Dimethyl ether

Dimethyl ether
Names
Preferred IUPAC name
Methoxymethane
Other names
Dimethyl ether
R-E170
Demeon

Dimethyl oxide
Dymel A
Methyl ether
Mether

Wood ether
Identifiers
3D model (JSmol)
Abbreviations DME
1730743
ChEBI
ChemSpider
ECHA InfoCard 100.003.696
EC Number 204-065-8
KEGG
MeSH Dimethyl+ether
RTECS number PM4780000
UNII
UN number 1033
Properties
C2H6O
Molar mass 46.07 g·mol−1
Appearance Colorless gas
Odor Typical
Density 2.1146 kg/m3 (gas, 0 °C, 1013 mbar)[1]
0.735 g/mL (liquid, -25 °C)[1]
Melting point −141 °C; −222 °F; 132 K
Boiling point −24 °C; −11 °F; 249 K
71 g/L (at 20 °C (68 °F))
log P 0.022
Vapor pressure >100 kPa
-26.3·10−6 cm3/mol
1.30 D
Thermochemistry
65.57 J K−1 mol−1
−184.1 kJ mol−1
−1.4604 MJ mol−1
Hazards
Safety data sheet See: data page
≥99% Sigma-Aldrich
GHS pictograms
GHS signal word Danger
H220
P210, P410+403
NFPA 704
Flammability code 4: Will rapidly or completely vaporize at normal atmospheric pressure and temperature, or is readily dispersed in air and will burn readily. Flash point below 23 °C (73 °F). E.g., propane Health code 1: Exposure would cause irritation but only minor residual injury. E.g., turpentine Reactivity code 1: Normally stable, but can become unstable at elevated temperatures and pressures. E.g., calcium Special hazards (white): no codeNFPA 704 four-colored diamond
4
1
1
Flash point −41 °C (−42 °F; 232 K)
350 °C (662 °F; 623 K)
Explosive limits 27%
Related compounds
Related ethers
Diethyl ether

Polyethylene glycol

Related compounds
Ethanol

Methanol

Supplementary data page
Refractive index (n),
Dielectric constantr), etc.
Thermodynamic
data
Phase behaviour
solidliquidgas
UV, IR, NMR, MS
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
YesY verify (what is YesYN ?)
Infobox references

Dimethyl ether (DME), also known as methoxymethane, is the organic compound with the formula CH3OCH3, simplified to C2H6O. The simplest ether, it is a colorless gas that is a useful precursor to other organic compounds and an aerosol propellant that is currently being demonstrated for use in a variety of fuel applications. It is an isomer of ethanol.

Production

Approximately 50,000 tons were produced in 1985 in Western Europe by dehydration of methanol:[2]

2 CH3OH → (CH3)2O + H2O

The required methanol is obtained from synthesis gas (syngas).[3] In principle, the methanol could be obtained from organic waste or biomass. Other possible improvements call for a dual catalyst system that permits both methanol synthesis and dehydration in the same process unit, with no methanol isolation and purification.[3][4]

Both the one-step and two-step processes above are commercially available. Currently, there is more widespread application of the two-step process, since it is relatively simple and start-up costs are relatively low. There is also a one-step liquid-phase process in development.[3][5]

Applications

The largest use of dimethyl ether is as the feedstock for the production of the methylating agent, dimethyl sulfate, which entails its reaction with sulfur trioxide:

CH
3
OCH
3
+ SO
3
(CH
3
)
2
SO
4

Dimethyl ether can also be converted into acetic acid using carbonylation technology related to the Monsanto acetic acid process:[2]

(CH
3
)
2
O
+ 2 CO + H2O → 2 CH3CO2H

Laboratory reagent and solvent

Dimethyl ether is a low-temperature solvent and extraction agent, applicable to specialised laboratory procedures. Its usefulness is limited by its low boiling point (−23 °C (−9 °F)), but the same property facilitates its removal from reaction mixtures. Dimethyl ether is the precursor to the useful alkylating agent, trimethyloxonium tetrafluoroborate.[6]

Niche applications

A mixture of dimethyl ether and propane is used in an over-the-counter device to treat warts, by freezing them.[7][8]

Dimethyl ether is the main constituent of "freeze spray", a spot-coolant used in field testing of electronic components.[9] In this role it has supplanted halocarbon compounds (Freon), which have been suspected of contributing to ozone depletion in the Earth's atmosphere.

Dimethyl ether is also a component of certain high temperature "MAP-plus" blowtorch gas blends, supplanting the use of methyl acetylene and propadiene mixtures.[10]

Dimethyl either is also used as a propellant in aerosol products. Such products include hair spray, bug spray and some aerosol glue products.

Research

Fuel

Installation of BioDME synthesis towers at Chemrec's pilot facility

A potentially major use of dimethyl ether is as substitute for propane in LPG used as fuel in household and industry.[11]

It is also a promising fuel in diesel engines,[12] petrol engines (30% DME / 70% LPG), and gas turbines. For diesel engines, an advantage is the high cetane number of 55, compared to that of diesel fuel from petroleum, which is 40–53.[13] Only moderate modifications are needed to convert a diesel engine to burn dimethyl ether. The simplicity of this short carbon chain compound leads during combustion to very low emissions of particulate matter, NOx, and CO. For these reasons as well as being sulfur-free, dimethyl ether meets even the most stringent emission regulations in Europe (EURO5), U.S. (U.S. 2010), and Japan (2009 Japan).[14] Mobil uses dimethyl ether in their methanol to gasoline process.

Dimethyl ether is being developed as a synthetic second generation biofuel (BioDME), which can be manufactured from lignocellulosic biomass.[15] Currently the EU is considering BioDME in its potential biofuel mix in 2030;[16] the Volvo Group is the coordinator for the European Community Seventh Framework Programme project BioDME[17][18] where Chemrec's BioDME pilot plant based on black liquor gasification is nearing completion in Piteå, Sweden.[19]

At the European Shell Eco Marathon, an unofficial World Championship for mileage, vehicle running on 100% dimethyl ether drove 589 km/liter, fuel equivalent to gasoline with a 50 cc 2-stroke Diesel engine. As well as winning they beat the old standing record of 306 km/liter, set by the same team in 2007.[20]

Processes

The image below illustrates some of processes from various raw materials to dimethyl ether.

Refrigerant

Dimethyl ether is a refrigerant with ASHRAE refrigerant designation R-E170. It is also used in refrigerant blends with e.g. ammonia, carbon dioxide, butane and propene.[21]

Safety

Unlike other alkyl ethers, dimethyl ether resists autoxidation. Dimethyl ether is also relatively non-toxic, although it is highly flammable.

References

  1. 1 2 Record in the GESTIS Substance Database of the Institute for Occupational Safety and Health
  2. 1 2 Manfred Müller, Ute Hübsch, “Dimethyl Ether” in Ullmann’s Encyclopedia of Industrial Chemistry, Wiley-VCH, Weinheim, 2005. doi:10.1002/14356007.a08_541
  3. 1 2 3 Dimethyl Ether Technology and Markets 07/08-S3 Report, ChemSystems, December 2008.
  4. P.S. Sai Prasad et al., Fuel Processing Technology, 2008, 89, 1281.
  5. Air Products Technology Offerings
  6. T. J. Curphey (1988). "Trimethyloxonium tetrafluoroborate". Org. Synth.; Coll. Vol., 6, p. 1019
  7. "A Pharmacist's Guide to OTC Therapy: OTC Treatments for Warts". July 2006.
  8. http://www.fda.gov/cdrh/pdf3/K030838.pdf
  9. http://www.electrolube.com/products/msds/044FRE.pdf
  10. http://images.toolbank.com/downloads/cossh/0482.pdf
  11. IDA Fact Sheet DME/LPG Blends 2010 v1
  12. nycomb.se, Nycomb Chemicals company
  13. http://www.topsoe.com/site.nsf/all/BBNN-5PNJ3F?OpenDocument topsoe.com
  14. http://www.japantransport.com/conferences/2006/03/dme_detailed_information.pdf, Conference on the Development and Promotion of Environmentally Friendly Heavy Duty Vehicles such as DME Trucks, Washington DC, March 17, 2006
  15. http://www.biodme.eu/
  16. Biofuels in the European Union, 2006
  17. http://www.volvo.com/group/global/en-gb/newsmedia/pressreleases/NewsItemPage.htm?channelId=2184&ItemID=47984&sl=en-gb
  18. http://www.volvo.com/group/global/en-gb/volvo+group/ourvalues/environment/renewable_fuels/biodme/biodme.htm
  19. Chemrec press release September 9, 2010
  20. The Danish Ecocar Team - List of achievements
  21. http://www.ashrae.org/technology/page/1933#et ASHRAE list of refrigerants

https://docs.lib.purdue.edu/cgi/viewcontent.cgi?article=1955&context=iracc

http://www.eurammon.com/sites/default/files/attachments/eurammon12engl.pdf
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.