Field strength meter

In telecommunications, field strength meter is a measuring device which measures the signal strength caused by a transmitter.

The relation between the electric field and the transmitted power

In ideal free space, the electric field strength produced by a transmitter with isotropic radiator is readily calculated.^[1]

\mbox{E} = \frac{ \sqrt{30 \cdot P}}{d}

where

E is the electric field strength in volts per meter

P is the transmitter power output in watts

d is the distance from the radiator in meters

It is clear that electric field strength is inversely proportional to the distance between the transmitter and the receiver. However, this relation is impractical for calculating the field strength produced by terrestrial transmitters, where reflections and attenuation caused by objects around the transmitter or receiver may affect the electrical field strength considerably.

The factor ${\sqrt {30}}$ is an approximation of ${\sqrt {\frac {Z_{0}}{4\pi }}}$ where $Z_{0}=119.9169832\pi \Omega$ is the impedance of free space.

Field strength meter

Field strength meter is actually a simple receiver. After a tuner circuit, the signal is detected and fed to a microammeter, which is scaled in dBų. The frequency range of the tuner is usually within the terrestrial broadcasting bands. Some FS meters can also receive satellite (TVRO and RRO) frequencies. Most modern FS meters have AF and VF circuits and can be used as standard receivers. Some FS meters are also equipped with printers to record received field strength.

Antennas

When measuring with a field strength meter it is important to use a calibrated antenna such as the standard antenna supplied with the meter. For precision measurements the antenna must be at a standard height. A value of standard height frequently employed for VHF and UHF measurements is 10 metres (33 ft). Gain correction tables may be provided with the meter, that take into account the change of antenna gain with frequency.

Minimum field strength criteria

The CCIR defines the minimum field strength for satisfactory reception. These are shown in the table below.^[2] (Band II is reserved for FM radio broadcasting and the other bands are reserved for TV broadcasting.)

Frequency band	Minimum field strength in dBµV/m	Notes
Band I	48
Band III	55
Band IV	65
Band V	70
Band II	48	Rural area
Band II	60	Urban area
Band II	70	Large towns

References

↑ Reference Data for Radio Engineers, Howard W.Sams Co.Inc.,ISBN 0-672-21218-8, p 27-7
↑ K.H.Kaltbeitzer: Technical Monograph 3104, EBU Technical Centre, 1965, p.24

Analog television broadcasting topics
Systems	180-line 405-line ( System A ) 441-line 525-line ( System J , System M ) 625-line ( System B , System C , System D , System G , System H , System I , System K , System L , System N ) 819-line ( System E , System F )
Color systems	NTSC PAL PAL-M PAL-S PALplus SECAM
Video	Back porch and front porch Black level Blanking level Chrominance Chrominance subcarrier Colorburst Color killer Color TV Composite video Frame (video) Horizontal scan rate Horizontal blanking interval Luma Nominal analogue blanking Overscan Raster scan Safe area Television lines Vertical blanking interval White clipper
Sound	Multichannel television sound NICAM Sound-in-Syncs Zweikanalton
Modulation	Frequency modulation Quadrature amplitude modulation Vestigial sideband modulation (VSB)
Transmission	Amplifiers Antenna (radio) Broadcast transmitter/Transmitter station Cavity amplifier Differential gain Differential phase Diplexer Dipole antenna Dummy load Frequency mixer Intercarrier method Intermediate frequency Output power of an analog TV transmitter Pre-emphasis Residual carrier Split sound system Superheterodyne transmitter Television receive-only Direct-broadcast satellite television Television transmitter Terrestrial television Transposer
Frequencies & Bands	Frequency offset Microwave transmission Television channel frequencies UHF VHF
Propagation	Beam tilt Distortion Earth bulge Field strength in free space Knife-edge effect Noise (electronics) Null fill Path loss Radiation pattern Skew Television interference
Testing	Distortionmeter Field strength meter Vectorscope VIT signals Zero reference pulse
Artifacts	Dot crawl Ghosting Hanover bars Sparklies

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.