bertalan, Dan (2013). The Traditional Bowyers Encyclopedia. Skyhorse Publishing. p. 293. ISBN 978-1-62873-012-8.
  13. ↑ Haywood and Lewis 2013, p. 15.
  14. ↑ Ruis, Steve; Stevenson, Claudia (2004). Precision Archery. Human Kinetics. p. 131. ISBN 978-0-7360-4634-3.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.