Water table

For the architectural feature, see Water table (architecture).
Cross section showing the water table varying with surface topography as well as a perched water table

The water table is the surface where the water pressure head is equal to the atmospheric pressure (where gauge pressure = 0). It may be conveniently visualized as the "surface" of the subsurface materials that are saturated with groundwater in a given vicinity. However, saturated conditions may extend above the water table as surface tension holds water in some pores below atmospheric pressure.[1] Individual points on the water table are typically measured as the elevation that the water rises to in a well screened in the shallow groundwater.

The groundwater may be from infiltrating precipitation or from groundwater flowing into the aquifer. In areas with sufficient precipitation, water infiltrates through pore spaces in the soil, passing through the unsaturated zone. At increasing depths water fills in more of the pore spaces in the soils, until the zone of saturation is reached. In permeable or porous materials, such as sands and well fractured bedrock, the water table forms a relatively horizontal plane. Below the water table, in the phreatic zone, permeable units that yield groundwater are called aquifers. The ability of the aquifer to store groundwater is dependent on the primary and secondary porosity and permeability of the rock or soil. In less permeable soils, such as tight bedrock formations and historic lakebed deposits, the water table may be more difficult to define.

The water table should not be confused with the water level in a deeper well. If a deeper aquifer has a lower permeable unit that confines the upward flow, then the water level in a well screened in this aquifer may rise to a level that is greater or less than the elevation of the actual water table. The elevation of the water in this deeper well is dependent upon the pressure in the deeper aquifer and is referred to as the potentiometric surface, not the water table.[1]

Form

The water table may vary due to seasonal changes such as precipitation and evapotranspiration. In undeveloped regions with permeable soils that receive sufficient amounts of precipitation, the water table typically slopes toward rivers that act to drain the groundwater away and release the pressure in the aquifer. Springs, rivers, lakes and oases occur when the water table reaches the surface. Springs commonly form on hillsides, where the Earth's slanting surface may "intersect" with the water table. Groundwater entering rivers and lakes accounts for the base-flow water levels in water bodies.

Surface topography

Within an aquifer, the water table is rarely horizontal, but reflects the surface relief due to the capillary effect in soils, sediments and other porous media. In the aquifer, groundwater flows from points of higher pressure to points of lower pressure, and the direction of groundwater flow typically has both a horizontal and a vertical component. The slope of the water table is known as the hydraulic gradient, which depends on the rate at which water is added to and removed from the aquifer and the permeability of the material. The water table does not always mimic the topography due to variations in the underlying geological structure (e.g., folded, faulted, fractured bedrock)

Perched water tables

A perched water table (or perched aquifer) is an aquifer that occurs above the regional water table, in the vadose zone. This occurs when there is an impermeable layer of rock or sediment (aquiclude) or relatively impermeable layer (aquitard) above the main water table/aquifer but below the surface of the land. If a perched aquifer's flow intersects the Earth's dry surface, at a valley wall for example, the water is discharged as a spring.

Fluctuations

Seasonal fluctuations in the water table. During the dry season, river beds may dry up.

Tidal fluctuations

On low-lying oceanic islands with porous soil, freshwater tends to collect in lenticular pools on top of the denser seawater intruding from the sides of the islands. Such an island's freshwater lens, and thus the water table, rises and falls with the tides.

Seasonal fluctuations

In some regions, for example, Great Britain or California, winter precipitation is often higher than summer precipitation and so the groundwater storage is not fully recharged in summer. Consequently, the water table is lower during the summer. This disparity between the level of the winter and summer water table is known as the "zone of intermittent saturation", wherein the water table will fluctuate in response to climatic conditions.

Long-term fluctuations

Fossil water is groundwater that has remained in an aquifer for several millennia and occurs mainly in deserts. It is non-renewable by present-day rainfall due to its depth below the surface, and any extraction causes a permanent change in the water table in such regions.

Effects on climate

Aquifer drawdown or overdrafting and the pumping of fossil water may be a contributing factor to sea-level rise.[2]

See also

References

  1. 1 2 Freeze, R. Allan; Cherry, John A. (1979). Groundwater. Englewood Cliffs, NJ: Prentice-Hall. OCLC 252025686.
  2. ↑ "Rising sea levels attributed to global groundwater extraction". University of Utrecht. Retrieved February 8, 2011.
This article is issued from Wikipedia - version of the Monday, December 14, 2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.