Pelagic sediment

Pelagic sediment or pelagite is a fine-grained sediment that accumulates as the result of the settling of particles to the floor of the open ocean, far from land. These particles consist primarily of either the microscopic, calcareous or siliceous shells of phytoplankton or zooplankton; clay-size siliciclastic sediment; or some mixture of these. Trace amounts of meteoric dust and variable amounts of volcanic ash also occur within pelagic sediments. Based upon the composition of the ooze, there are three main types of pelagic sediments: siliceous oozes, calcareous oozes, and red clays.[1][2]

The composition of pelagic sediments is controlled by three main factors. The first factor is the distance from major landmasses, which affects their dilution by terrigenous, or land-derived, sediment. The second factor is water depth, which affects the preservation of both siliceous and calcareous biogenic particles as they settle to the ocean bottom. The final factor is ocean fertility, which controls the amount of biogenic particles produced in surface waters.[1][2]

Oozes

In case of marine sediments, ooze does not refer to a sediment's consistency, but to its composition, which directly reflects its origin. Ooze is pelagic sediment that consists of at least 30% of microscopic remains of either calcareous or siliceous planktonic debris organisms. The remainder typically consists almost entirely of clay minerals. As a result, the grain size of oozes is often bimodal with a well-defined biogenic silt- to sand-size fraction and siliciclastic clay-size fraction. Oozes can be defined by and classified according to the predominate organism that compose them. For example, there are diatom, coccolith, foraminifera, globigerina, pteropod, and radiolarian oozes. Oozes are also classified and named according to their mineralogy, i.e. calcareous or siliceous oozes. Whatever their composition, all oozes accumulate extremely slowly, at no more than a few centimeters per millennium.[2][3]

Calcareous ooze is ooze that is composed of at least 30% of the calcareous microscopic shells—also known as tests—of foraminifera, coccolithophores, and pteropods. This is the most common pelagic sediment by area, covering 48% of the world ocean's floor. This type of ooze accumulates on the ocean floor at depths above the carbonate compensation depth. It accumulates more rapidly than any other pelagic sediment type, with a rate that varies from 0.3–5 cm/1000 yr.[1][2]

Siliceous ooze is ooze that is composed of at least 30% of the siliceous microscopic "shells" of plankton, such as diatoms and radiolaria. Siliceous oozes often contain lesser proportions of either sponge spicules, silicoflagellates or both. This type of ooze accumulates on the ocean floor at depths below the carbonate compensation depth. Its distribution is also limited to areas with high biological productivity, such as the polar oceans, and upwelling zones near the equator. The least common type of sediment, it covers only 15% of the ocean floor. It accumulates at a slower rate than calcareous ooze: 0.2–1 cm/1000 yr.[1][2]

Red and brown clays

Main article: Pelagic red clay

Red clay, also known as either brown clay or pelagic clay, accumulates in the deepest and most remote areas of the ocean. It covers 38% of the ocean floor and accumulates more slowly than any other sediment type, at only 0.1-0.5 cm/1000 yr.[1] Containing less than 30% biogenic material, it consists of sediment that remains after the dissolution of both calcareous and siliceous biogenic particles while they settled through the water column. These sediments consist of aeolian quartz, clay minerals, volcanic ash, subordinate residue of siliceous microfossils, and authigenic minerals such as zeolites, limonite and manganese oxides. The bulk of red clay consists of eolian dust. Accessory constituents found in red clay include meteorite dust, fish bones and teeth, whale ear bones, and manganese micro-nodules.[2]

These pelagic sediments are typically bright red to chocolate brown in color. The color results from coatings of iron and manganese oxide on the sediment particles. In the absence of organic carbon, iron and manganese remain in their oxidized states and these clays remain brown after burial. When more deeply buried, brown clay may change into red clay due to the conversion of iron-hydroxides to hematite.[2]

These sediments accumulate on the ocean floor within areas characterized by little planktonic production. The clays which comprise them were transported into the deep ocean in suspension, either in the air over the oceans or in surface waters. Both wind and ocean currents transported these sediments in suspension thousands of kilometers from their terrestrial source. As they were transported, the finer clays may have stayed in suspension for a hundred years or more within the water column before they settled to the ocean bottom. The settling of this clay-size sediment occurred primarily by the formation of clay aggregates by flocculation and by their incorporation into fecal pellets by pelagic organisms.[2]

Distribution and average thickness of marine sediments

Total sediment thickness of the ocean floor, with the thinnest deposits in dark blue and the thickest in red. Note the abundant deposits along the east and gulf coasts of North America, in the South China Sea, and in the Bay of Bengal, east of India
Region Percent of Ocean Area Percent of Total Volume of Marine Sediments Average Thickness
Continental shelves 9% 15% 2.5 km (1.6 mi)
Continental slopes 6% 41% 9 km (5.6 mi)
Continental rises 6% 31% 8 km (5 mi)
Deep-ocean floor 78% 13% 0.6 km (0.4 mi)

Classification of marine sediments by source of particles

Sediment Type Source Examples Distribution Percent of All Ocean Floor Area Covered
Terrigenous Erosion of land, volcanic eruptions, blown dust Quartz sand, clays, estuarine mud Dominant on continental margins, abyssal plains, polar ocean floors ~45%
Biogenous Organic; accumulation of hard parts of some marine organisms Calcareous and siliceous oozes Dominant on deep-ocean floor (siliceous ooze below about 5 km) ~55%
Hydrogenous (authigenic) Precipitation of dissolved mineral from water, often by bacteria Manganese nodules, phosphorite deposits Present with other, more dominant sediments 1%
Cosmogenous Dust from space, meteorite debris Tektite spheres, glassy nodules Mixed in very small proportion with more dominant sediments 1%

See also

Footnotes

  1. 1 2 3 4 5 Rothwell, R.G., (2005) Deep Ocean Pelagic Oozes, Vol. 5. of Selley, Richard C., L. Robin McCocks, and Ian R. Plimer, Encyclopedia of Geology, Oxford: Elsevier Limited. ISBN 0-12-636380-3
  2. 1 2 3 4 5 6 7 8 HüNeke, H., and T. Mulder (2011) Deep-Sea Sediments. Developments in Sedimentology, vol. 63. Elsiever, New York. 849 pp. ISBN 978-0-444-53000-4
  3. ↑ Neuendorf, K.K.E., J.P. Mehl, Jr., and J.A. Jackson, J.A., eds. (2005) Glossary of Geology (5th ed.). Alexandria, Virginia, American Geological Institute. 779 pp. ISBN 0-922152-76-4

External links

This article is issued from Wikipedia - version of the Saturday, January 30, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.