DORIS (geodesy)

The DORIS antenna and receiver installed onboard OSTM/Jason-2 satellite
Country/ies of origin  France
Operator(s) CNES
Type Civilian
Status Operational
Constellation size
First launch 1990 (1990)

Doppler Orbitography and Radiopositioning Integrated by Satellite or, in French, Détermination d'Orbite et Radiopositionnement Intégré par Satellite (in both case yielding the acronym DORIS) is a French satellite system used for the determination of satellite orbits (e.g. TOPEX/Poseidon) and for positioning.

Principle

Ground-based radio beacons emit a signal which is picked up by receiving satellites. This is in reverse configuration to other GNSS, in which the transmitters are space-borne and receivers are in majority near the surface of the Earth. A frequency shift of the signal occurs that is caused by the movement of the satellite (Doppler effect). From this observation satellite orbits, ground positions, as well as other parameters can be derived.

Organization

DORIS is a French system which was initiated and is maintained by the French Space Agency (CNES). It is operated from Toulouse.

Ground segment

The UHF transmitting antenna of DORIS ground station at Dionysos, Greece

The ground segment includes about 50-60 ground stations, equally distributed over the earth and ensure a good coverage for orbit determination. For the installation of a beacon only electricity is required because the station only emits a signal but does not receive any information. DORIS beacons transmit to the satellites on two UHF frequencies, 401.25 MHz and 2036.25 MHz.

Australian ground segments

There have been two active DORIS stations in Australia:[1]

Space segment

The best known satellites equipped with DORIS receivers are the altimetry satellites TOPEX/Poseidon, Jason 1 and Jason 2. They are used to observe the ocean surface as well as currents or wave heights. DORIS contributes to their orbit accuracy of about 2 cm.

Other DORIS satellites are the Envisat, SPOT, HY-2A and CryoSat-2 satellites.[2]

Positioning

Apart from orbit determination, the DORIS observations are used for positioning of ground stations. The accuracy is a bit lower than with GPS, but it still contributes to the International Terrestrial Reference Frame (ITRF).

References

  1. ↑ Australia, c\=AU\;o\=Australia Government\;ou\=Geoscience (15 May 2014). "Doppler Orbitography and Radiopositioning Integrated by Satellite". www.ga.gov.au. Geoscience Australia. Retrieved 24 June 2017.
  2. ↑ "Doris-Equipped Satellites".
  • G. Seeber: Satellite Geodesy. De Gruyter-Verlag, 2. Auflage (590 p.), Berlin 2003
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.