Swashplate

Swashplate animation. The rotating shaft and plate are shown in silver. The fixed plate is shown in gold and six shafts each take a reciprocating motion from points on the gold plate. The shafts might be connected to pistons in cylinders. Note the power may be coming from the shaft to drive the pistons as in a pump, or from the pistons to drive the shaft rotation as in an engine.

A swashplate is a device used in mechanical engineering to translate the motion of a rotating shaft into reciprocating motion, or to translate a reciprocating motion into a rotating one to replace the crankshaft in engine designs.

Construction

A swashplate consists of a disk attached to a shaft. If the disk were aligned perpendicular to the shaft, then rotating the shaft would merely turn the disk with no reciprocating (or swashplate) effect. But instead the disk is mounted at an oblique angle, which causes its edge to appear to describe a path that oscillates along the shaft's length as observed from a non-rotating point of view away from the shaft. The greater the disk's angle to the shaft, the more pronounced is this apparent linear motion. The apparent linear motion can be turned into an actual linear motion by means of a follower that does not turn with the swashplate but presses against one of the disk's two surfaces near its circumference. The device has many similarities to the cam.

The swashplate engine uses a swashplate in place of a crankshaft to translate the motion of a piston into rotary motion. Internal combustion engines and Stirling engines have been built using this mechanism.

The axial piston pump drives a series of pistons aligned coaxially with a shaft through a swashplate to pump a fluid.[1]

A helicopter swashplate is a pair of plates, one rotating and one fixed, that are centered on the main rotor shaft. The rotating plate is linked to the rotor head, and the fixed plate is linked to the operator controls. Displacement of the alignment of the fixed plate is transferred to the rotating plate, where it becomes reciprocal motion of the rotor blade linkages. This type of pitch control, known as cyclic pitch, allows the helicopter rotor to provide selective lift in any direction.

Nutating flowmeters and pumps have similar motions to the wobble of a swashplate, but do not necessarily transform the motion to a reciprocating motion at any time.

Active Electronically Scanned Array (AESA) radars are flat plates that can scan up to sixty degrees in any direction from directly ahead of them. By mounting an AESA radar on a swashplate, the swashplate angle is added to the electronic scan angle. The typical swashplate angle chosen for this application is 40 degrees so the radar can scan a total angle of 200 degrees out of 360.[2]

Notes

  1. ↑ Harris et al
  2. ↑ Gripen NG AESA Radar

References

External links

See also

Swashplate (helicopter)

This article is issued from Wikipedia - version of the Thursday, February 04, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.