Recoil start

Starting a Lazair II ultralight aircraft's JPX PUL 425 engine, equipped with a recoil starter.

Recoil start (also called manual start, pull start, or zip start) refers to a method of starting an internal combustion engine, usually on small machines, such as lawn mowers, chainsaws, ultralight aircraft and portable engine-generators. Recoil start is also used on some small vehicles such as small go-karts, minibikes, and small ATVs.

Modern version

The starter consists of a rope with a grip at the end, coiled around an end of the crankshaft. When the rope's grip is pulled, the rope uncoils around the end of the crankshaft, spinning it to crank the engine. After the rope is pulled, the flywheel keeps spinning and the engine starts. If the grip is not returned gently, it can damage the starter by the rope getting tangled in the mechanism. The rope is not directly connected to the crankshaft itself, but to reel that is connected the crank by a racheting mechanism. When the rope is pulled, the rachet engages the crankshaft and forces it to spin as well. Once the engine starts, the rachet mechanism allows the crankshaft to keep spinning, while a coil spring inside the reel mechanism reverses its direction and recoils the rope (hence "recoil starter"). If the reel were directly connected to the crank, once the rope reached its end, the spinning crankshaft would keep turning the reel, which would violently recoil the rope in the opposite direction until it reached its end, where it would likely jam and stall the engine.

Old version

There is an older, simpler version of pull starter that has a reel directly connected to the crankshaft, and a rope that is not connected to the reel. The rope is wound around the reel and pulled, starting the engine, but once the end of the pull is reached, it comes free, leaving a loose rope in the person's hand. If the engine fails to start on the first pull, the operator has to re-wind it by hand. This is also done when the engine is shut down to prepare it for the next start.

Easy start feature

Most modern engines have an easy start feature where one of the engine valves is held open by a special cam while the rope is being pulled, avoiding the need to overcome compression. This cam is deactivated at the end of the "pull" so that the engine can fire and run by itself.

References

Aircraft piston engine components, systems and terminology

Piston engines

Mechanical components	Camshaft Connecting rod Crankpin Crankshaft Cylinder Cylinder head Gudgeon pin Hydraulic tappet Main bearing Obturator ring Oil pump Piston Piston ring Poppet valve Pushrod Rocker arm Sleeve valve Tappet

Electrical components	Alternator Capacitor discharge ignition Dual ignition Electronic fuel injection Generator Ignition system Magneto Spark plug Starter

Terminology	Air-cooled Aircraft engine starting Bore Compression ratio Dead centre Engine displacement Four-stroke engine Horsepower Ignition timing Manifold pressure Mean effective pressure Naturally aspirated Monosoupape Overhead camshaft Overhead valve engine Rotary engine Shock cooling Stroke Time between overhaul Two-stroke engine Valve timing Volumetric efficiency

Propellers

Components	Propeller governor Propeller speed reduction unit Spinner

Terminology	Autofeather Blade pitch Constant-speed Contra-rotating Counter-rotating Scimitar Single-blade Variable-pitch

Engine instruments

Engine controls

Fuel and induction
system

Other systems

This article is issued from Wikipedia - version of the Thursday, January 29, 2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.