Argus As 014
As 014 | |
---|---|
Argus As 014 of the V-1 flying bomb on display at the Royal Air Force Museum London | |
Type | Pulsejet |
Manufacturer | Argus Motoren |
First run | 1941 |
Major applications | V-1 flying bomb |
Number built | 31,100 |
The Argus As 014 (also known as the 109-014 by the RLM) was a pulsejet engine used on the German V-1 flying bomb of World War II, and the first model of pulsejet engine placed in mass production.
History
The origins of the Argus As 014 lie in 1928, when Munich inventor Paul Schmidt began work on a new design of pulse jet engine. Schmidt received a patent on his design in 1931 and received support from the German Air Ministry in 1933.
In 1934, along with Professor Georg Madelung, Schmidt proposed a "flying bomb" to be powered by his pulse jet to the Ministry and received a development contract the following year. In 1938 he demonstrated a pulse jet–powered pilotless bomber, but the project was shelved by the Air Ministry as the prototype lacked range and accuracy and was expensive to construct. That same year, however, the Argus Company began work on a flying bomb using Schmidt's engine. Schmidt later joined Argus in 1940. License manufacture of the As 014 was carried out in Japan in the latter stages of World War II, as the Ka10.
The Americans reverse-engineered the design for the Ford PJ31 powering the Republic-Ford JB-2 cruise missile and the experimental USAAF-developed JB-4 television-guided bomb.
Design and development
A model of simplicity and low cost, the engine was made from a sheet of mild steel rolled into a tube. At the front of the engine there was a spring flap-valve grid (shutters), a fuel inlet valve and an igniter. It could run on any grade of petroleum fuel and its shutter system was not expected to last longer than one flight, as it had an operational life of approximately one hour. The engine was a resonant jet which, contrary to popular legend, could operate while the V-1 was stationary on its launch ramp.
Operation
Ignition was initiated by an automotive-type spark plug located about 0.75 m (2 ft 6 in) behind the shutter system, electricity to the plug being supplied from a portable starting unit. Three air nozzles in the front of the pulse jet were connected to an external high pressure air source which was used to start the engine. Acetylene was used for starting, and very often a panel of wood or similar was held across the end of the tailpipe to prevent the fuel from diffusing and escaping before ignition was complete.
Once the engine had been started and the temperature rose to the minimum operating level, the external air hose and connectors were removed and the resonant design of the tailpipe kept the pulse jet firing. Each cycle or pulse of the engine began with the shutters open; fuel was injected behind them and ignited, and the resulting expansion of gases forced the shutters closed. As the pressure in the engine dropped following combustion, the shutters reopened and the cycle was repeated, roughly 45 to 55 times per second. The electrical ignition system was needed only to start the engine - a V-1 carried no coils or magnetos to power the spark plug once launched.
Since the engine was rather simple, low-grade gasoline could be used and a good amount of thrust — 2.7 kN (660 lbf) — was produced, but it was inefficient, limiting the range of the V-1 to 240–400 km (150–250 mi) The resonant frequency of this combustion process was around 45 Hz, giving the V-1 its nicknames "buzz bomb" or "doodlebug", because of the sputtering sound it emitted. The prototype engine was tested while slung below a Gotha Go 145 Luftwaffe training biplane marked D-IIWS[1] in April 1941 and the first prototype V-1 flew on December 24 of 1942. The As 014, as well as the higher thrust As 044 pulsejet engine, was also under consideration as a power source for various last-ditch German fighters in the closing days of World War II. Production totaled 31,100 units.[2]
Applications
- Blohm & Voss P.213
- Fieseler Fi 103R Reichenberg
- Junkers EF 126
- Messerschmitt Me 328
- V-1 flying bomb (Fieseler Fi 103)
Postwar
After the Second World War the As 014 was reverse-engineered / copied for use by the USA, as the Ford PJ31, on the Republic-Ford JB-2, and the Soviet Union as the Chelomey D-3 on the 10Kh (Fieseler Fi 103 look-alike).
Engines on display
The Planes of Fame Air Museum in Chino, California, constructed a reproduction of an As 014. The engine was demonstrated at the 2010 show.[3]
The V-1 flying bomb held by the London Science Museum features a sectioned As 014 engine, other museums displaying V-1s complete with their engines include the:
Specifications (As 014)
General characteristics
- Type: Pulse jet
- Length: 3,350 mm (132 in)
- Diameter:
- Dry weight:
Components
- Compressor: None
- Fuel type: Petrol
Performance
- Maximum thrust: 2.7 kN (660 lbf)
- Power-to-weight ratio:
See also
References
Notes
- ↑ "The LEMB Stammkennzeichen Database Project — Civilian D-xxxx Letter Codes". luftwaffe-experten.org. LEMB. Retrieved November 16, 2013.
- ↑ Gunston 1989, p.17.
- ↑ "Hitler’s Vengeance Weapon featuring The V-1 Buzz Bomb" (PDF). Planes of Fame Air Museum. May 2010. Retrieved January 10, 2015.
Bibliography
External links
Wikimedia Commons has media related to Argus As 014. |