Units of information

In computing and telecommunications, a unit of information is the capacity of some standard data storage system or communication channel, used to measure the capacities of other systems and channels. In information theory, units of information are also used to measure the information contents or entropy of random variables.

The most common units are the bit, the capacity of a system which can exist in only two states, and the byte (or octet), which is equivalent to eight bits. Multiples of these units can be formed from these with the SI prefixes (power-of-ten prefixes) or the newer IEC binary prefixes (binary power prefixes). Information capacity is a dimensionless quantity.

Primary units

Comparison of units of information: bit, trit, nat, ban. Quantity of information is the height of bars. Dark green level is the "Nat" unit.

In 1928, Ralph Hartley observed a fundamental storage principle,^[1] which was further formalized by Claude Shannon in 1945: the information that can be stored in a system is proportional to the logarithm log_b N of the number N of possible states of that system. Changing the basis of the logarithm from b to a different number c has the effect of multiplying the value of the logarithm by a fixed constant, namely log_c N = (log_c b) log_b N. Therefore, the choice of the basis b determines the unit used to measure information. In particular, if b is a positive integer, then the unit is the amount of information that can be stored in a system with b possible states.

When b is 2, the unit is the shannon, equal to the information content of one "bit" (a contraction of binary digit). A system with 8 possible states, for example, can store up to log₂8 = 3 bits of information. Other units that have been named include:

• Base b = 3: the unit is called "trit", and is equal to log₂ 3 (≈ 1.585) bits.^[2]
• Base b = 10: the unit is called decimal digit, hartley, ban, decit, or dit, and is equal to log₂ 10 (≈ 3.322) bits.^[1][3][4][5]
• Base b = e, the base of natural logarithms: the unit is called a nat, nit, or nepit (from Neperian), and is worth log₂ e (≈ 1.443) bits.^[1]

The trit, ban, and nat are rarely used to measure storage capacity; but the nat, in particular, is often used in information theory, because natural logarithms are sometimes more convenient than logarithms in other bases.

Units derived from bit

Several conventional names are used for collections or groups of bits.

Byte

Historically, a byte was the number of bits used to encode a character of text in the computer, which depended on computer hardware architecture; but today it almost always means eight bits — that is, an octet. A byte can represent 256 (2⁸) distinct values, such as the integers 0 to 255, or -128 to 127. The IEEE 1541-2002 standard specifies "B" (upper case) as the symbol for byte. Bytes, or multiples thereof, are almost always used to specify the sizes of computer files and the capacity of storage units. Most modern computers and peripheral devices are designed to manipulate data in whole bytes or groups of bytes, rather than individual bits.

Nibble

A group of four bits, or half a byte, is sometimes called a nibble or nybble. This unit is most often used in the context of hexadecimal number representations, since a nibble has the same amount of information as one hexadecimal digit.^[6]

Word, block, and page

Computers usually manipulate bits in groups of a fixed size, conventionally called words. The number of bits in a word is usually defined by the size of the registers in the computer's CPU, or by the number of data bits that are fetched from its main memory in a single operation. In the IA-32 architecture more commonly known as x86-32, a word is 16 bits, but other past and current architectures use words with 8, 24, 32, 36, 56, 64, 80 bits or others.

Some machine instructions and computer number formats use two words (a "double word" or "dword"), or four words (a "quad word" or "quad").

Computer memory caches usually operate on blocks of memory that consist of several consecutive words. These units are customarily called cache blocks, or, in CPU caches, cache lines.

Virtual memory systems partition the computer's main storage into even larger units, traditionally called pages.

Systematic multiples

Terms for large quantities of bits can be formed using the standard range of SI prefixes for powers of 10, e.g., kilo = 10³ = 1000 (as in kilobit or kbit), mega- = 10⁶ = 1000000 (as in megabit or Mbit) and giga = 10⁹ = 1000000000 (as in gigabit or Gbit). These prefixes are more often used for multiples of bytes, as in kilobyte (1 kB = 8000 bit), megabyte (1 MB = 8000000bit), and gigabyte (1 GB = 8000000000bit).

However, for technical reasons, the capacities of computer memories and some storage units are often multiples of some large power of two, such as 2²⁸ = 268435456 bytes. To avoid such unwieldy numbers, people have often misused the SI prefixes to mean the nearest power of two, e.g., using the prefix kilo for 2¹⁰ = 1024, mega for 2²⁰ = 1048576, and giga for 2³⁰ = 1073741824, and so on. For example, a random access memory chip with a capacity of 2²⁸ bytes would be referred to as a 256-megabyte chip. The table below illustrates these differences.

In the past, uppercase K has been used instead of lowercase k to indicate 1024 instead of 1000. However, this usage was never consistently applied.

On the other hand, for external storage systems (such as optical disks), the SI prefixes were commonly used with their decimal values (powers of 10). There have been many attempts to resolve the confusion by providing alternative notations for power-of-two multiples. In 1998 the International Electrotechnical Commission (IEC) issued a standard for this purpose, namely a series of binary prefixes that use 1024 instead of 1000 as the main radix:^[7]

The JEDEC memory standards however define uppercase K, M, and G for the binary powers 2¹⁰, 2²⁰ and 2³⁰ to reflect common usage.^[8]

Size examples

• 1 bit – answer to a yes/no question
• 1 byte – a number from 0 to 255.
• 90 bytes: enough to store a typical line of text from a book.
• 512 bytes = ½ KiB: the typical sector of a hard disk.
• 1024 bytes = 1 KiB: the classical block size in UNIX filesystems.
• 2048 bytes = 2 KiB: a CD-ROM sector.
• 4096 bytes = 4 KiB: a memory page in x86 (since Intel 80386).
• 4 kB: about one page of text from a novel.
• 120 kB: the text of a typical pocket book.
• 1 MB – a 1024×1024 pixel bitmap image with 256 colors (8 bpp color depth).
• 3 MB – a three-minute song (133 kbit/s)
• 650-900 MB – a CD-ROM
• 1 GB – 114 minutes of uncompressed CD-quality audio at 1.4 Mbit/s
• 8/16 GB – size of a normal flash drive
• 4 TB – the size of a $150 hard disk (as of late 2014)
• 1.3 ZB – prediction of the volume of the whole internet in 2016.

Obsolete and unusual units

Several other units of information storage have been named.^[6]

• 1 bit: sniff.
• 2 bits: crumb,^[9] quad, quarter, tayste, tydbit, semi-nibble.
• 3 bits: triad, triade^[10][11]
• 5 bits: nickel, nyckle.
• 6 bits: byte (in early IBM machines using BCD alphamerics).
• 10 bits: declet,^{[12][13][14][15]} decle,^[16] deckle, dyme.
• 16 bits: wyde,^[17] doublet,^[18] plate, playte, chomp, chawmp (on a 32-bit machine).
• 18 bits: chomp, chawmp (on a 36-bit machine).
• 32 bits: quadlet,^[18] dinner, dynner, gawble (on a 32-bit machine).
• 48 bits: gobble, gawble (under circumstances that remain obscure).
• 64 bits: octlet.^[18]
• 128 bits: hexlet.^[18]
• 16 bytes: paragraph.
• 6 trits: tryte^[19]

Most of these names are jargon, obsolete, or used only in very restricted contexts.

References

External links

• Representation of numerical values and SI units in character strings for information interchanges
• Bit Calculator - Convert between bit, byte, kilobit, kilobyte, megabit, megabyte, gigabit, gigabyte
• Paper on standardized units for use in information technology
• Data Byte Converter