Mercedes D.II

D.II
Daimler D II engine
Type	Inline piston engine
Manufacturer	Mercedes

The Mercedes D.II was a six-cylinder, SOHC valvetrain liquid-cooled inline aircraft engine built by Daimler during the early stages of World War I. Producing about 110 to 120 hp, it was at the low-end of the power range of contemporary engines, and was generally outperformed by rotaries whose power-to-weight ratio tended to be much better. It also had stiff competition from the Ferdinand Porsche-designed 120 hp Austro-Daimler 6. The D.II was produced only briefly as a result, but its design formed the basis for the later Mercedes D.III which saw widespread use throughout the war.

Design and development

The D.II was based on the Austro-Daimler to a large degree. Like the Austro-Daimler, it was built up from the crankcase, which was milled from two pieces of cast aluminum bolted together at their midline. The cylinders were separately milled from steel and bolted to the top of the crankcase. Steel sleeves were fitted over the cylinders and welded on to form a cooling jacket. Much of this complexity is due to the differential rates of expansion of steel and aluminum, which precluded screwing the cylinders into the crankcase, and the alloys of the era meant that an aluminum cylinder was not possible. Both engines also used a scavenger pump to pump oil out of the crankcase to a separate cylinder, where a second high-pressure pump supplied oil to the engine. This arrangement allowed for a much smaller "sump" on the bottom of the crankcase, reducing the overall size of the engine, although in the case of the D.II it was not nearly as much as the Austro-Daimler.

Where the D.II differed from the Austro-Daimler was largely in mechanical arrangement. For instance, the D.II featured a single overhead cam, powered by a shaft leading up from the crankshaft at the rear of the engine, whereas the Austro-Daimler had a more conventional valvetrain using pushrods driven from the crankcase. Another unique feature was the ability to shift the camshaft to a half-compression position for starting. The D.II used two carburetors located together on one side of the engine, feeding the cylinders through two manifolds; the Austro-Daimler separated its carburetors to locate them closer to the cylinders they fed. The D.II also used a unique cooling jacket design, with every two cylinders being covered by a single jacket.

The D.II was fairly quickly replaced by the D.III, and ended production around 1916. The D.III was essentially a scaled-up D.II, although it abandoned the paired cooling jackets.

Applications

• Aviatik B.II
• Aviatik C.I
• Albatros B.I
• Albatros B.II
• DFW B.II
• Fokker D.I
• Friedrichshafen FF.29
• Halberstadt D.II
• Junkers J 1 Blechesel
• Zmaj Fizir FN

Engines on display

One surviving example of this engine had been on display at Old Rhinebeck Aerodrome-its crankshaft had sheared, and the engine is rumored to possibly have been brought to New Zealand.

Deutsche Museum in Munich has one example on display, this is a cutaway model that was created by Daimler ^[1]

Specifications (D.II)

General characteristics

• Type: 6-cylinder, inline piston engine
• Displacement: 579 cu in
• Dry weight: 449 lb

Components

• Valvetrain: SOHC
• Reduction gear: Direct drive, left-hand tractor

Performance

• Power output: 120 hp at 1,400 rpm

See also

Comparable engines

• Rolls-Royce Hawk

Related lists

• List of aircraft engines

References

Wikimedia Commons has media related to Mercedes D.II.

Notes

Bibliography