Windshield

This article is about glass used on vehicles. For the screen on windows, see window screen. For the microphone wind protecting accessory, see Microphone#Microphone windscreens.
Panoramic (wrap-around) windshield on a 1959 Edsel Corsair

The windshield (North America) or windscreen (EU & Commonwealth countries) of an aircraft, car, bus, motorbike or tram is the front window. Modern windshields are generally made of laminated safety glass, a type of treated glass, which consists of two (typically) curved sheets of glass with a plastic layer laminated between them for safety, and are bonded into the window frame. Motorbike windshields are often made of high-impact acrylic plastic.

Usage

Split and raked windshield on a 1952 DeSoto. Note the panes of glass are flat.

Windshields protect the vehicle's occupants from wind and flying debris such as dust, insects, and rocks, and provide an aerodynamically formed window towards the front. UV coating may be applied to screen out harmful ultraviolet radiation. However, this is usually unnecessary since most auto windshields are made from laminated safety glass. The majority of UV-B is absorbed by the glass itself, and any remaining UV-B together with most of the UV-A is absorbed by the PVB bonding layer.[1]

On motorbikes their main function is to shield the rider from wind, though not as completely as in a car, whereas on sports and racing motorcycles the main function is reducing drag when the rider assumes the optimal aerodynamic configuration with his or her body in unison with the machine, and does not shield the rider from wind when sitting upright.

Safety

Automobile windshield displaying "spiderweb" cracking typical of laminated safety glass.

Early windshields were made of ordinary window glass, but that could lead to serious injuries in the event of a crash. A series of lawsuits led up to the development of stronger windshields. The most notable example of this is the Pane vs. Ford case of 1917 that decided against Pane in that he was only injured through reckless driving. They were replaced with windshields made of toughened glass and were fitted in the frame using a rubber or neoprene seal. The hardened glass shattered into many mostly harmless fragments when the windshield broke. These windshields, however, could shatter from a simple stone chip. In 1919, Henry Ford solved the problem of flying debris by using the new French technology of glass laminating. Windshields made using this process were two layers of glass with a cellulose inner layer. This inner layer held the glass together when it fractured. Between 1919 and 1929, Ford ordered the use of laminated glass on all of his vehicles.[2]

Modern, glued-in windshields contribute to the vehicle's rigidity, but the main force for innovation has historically been the need to prevent injury from sharp glass fragments. Almost all nations now require windshields to stay in one piece even if broken, except if pierced by a strong force. Properly installed automobile windshields are also essential to safety; along with the roof of the car, they provide protection to the vehicle's occupants in the case of a roll-over accident .

Today’s windshields are a safety device just like seat belts and airbags. The installation of the auto glass is done with an automotive grade urethane designed specifically for automobiles. The adhesive creates a molecular bond between the glass and the vehicle. If the adhesive bond fails at any point on the glass it can reduce the effectiveness of the air bag and substantially compromise the structural integrity of the roof.

Other aspects

In many places, laws restrict the use of heavily tinted glass in vehicle windshields; generally, laws specify the maximum level of tint permitted. Some vehicles have noticeably more tint in the uppermost part of the windshield to block sunglare.

In aircraft windshields, an electric current is applied through a conducting layer of tin(IV) oxide to generate heat to prevent icing. A similar system for automobile windshields, introduced on Ford vehicles as "Quickclear" in Europe ("InstaClear" in North America) in the 1980s and through the early 1990s, used this conductive metallic coating applied to the inboard side of the outer layer of glass. Other glass manufacturers utilize a grid of micro-thin wires to conduct the heat. These systems are more typically utilized by European auto manufacturers such as Jaguar and Porsche.

The use of thermal glass prevents some navigation systems from functioning correctly, as the embedded metal blocks the satellite signal. This can be resolved by using an external antenna. Mobile telephones can also have problems; typically thermal glass will only allow 0.0001 (1‰ or one per mille) of the signal to pass, compared to a concrete wall with rebars that allows up to 0.0100 (10% or 100‰) of the signal to pass.

Terminology

Singled aero screen on Bentley Blower No.1

The term windshield is used generally throughout North America. The term windscreen is the usual term in the British Isles and Australasia for all vehicles. In the US windscreen refers to the mesh or foam placed over a microphone to minimize wind noise, while a windshield refers to the front window of a car. In the UK, the terms are reversed, although generally, the foam screen is referred to as a microphone shield, and not a windshield.

Sports or racing cars would sometimes have aero screens, which were small semi-circular or rectangular windshields. These were often mounted in pairs behind a foldable flat windshield.[3] Aero screens are usually less than 20 cm (8 in) in height. They are known as aero screens because they only deflect the wind. The twin aeroscreen setup (often called Brooklands) was popular among older sports and modern cars in vintage style.

A wiperless windshield is a windshield that uses a mechanism other than wipers to remove snow and rain from the windshield. The concept car Acura TL features a wiperless windshield using a series of jet nozzles in the cowl to blow pressurized air onto the windshield.

Repair of stone-chip and crack damage

According to the US National Windshield Repair Association many types of stone damage can be successfully repaired. Whether the windshield can be repaired always depends upon four factors: the size, type, depth, and location of the damage.[4]

Size and depth

Repair of cracks up to 61 cm (24 in) is within permissible limits, auto glass with more severe damage needs to be replaced. Dependent on State and Local laws.

Type

Circular Bullseyes, linear cracks, crack chips, dings, pits, and star-shaped breaks can be repaired without removing the glass, eliminating the risk of leaking or bonding problems sometimes associated with replacement.

Location

If the damage is in the driver’s line of sight or very near the windshield’s edge, usually it cannot be repaired.

Some damages are very difficult to repair, or cannot be repaired:

In cracked windshield repair, air is removed from the damaged area on the windshield with a specified vacuum injection pump. Then using the injection pump, clear adhesive resin is injected to replace the air in the windshield crack. The resin is then cured with an ultraviolet light. When done properly, the damaged area’s strength is restored, as is 90–95% of the clarity. Auto glass chip repair usually take about 15–20 minutes.[5]

Windshield replacement

Windshields that cannot be repaired have to be replaced. Replacement of a windshield typically takes less than 1 hour. To ensure the vehicle is safe to drive, time values called the Safe Drive Away Time have been established. Windshields which have been replaced must cure or bond sufficiently until they are able to withstand the forces of a crash. Knowing the minimum time needed to cure the glass bonding adhesives is therefore important. This safe drive away time (SDAT) or minimum drive away time (MDAT) refers to the time required until a windshield installation or glass replacement is considered safe to drive again.[6] Criteria are specified in U.S. Federal Motor Vehicle Safety Standards 212/208 (see FMVSS) to ensure the reliability of adhesive systems. Typically the SDAT is verified with crash tests as well as with high speed laboratory test methods.

Consumers may be unaware that the MDAT or SDAT time is focused on safety and not necessarily on the quality, durability, or warranty of the installation. Care must be taken not to drive the vehicle prior to the SDAT/MDAT.

Airbags deploy at speeds up to 200 mph (320 km/h; 89 m/s) and in some cases exert tremendous force on the windshield. Occupants can impact the airbag just 50 ms after initial deployment.[7] Depending on vehicle design, airbag deployment and/or occupant impact into the airbag may increase forces on the windshield, dramatically in some cases. Forces of occupants on the airbags - and hence the potential forces on the windshield - are lower for belted occupants.[8] As consequence, adhesive suppliers usually inform their customers about the level of security achieved:

1) Example: Security exceeding FMVSS 212/208 belted

2) Example: Security exceeding FMVSS 212/208 unbelted[9]

With the advent of quick cure adhesives, mobile windshield replacements have become more prevalent. Often the temperature and humidity cannot be controlled for mobile installations. For most common glass adhesives the ideal environment is 70 °F (21 °C) and 50% humidity. Variations from the ideal curing environment can increase the time needed for a sufficiently safe bond to form. A controlled environment always ensures the performance and safety of the windshield installation.

If not properly cured, the adhesive bond could fail during a crash, allowing occupants to be injured, ejected, or causing other harm. Because of the variables and difficulties involved in mobile windshield replacement, many vehicle manufacturers do not recommend this method of installation.

Disposal

Waste disposal of laminated glass is no longer permitted in landfill in most European countries as the End of Life Vehicles Directive (ELV) is implemented. A study[10] by Surrey University and Pilkington Glass proposes that waste laminated glass is placed into a separating device such as a rolling mill where the glass is fragmented and the larger cullet is mechanically detached from the inner film. The application of heat then melts the laminating plastic, usually Polyvinyl Butyral "PVB" enabling both the glass and the interior film to be recycled. The PVB recycling process is a simple procedure of melting and reshaping it. A Yorkshire consortium of CO2Sense and Ecofillers Ltd estimate that in the UK the potential market for recycled PVB in 2020 may reach a value of around £5,000.

See also

References

Wikimedia Commons has media related to Windshields.
  1. ↑ Tuchinda, Chanisada; Sabong Srivannaboon; Henry W Lim (2006). "Photoprotection by window glass, automobile glass, and sunglasses". J Am Acad Dermatol 54: 845–854. doi:10.1016/j.jaad.2006.05.014. Retrieved 23 January 2013.
  2. ↑ "Your Windshield is Not Just a "Wind-Shield" Any More". National Glass Association. Archived from the original on 2 August 2009.
  3. ↑ Beattie, Ian (1977). The Complete Book of Automobile Body Design. Yeovil, UK: The Haynes Publishing Group. p. 22. ISBN 0854292179.
  4. ↑ "Is Your Windshield Repairable?". Car Windshield Info. Retrieved 22 February 2014.
  5. ↑ "Windshield Repair FAQ's". Patsco windshield repair. Retrieved 14 December 2013.
  6. ↑ Cognard, Philippe (2006). Handbook of Adhesives and Sealants. Elsevier. ISBN 978-0080447087.
  7. ↑ Bob Stenzel: Determining SDAT, AGRR Magazine, March/April 2012, page 29-30
  8. ↑ Exposing Industry Shortcuts to SDAT Recommendations, http://www.sika.com/en/solutions_products/Sika%20Industry%20Business/01a001/noshortcutstosafety/nsts_4.html
  9. ↑ Premium Adhesive Systems, AGRR Magazine, March/April 2012, Page 15
  10. ↑ "Laminated Car Windscreen Recycling" (PDF). Archived from the original (pdf) on 2008-10-31.

Manufacturing Processes Reference Guide: Robert H. Todd, Dell K. Allen, and Leo Alting How It's Made: Windshields

External links

This article is issued from Wikipedia - version of the Sunday, January 17, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.