Fog Investigation and Dispersal Operation

FIDO in operation at RAF Graveley, May 1945

Fog Investigation and Dispersal Operation (FIDO) (which was sometimes referred to as "Fog Intense Dispersal Operation" or "Fog, Intense Dispersal Of") was a system used for dispersing fog and pea soup fog (dense smog) from an airfield so that aircraft could land safely. The device was developed by Arthur Hartley for British RAF bomber stations, allowing the landing of aircraft returning from raids over Germany in poor visibility by burning fuel in rows on either side of the runway.

The FIDO system was developed at the department of chemical engineering of the University of Birmingham, United Kingdom, during the Second World War. The invention of FIDO is formally attributed to Dr John David Main-Smith, an ex-Birmingham resident & Principal Scientific Officer of the Chemistry Dept of the Royal Aircraft Establishment at Farnborough, Hants, and as a courtesy the joint-patent (595,907) held by the Ministry of Supply was shared by the department head Dr Ramsbottom as was normal practice at that date. This formal government recognition is enshrined in an Air Ministry postwar letter to the late inventor's late widow and held by the son Bruce Main-Smith (February 2008). It also deals with the lesser role of those developing support equipment, notably the FIDO burner.

"It is my memory", writes B Main-Smith, "that much of the airfield installation was pioneered at Hartford Bridge Flats airfield (aka Blackbushe near Yateley, Surrey [sic]) a convenient few miles from the RAE's Farnborough aerodrome." Though JD Main-Smith co-owned the FIDO patent, no royalties accrued from any UK civilian usage after World War II as there was none, it being too petrol-hungry. At an attempt to quantify the saving of aircrew life, B Main-Smith suggests possibly 11,000 airmen but not all would be fit to fly again....

"It is difficult for the modern (2008) UK resident to comprehend what World War II fogs were like. It was not uncommon for a person to be unable to see the hand at the end of an outstretched arm. The post-war Clean Air Act hugely ameliorated UK fogs", comments B Main-Smith.

The system

The device consisted of two pipelines situated along both sides of the runway and through which a fuel (usually the petrol from the airfield's own fuel dump) was pumped along and then out through burner jets positioned at intervals along the pipelines. The vapours were lit from a series of burners, producing walls of flame. The FIDO installation usually stored its fuel in four circular upright tanks built at the edge of the airfield with a low brick bund wall in case of leakage. The tanks were usually encased in ordinary brickwork as protection from bomb splinters or cannon fire.

When fog prevented returning Allied aircraft from locating and seeing their runways to land, they would be diverted to FIDO equipped aerodromes. RAF night bombers which were damaged on their missions were also diverted to FIDO airfields due to the need to make certain they could land when they arrived. When FIDO was needed, the fuel pumps were started to pour flammable liquid into the pipe system and a jeep with a flaming brand lashed to its rear drove fast down both sides of the runway to ignite the fuel at the outlets in the pipes. The burners were sometimes ignited by men on bicycles or by runners on foot.[1] The result was a row of flame along the side of the runway that could be seen for a great distance from the air. The heat from the flames evaporated suspended fog droplets so that the Allied aircraft could have suitable visibility to find the airfield and land. Once landed, the crews would find shelter where they could, and their planes would be refuelled and, if needed, repaired before flying back to their normal bases the next day.

The procedure for aircrew before the introduction of FIDO

Before the introduction of FIDO, fog had been responsible for losses of a number of aircraft returning from operations. Often large areas of the UK would be simultaneously fog-bound and it was recommended procedure in these situations for the pilot to point the aircraft towards the sea and then, while still over land, for the crew to bail-out by parachute, leaving the aircraft to subsequently crash in the sea. With raids often consisting of several hundred aircraft, this could amount to a large loss of bombers.

The use of FIDO

FIDO used huge quantities of fuel, as much as 100,000 gallons [125,000 US gallons, 450,000 litres] per hour. Over twice this amount was used by airfields with longer runways such as RAF Carnaby. Large fuel storage tanks filled with low-grade petrol and possibly kerosene and other fuel were connected by pumps to provide this fuel to the runway pipes. Although extravagant in the use of fuel consumed, the device more than made up for the costs involved in the reduction in aircraft losses.

FIDO systems were used at many RAF Stations in England during World War II.

RAF fields equipped with FIDO
[2]

The last FIDO-equipped airfield at which a system was maintained was RAF Manston, the system being available for emergency use as late as 1952. Due to the high costs involved use had to be reported to the Air Minister.

Initial installation of FIDO was designed and constructed along Runway 1 at London Heathrow Airport but the pipes and other fittings were never installed.

FIDO was also installed at North American airfields including Arcata, California, Eareckson Air Station, Naval Air Station Whidbey Island, at the World War Two Amchitka Army Airfield on Amchitka Island in the Aleutians.[3] It has been used to bring commercial planes into fog-covered airports in the United States.

Notes

  1. ↑ Williams (1995) p.184
  2. ↑ Williams (1995) pp. 43, 51, 59, 69, 82, 97, 106, 123, 135, 153, 162, 168, 176, 180, 190, 214, 216–217
  3. ↑ Williams (1995) pp. 216–224

References

Bibliography

  • Geoffrey Williams: FLYING THROUGH FIRE. FIDO - The Fogbuster of World War Two (Grange Books, London, UK, 1996, ISBN 1-85627-900-6).
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.