German Continental Deep Drilling Program

The drill tower of the main borehole

The German Continental Deep Drilling Program (in German Kontinentales Tiefbohrprogramm der Bundesrepublik Deutschland[1]), abbreviated as the KTB borehole, was a scientific drilling project from 1987 to 1995 near Windischeschenbach, Bavaria. The main superdeep borehole reached a depth of 9,101 meters into the Earth's continental crust.

The project was funded by the German Federal Ministry of Research with 528 million DM (270 million Euro). The project lead was taken over by the LBEG mining office (Landesamt für Bergbau, Energie und Geologie). After the drilling project had ended the borehole was reused by the GFZ German Research Centre for Geosciences for installation of a seismic observatory at depth (Tiefenobservatorium) that was active from 1996 to 2001. The derrick - one of the largest in the world - is now used as touristic attraction in the region. The two boreholes continue to be open for further scientific usage.

History

The site of the drilling project is in the ZEV, Zone von Erbendorf-Vohenstrauß, just south of the Erbendorflinie being the contact zone where Laurasia and Gondwana merged into Pangaea. Due to the geological genesis the earth crust consists of a number of layers exhibiting a number of phenomena such as strong magnetic areas and the Erbendorfkörper, a large mass drifting at about eleven kilometers below the surface with a relative high speed and seismic activity.

The project started in September 1987 with an advance borehole using state of the art technology. The borehole reached its target depth of 4000 metres in April 1989. The results of this drilling were used as parameters for the main borehole - for example the temperature gradient was higher than originally expected. The main drilling started on 8 September 1990 about 200 meters away from the advance borehole for an envisaged depth of 10000 meters. The first 7500 meters were using an automatic vertical drill head so that the lateral deviation could be limited to 12 meters. Due to the expected failure of the electronics below that depth a conventional drill head was used below that point. Due to brittleness and ductility the borehole was deforming multiple times, requiring to backfill the hole and start drilling again from a higher place. These operations continued for the last year of the project - the timing and budget constraints put an end to the efforts to go deeper. The drilling ended on 12 October 1994 after 1468 days at a depth of 9101 meters and about 300 meters lateral deviation showing a temperature of 265 °C. The planned three main experiments were performed until 31 December 1994. The facilities were being partially dismantled until 31 December 1995.

Results

The KTB project contained a lot of innovations - the Kola drilling experiment had shown problems with high friction that was increased by the vertical instability. So the German scientists designed a new drill head that would keep the direction with minimal lateral difference. The drill head was also designed to withstand temperatures between 250 and 300 °C. The original expectations had been that this temperature would be reached at a depth about 10 to 14 km. This is also the reason that the ZEV place was chosen - there was another location in the Black Forest that had been considered equal in the scientific interest level but it was expected to have a higher temperature gradient. At the ZEV location however it was hoped to possibly reach the Erbendorfkörper - a mass that reflects seismic waves while the portion that enters it will be transmitted quickly.

While the Erbendorfkörper had not been reached the KTB drilling has been considered a success regardless. For one thing the temperature rose much more quickly than expected which inflicted a reform of the theories about the temperature gradient at very deep drillholes. Other theory changes were required as well - it had been expected that the large mass and tectonic pressures would change the nature of the rock at depth (so called "metamorphite" rock). Quite unexpectedly however the rock layers were not solid at that depth and instead large amounts of fluid and gas were met pouring into the drillhole. Due to the heat and fluids the rock was of a dynamic nature which changes the way that the next superdeep drilling would be planned.

The experiments of the KTB did also show new results. The initial seismic tests showed very different recordings compared to those near the surface so that the theories on the source of seismic reflections needed to change. Using the data the reflections from the deep can be interpreted better even when being initiated from the surface.

The first experiment, the "Dipol-Dipol-Experiment" was about measuring the electric conductibility around the drill hole. This showed lines of graphite spanning through the rock that would also allow the rocks to glide when pressures moves them. The second experiment was to put a high pressure into the drillhole such that the rock would start cracking, the "Integriertes Hydrafrac/Seismik Experiment". The resulting seismic activity was measured at multiple stations in the larger area - the result had been that the overall pressure came from the south, actually the African tectonic plate at work. The third experiment, the "Fluid/Hydraulik-Test" was pumping large amounts of fluid into the rock which showed it to be generally porous.[2]

The experiences were the foundation of the follow-up project, the International Continental Scientific Drilling Program (ICDP) founded in 1996. The German scientists of the KTB were also called to help with the San Andreas Fault Observatory at Depth drillhole.

References

  1. ↑ literally "continental deep drilling program of the federal republic of germany"
  2. ↑ http://scinexx.de/dossier-detail-56-11.html

External links

Wikimedia Commons has media related to KTB.

Coordinates: 49°48′55″N 12°07′14″E / 49.81528°N 12.12056°E / 49.81528; 12.12056

This article is issued from Wikipedia - version of the Friday, June 05, 2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.