LFG Roland C.II
LFG Roland C.II | |
---|---|
Role | Reconnaissance Aircraft |
Manufacturer | Luft-Fahrzeug-Gesellschaft G.m.b.H. |
Designer | Dipl. Ing. Tantzen |
First flight | 1915 |
Introduction | 1916 |
Primary user | Luftstreitkräfte |
|
The LFG Roland C.II, usually known as the Walfisch (Whale), was an advanced German reconnaissance aircraft of World War I. It was manufactured by Luft-Fahrzeug-Gesellschaft G.m.b.H.
Characteristics
The C.II had much lower drag than comparable aircraft of its time. It featured a monocoque fuselage built with an outer skin of two layers of thin plywood strips at an angle to each other (known as a Wickelrumpf, or "wrapped body" design).[1] This had both lower drag and better strength per weight than typical of the time, but it was relatively slow and expensive to build. (This approach was further developed in the de Havilland Mosquito of World War II.) The deep fuselage completely filled the vertical gap between the wing panel center sections, eliminating any need for cabane struts commonly used in biplanes, and gave the aircraft its "whale" nickname. Struts and wires were reduced, short of suffering the weight penalty of cantilever wings, like those used on the pioneering all-metal Junkers J 1 of late 1915. There was even some attempt to flair the wings into the fuselage, to eliminate dead air space, a feature prominently missing from the Schneider Trophy contestants of the following decade. The engineer in charge of the design was Tantzen, who was a student of Ludwig Prandtl, the founder of mathematical aerodynamics and the one to introduce the concept of boundary layer.[2][3]
The C.II was powered by a single 160 hp (120 kW) Mercedes D III, providing a top speed of 165 km/h (103 mph), a ceiling of 4,000 metres (13,000 ft) and an endurance of four hours.
Operational history
The C.II entered service in the spring of 1916. Operationally, handling was reported as difficult but performance was relatively good. Due to the crew positions with eyes above the upper wing, upward visibility was excellent, but downward visibility was poor. It was also used in a fighter escort role and had a crew of two, pilot and observer/gunner.
Because of its speed, when it was first introduced, it could be intercepted only from above. Because of the lack of downward visibility, it was best attacked by diving below and coming up at it.[4]
Albert Ball, whose first victim was a C.II, said in the latter half of 1916 that it was "the best German machine now".
Variant
- C.II : Two-seat reconnaissance, escort fighter biplane.
- C.IIa : Generally similar to the Roland C.II, but fitted with revised and reinforced wingtips and larger vertical stabilizer.
- C.III : Development with two bay wings and a 200 hp (149 kW) Benz Bz.IV 6-cylinder water-cooled inline engine.
Operators
Specifications (C.II)
Data from Gray and Thetford p.161
General characteristics
- Crew: 2, pilot and observer
- Length: 7.7 m (25 ft 3 in)
- Wingspan: 10.3 m (33 ft 9 in)
- Height: 2.9 m (9 ft 6 in)
- Wing area: 26.00 m² (280.8 ft²)
- Empty weight: 764 kg (1,681 lb)
- Loaded weight: 1,284 kg (2,825 lb)
- Powerplant: 1 × Mercedes D.III water-cooled in-line, 160 hp (120 kw)
Performance
- Maximum speed: 165 km/h (103 mph) at sea level
- Service ceiling: 4,000 m (13,123 ft)
- Rate of climb: 12 minutes to 2,000 m (6,562 ft)
Armament
- Guns: 7.92 mm (0.312 in) Parabellum machine gun on a ring mounting in rear turret, forward-firing synchronized 7.92mm Spandau machine gun
- Bombs: four 12.5 kg bombs carried under the fuselage.
Comparable aircraft
References
Wikimedia Commons has media related to Roland C.II. |
- Notes
- Bibliography
- Gray, Peter; Thetford, Owen (1970). German Aircraft of the First World War. London: Putnam. ISBN 0-85177-809-7.
- Munson, Kenneth - Bombers, Patrol and Reconnaissance Aircraft 1914–1919 ISBN 0-7537-0918-X
- Munson, Kenneth (1967). Aircraft Of World War I. London: Ian Allen. p. 71.
|
|
|