Buckley–Leverett equation

In fluid dynamics, the Buckley–Leverett equation is a conservation equation used to model two-phase flow in porous media.^[1] The Buckley–Leverett equation or the Buckley–Leverett displacement describes an immiscible displacement process, such as the displacement of oil by water, in a one-dimensional or quasi-one-dimensional reservoir. This equation can be derived from the mass conservation equations of two-phase flow, under the assumptions listed below.

Equation

In a quasi-1D domain, the Buckley–Leverett equation is given by:

{\frac {\partial S_{w}}{\partial t}}+{\frac {\partial }{\partial x}}\left({\frac {Q}{\phi A}}f_{w}(S_{w})\right)=0,

where $S_{w}(x,t)$ is the wetting-phase (water) saturation, $Q$ is the total flow rate, $\phi$ is the rock porosity, $A$ is the area of the cross-section in the sample volume, and $f_{w}(S_{w})$ is the fractional flow function of the wetting phase. Typically, $f_{w}(S_{w})$ is an 'S'-shaped, nonlinear function of the saturation $S_{w}$ , which characterizes the relative mobilities of the two phases:

f_{w}(S_{w})={\frac {\lambda _{w}}{\lambda _{w}+\lambda _{n}}}={\frac {\frac {k_{rw}}{\mu _{w}}}{{\frac {k_{rw}}{\mu _{w}}}+{\frac {k_{rn}}{\mu _{n}}}}},

where $\lambda _{w}$ and $\lambda _{n}$ denote the wetting and non-wetting phase mobilities. $k_{rw}(S_{w})$ and $k_{rn}(S_{w})$ denote the relative permeability functions of each phase and $\mu _{w}$ and $\mu _{n}$ represent the phase viscosities.

Assumptions

The Buckley–Leverett equation is derived based on the following assumptions:

Flow is linear and horizontal
Both wetting and non-wetting phases are incompressible
Immiscible phases
Negligible capillary pressure effects (this implies that the pressures of the two phases are equal)
Negligible gravitational forces

General solution

The characteristic velocity of the Buckley–Leverett equation is given by:

U(S_{w})={\frac {Q}{\phi A}}{\frac {\mathrm {d} f_{w}}{\mathrm {d} S_{w}}}.

The hyperbolic nature of the equation implies that the solution of the Buckley–Leverett equation has the form $S_{w}(x,t)=S_{w}(x-Ut)$ , where $U$ is the characteristic velocity given above. The non-convexity of the fractional flow function $f_{w}(S_{w})$ also gives rise to the well known Buckley-Leverett profile, which consists of a shock wave immediately followed by a rarefaction wave.

References

↑ S.E. Buckley and M.C. Leverett (1942). "Mechanism of fluid displacements in sands". Transactions of the AIME (146): 107–116.

External links

Buckley-Leverett Equation and Uses in Porous Media

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.