Double stop

Cello triple and quadruple stops from the opening of Breval's Sonata in C major for cello and piano.  Play 

The beginning of Mozart's Eine Kleine Nachtmusik (1787). The First and Second Violins have a triple stop notated. The low D is to be bowed only briefly and left to ring. Shortly afterward the D and G are played normally.

In music, a double stop refers to the technique of playing two notes simultaneously on a bowed stringed instrument such as a violin, a viola, a cello, or a double bass. In performing a double stop, two separate strings are bowed or plucked simultaneously. Although the term itself suggests these strings are to be fingered (stopped), in practice one or both strings may be open.

A triple stop is the same technique applied to three strings; a quadruple stop applies to four strings. Double, triple, and quadruple stopping are collectively known as multiple stopping.

	Eine kleine Nachtmusik – 1. Allegro Performed by the Advent Chamber Orchestra. Notice the triple stop in the Violins at the first chord.
Problems playing this file? See media help.

Early extensive examples of the double-stop and string chords appear in Carlo Farina's Capriccio Stravagante from 1627, and in certain of the sonatas of Biagio Marini's op. 8 of 1629.

Bowing

Cello bridge holds strings over the finger and sounding boards.

On instruments with a curved bridge, it is difficult to bow more than two strings simultaneously. Early treatises make it clear that composers did not expect three notes to be played at once, even though the notes may be written in a way as to suggest this. Playing four notes at once is almost impossible. The normal way of playing three or four note chords is to sound the lower notes briefly and allow them to ring while the bow plays the upper notes (a broken chord). This gives the illusion of a true triple or quadruple stop. In forte, however, it is possible to play three notes at once, especially when bowed toward the fingerboard. With this technique more pressure than usual is needed on the bow, so this cannot be practiced in softer passages. This technique is mainly used in music with great force, such as the cadenza-like solo at the beginning of the last movement of Tchaikovsky's violin concerto.

A violin bridge blank (unfinished) and the finished bridge.

Bach bow

An invention called the "Bach bow" with an arched back uses a system of levers to slacken or tighten bow hair immediately while playing so as to (according to its advocates) facilitate the performance of polyphonic music. Such a bow was conceived early in the 20th century by Arnold Schering and Albert Schweitzer and constructed by Rolf Schröder in 1933.^[1] A similar device called the "Vega bow" was built in 1954 under the sponsorship of the violinist Emil Telmányi.^[2] Neither of these bows bears any particular relation to historical Baroque bows and neither has ever been widely employed.

Notation

In longer three-note or four-note chords, either the top note or the top two notes are sustained after the lower notes have been played as grace notes.^[3] Sometimes the noteheads for the lower notes are filled in to show they are of short duration while the noteheads for the notes to be held are left open. This notation occurs, for example, at the beginning of the fourth movement of Beethoven's fifth symphony.^[4]

Simultaneous notes in a single part for an orchestral string section may played as multiple stops or the individual notes may be distributed among the players within the section. Where the latter is intended, divisi or div. is written above the staff.^[5]

See also

• Music terminology

Sources