Ventilation/perfusion ratio

In respiratory physiology, the ventilation/perfusion ratio (or V/Q ratio) is a measurement used to assess the efficiency and adequacy of the matching of two variables:^[1]

"V" – ventilation – the air that reaches the alveoli
"Q" – perfusion – the blood that reaches the alveoli

VQ Ratio can therefore be defined as: the ratio of the amount of air reaching the alveoli to the amount of blood reaching the alveoli. These two variables, V & Q, constitute the main determinants of the blood oxygen (O2) and carbon dioxide (CO2) concentration.

The V/Q ratio can be measured with a ventilation/perfusion scan.

A V/Q mismatch can cause a type 1 respiratory failure.

Physiology

Ideally, the oxygen provided via ventilation would be just enough to saturate the blood fully. In the typical adult, 1 litre of blood can hold about 200 mL of oxygen; 1 litre of dry air has about 210 mL of oxygen. Therefore, under these conditions, the ideal ventilation perfusion ratio would be about 0.95. If one were to consider humidified air (with less oxygen), then the ideal v/q ratio would be in the vicinity of 1.0, thus leading to concept of ventilation-perfusion equality or ventilation-perfusion matching. This matching may be assessed in the lung as a whole, or in individual or in sub-groups of gas-exchanging units in the lung. On the other side Ventilation-perfusion mismatch is the term used when the ventilation and the perfusion of a gas exchanging unit are not matched.

The actual values in the lung vary depending on the position within the lung. If taken as a whole, the typical value is approximately 0.8.^[2]

Because the lung is centered vertically around the heart, part of the lung is superior to the heart, and part is inferior. This has a major impact on the V/Q ratio:^[3]

apex of lung – higher
base of lung – lower

In a subject standing in orthostatic position (upright) the apex of the lung shows higher V/Q ratio, while at the base of the lung the ratio is lower but nearer to the optimal value for reaching adequate blood oxygen concentrations. The main reason for lower V/Q ratios at the base is that both ventilation and perfusion increase when going from the apex to the base, but Q does it more strongly thus lowering the V/Q ratio. The principal factor involved in the genesis of V/Q dishomogeneity between the apex and the base of the lung is gravity (this is why V/Q ratios change in positions other than the orthostatic one).

Ventilation

Gravity and lung’s weight act on ventilation by increasing pleural pressure at the base (making it less negative) and thus reducing the alveolar volume. The lowest part of the lung in relation to gravity is called the dependent region. At the dependent region smaller volumes mean the alveoli are more compliant (more distensible) and so capable of wider oxygen exchanges with the external environment. The apex, though showing a higher oxygen partial pressure, ventilates less efficiently since its compliance is lower and so smaller volumes are exchanged.

Perfusion

The impact of gravity on pulmonary perfusion expresses itself as the hydrostatic pressure of the blood passing through the branches of the pulmonary artery in order to reach the apical and basal district of the lung, acting respectively against or synergistically with the pressure developed by the right ventricle. Thus at the apex of the lung the resulting pressure can be insufficient for developing a flow (which can be sustained only by the negative pressure generated by venous flow towards the left atrium) or even for preventing the collapse of the vascular structures surrounding the alveoli, while the base of the lung shows an intense flow due to the higher resulting pressure.

Pathology

Extreme alterations of V/Q

An area with perfusion but no ventilation (and thus a V/Q of zero) is termed "shunt."
An area with ventilation but no perfusion (and thus a V/Q undefined though approaching infinity) is termed dead space.^[4]

Of note, few conditions constitute "pure" shunt or dead space as they would be incompatible with life, and thus the term V/Q mismatch is more appropriate for conditions in between these two extremes.

Pathophysiology

A lower V/Q ratio (with respect to the expected value for a particular lung area in a defined position) impairs pulmonary gas exchange and is a cause of low arterial partial pressure of oxygen (paO₂). Excretion of carbon dioxide is also impaired, but a rise in the arterial partial pressure of carbon dioxide (paCO₂) is very uncommon because this leads to respiratory stimulation and the resultant increase in alveolar ventilation returns paCO₂ to within the normal range. These abnormal phenomena are usually seen in chronic bronchitis, asthma, hepatopulmonary syndrome, and acute pulmonary edema.

A high V/Q ratio decreases PACO2 and increases PAO2. This finding is typically associated with pulmonary embolism (where blood circulation is impaired by an embolus). Ventilation is wasted, as it fails to oxygenate any blood. A high V/Q can also be observed in emphysema as a maladaptive ventilatory overwork of the undamaged lung parenchyma. Because of the loss of alveolar surface area, there is proportionally more ventilation per available perfusion area. As a contrast, this loss of surface area leads to decreased arterial pO₂ due to impaired gas exchange (see Fick's laws of diffusion).

References

External links

Overview at anaesthesiauk.com
ventilation-perfusion ratio at the US National Library of Medicine Medical Subject Headings (MeSH)
Physiology: 4/4ch4/s4ch4_24 - Essentials of Human Physiology
RT Corner (Educational Site for RT's and Nurses) at rtcorner.net

Respiratory physiology

Respiration	positive pressure ventilation breath (inhalation exhalation) respiratory rate respirometer pulmonary surfactant compliance elastic recoil hysteresivity airway resistance bronchial hyperresponsiveness bronchoconstriction/Bronchodilatation

Control	pons pneumotaxic center apneustic center medulla dorsal respiratory group ventral respiratory group chemoreceptors central peripheral pulmonary stretch receptors Hering–Breuer reflex

Lung volumes	VC FRC Vt dead space CC PEF calculations respiratory minute volume FEV1/FVC ratio methods of lung testing spirometry body plethysmography peak flow meter nitrogen washout

Circulation	pulmonary circulation hypoxic pulmonary vasoconstriction pulmonary shunt

Interactions	Perfusion (V) ventilation (V) ventilation/perfusion scan zones of the lung gas exchange pulmonary gas pressures alveolar gas equation alveolar–arterial gradient hemoglobin oxygen–haemoglobin dissociation curve (Oxygen saturation 2,3-BPG Bohr effect Haldane effect) carbonic anhydrase (chloride shift) oxyhemoglobin respiratory quotient arterial blood gas diffusion capacity (DLCO)

Insufficiency	high altitude oxygen toxicity hypoxia

This article is issued from Wikipedia - version of the Friday, December 04, 2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.