FR-2
FR-2 is an abbreviation for Flame Resistant 2. It is a NEMA designation for synthetic resin bonded paper, a composite material made of paper impregnated with a plasticized phenol formaldehyde resin, used in the manufacture of printed circuit boards. Its main properties are similar to NEMA grade XXXP (MIL-P-3115) material, and can be substituted for the latter in many applications.
Applications
FR-2 sheet with copper foil lamination on one or both sides is widely used to build low-end consumer electronic equipment. While its electrical and mechanical properties are inferior to those of epoxy-bonded fiberglass, FR-4, it is significantly cheaper. It is not suitable for devices installed in vehicles, as continuous vibration can make cracks propagate, causing hairline fractures in copper circuit traces. Without copper foil lamination, FR-2 is sometimes used for simple structural shapes and electrical insulation.
Properties
| Property | Value |
| Dielectric constant (Permittivity) | 4.5 @1 MHz |
| Dissipation factor | 0.024-0.26 @1 MHz |
| Dielectric strength | 740 V/mil |
Fabrication
FR-2 can be machined by drilling, sawing, milling and hot punching. Cold punching and shearing are not recommended, as they leave a ragged edge and tend to cause cracking. Tools made of high-speed steel can be used, although tungsten carbide tooling is preferred for high volume production.
Adequate ventilation or respiration protection are mandatory during high-speed machining, as it gives off toxic vapors.
Trade names and synonyms
- Lamitex
- Paxoline
- Paxolin
- Pertinax- Dielektra[1] brand (now defunct and taken over by Lamitec[2])
- Phenolic paper
- Synthetic Resin Bonded Paper (SRBP)
- Veroboard