Real gas

Real gases are non-hypothetical gases whose molecules occupy space and have interactions; consequently, they adhere to gas laws. To understand the behaviour of real gases, the following must be taken into account:

compressibility effects;
variable specific heat capacity;
van der Waals forces;
non-equilibrium thermodynamic effects;
issues with molecular dissociation and elementary reactions with variable composition.

For most applications, such a detailed analysis is unnecessary, and the ideal gas approximation can be used with reasonable accuracy. On the other hand, real-gas models have to be used near the condensation point of gases, near critical points, at very high pressures, to explain the Joule–Thomson effect and in other less usual cases. The deviation from ideality can be described by the compressibility factor Z.

Models

Isotherms of real gas

Dark blue curves – isotherms below the critical temperature. Green sections – metastable states.

The section to the left of point F – normal liquid.
Point F – boiling point.
Line FG – equilibrium of liquid and gaseous phases.
Section FA – superheated liquid.
Section F′A – stretched liquid (p<0).
Section AC – analytic continuation of isotherm, physically impossible.
Section CG – supercooled vapor.
Point G – dew point.
The plot to the right of point G – normal gas.
Areas FAB and GCB are equal.

Red curve – Critical isotherm.
Point K – critical point.

Light blue curves – supercritical isotherms

Main article: Equation of state

van der Waals model

Main article: van der Waals equation

Real gases are often modeled by taking into account their molar weight and molar volume

RT=\left(P+\frac{a}{V_\text{m}^2}\right)(V_\text{m}-b)

Where P is the pressure, T is the temperature, R the ideal gas constant, and V_m the molar volume. a and b are parameters that are determined empirically for each gas, but are sometimes estimated from their critical temperature (T_c) and critical pressure (P_c) using these relations:

a=\frac{27R^2T_\text{c}^2}{64P_\text{c}}

b=\frac{RT_\text{c}}{8P_\text{c}}

Redlich–Kwong model

The Redlich–Kwong equation is another two-parameter equation that is used to model real gases. It is almost always more accurate than the van der Waals equation, and often more accurate than some equations with more than two parameters. The equation is

RT=\left(P+\frac{a}{\sqrt{T}V_\text{m}(V_\text{m}+b)}\right)(V_\text{m}-b)

where a and b two empirical parameters that are not the same parameters as in the van der Waals equation. These parameters can be determined:

a=0.42748\, \frac{R^2{T_\text{c}}^{5/2}}{P_\text{c}}

b=0.08664\, \frac{RT_\text{c}}{P_\text{c}}

Berthelot and modified Berthelot model

The Berthelot equation (named after D. Berthelot^[1] is very rarely used,

$P=\frac{RT}{V_\text{m}-b}-\frac{a}{TV_\text{m}^2}$

but the modified version is somewhat more accurate

$P=\frac{RT}{V_\text{m}}\left[1+\frac{9P/P_\text{c}}{128T/T_\text{c}}\left(1-\frac{6}{(T/T_\text{c})^2}\right)\right]$

Dieterici model

This model (named after C. Dieterici^[2]) fell out of usage in recent years

$P=RT\frac{\exp{(\frac{-a}{V_\text{m}RT})}}{V_\text{m}-b}$ .

Clausius model

The Clausius equation (named after Rudolf Clausius) is a very simple three-parameter equation used to model gases.

$RT=\left(P+\frac{a}{T(V_\text{m}+c)^2}\right)(V_\text{m}-b)$

where

$a=\frac{27R^2T_\text{c}^3}{64P_\text{c}}$

$b=V_\text{c}-\frac{RT_\text{c}}{4P_\text{c}}$

$c=\frac{3RT_\text{c}}{8P_\text{c}}-V_\text{c}$

where V_c is critical volume.

Virial model

The Virial equation derives from a perturbative treatment of statistical mechanics.

$PV_\text{m}=RT\left(1+\frac{B(T)}{V_\text{m}}+\frac{C(T)}{V_\text{m}^2}+\frac{D(T)}{V_\text{m}^3}+...\right)$

or alternatively

$PV_\text{m}=RT\left(1+\frac{B^\prime(T)}{P}+\frac{C^\prime(T)}{P^2}+\frac{D^\prime(T)}{P^3}+...\right)$

where A, B, C, A′, B′, and C′ are temperature dependent constants.

Peng–Robinson model

Peng–Robinson equation of state (named after D.-Y. Peng and D. B. Robinson^[3]) has the interesting property being useful in modeling some liquids as well as real gases.

$P=\frac{RT}{V_\text{m}-b}-\frac{a(T)}{V_\text{m}(V_\text{m}+b)+b(V_\text{m}-b)}$

Wohl model

The Wohl equation (named after A. Wohl^[4]) is formulated in terms of critical values, making it useful when real gas constants are not available.

$RT=\left(P+\frac{a}{TV_\text{m}(V_\text{m}-b)}-\frac{c}{T^2V_\text{m}^3}\right)(V_\text{m}-b)$

where

$a=6P_\text{c}T_\text{c}V_\text{c}^2$

$b=\frac{V_\text{c}}{4}$

$c=4P_\text{c}T_\text{c}^2V_\text{c}^3$ .

Beattie–Bridgeman model

^[5]

This equation is based on five experimentally determined constants. It is expressed as

$P=\frac{RT}{v^2}\left(1-\frac{c}{vT^3}\right)(v+B)-\frac{A}{v^2}$

where

A = A_0 \left(1 - \frac{a}{v} \right)

B = B_0 \left(1 - \frac{b}{v} \right)

This equation is known to be reasonably accurate for densities up to about 0.8 ρ_cr, where ρ_cr is the density of the substance at its critical point. The constants appearing in the above equation are available in following table when P is in KPa, v is in $\frac{\text{m}^3}{\text{K}\,\text{mol}}$ , T is in K and R=8.314 $\frac{\text{kPa}\cdot\text{m}^3}{\text{K}\,\text{mol}\cdot\text{K}}$ ^[6]

Gas	A₀	a	B₀	b	c
Air	131.8441	0.01931	0.04611	-0.001101	4.34×10^4
Argon, Ar	130.7802	0.02328	0.03931	0.0	5.99×10^4
Carbon Dioxide, CO₂	507.2836	0.07132	0.10476	0.07235	6.60×10^5
Helium, He	2.1886	0.05984	0.01400	0.0	40
Hydrogen, H₂	20.0117	-0.00506	0.02096	-0.04359	504
Nitrogen, N₂	136.2315	0.02617	0.05046	-0.00691	4.20×10^4
Oxygen, O₂	151.0857	0.02562	0.04624	0.004208	4.80×10^4

Benedict–Webb–Rubin model

Main article: Benedict–Webb–Rubin equation

The BWR equation, sometimes referred to as the BWRS equation,

$P=RTd+d^2\left(RT(B+bd)-(A+ad-a{\alpha}d^4)-\frac{1}{T^2}[C-cd(1+{\gamma}d^2)\exp(-{\gamma}d^2)]\right)$

where d is the molar density and where a, b, c, A, B, C, α, and γ are empirical constants. Note that the γ constant is a derivative of constant α and therefore almost identical to 1.

References

↑ D. Berthelot in Travaux et Mémoires du Bureau international des Poids et Mesures – Tome XIII (Paris: Gauthier-Villars, 1907)
↑ C. Dieterici, Ann. Phys. Chem. Wiedemanns Ann. 69, 685 (1899)
↑ Peng, D. Y., and Robinson, D. B. (1976). "A New Two-Constant Equation of State". Industrial and Engineering Chemistry: Fundamentals 15: 59–64. doi:10.1021/i160057a011.
↑ A. Wohl "Investigation of the condition equation", Zeitschrift für Physikalische Chemie (Leipzig) 87 pp. 1–39 (1914)
↑ Yunus A. Cengel and Michael A. Boles, Thermodynamics: An Engineering Approach 7th Edition, McGraw-Hill, 2010, ISBN 007-352932-X
↑ Gordan J. Van Wylen and Richard E. Sonntage, Fundamental of Classical Thermodynamics, 3rd ed, New York, John Wiley & Sons, 1986 P46 table 3.3

Dilip Kondepudi, Ilya Prigogine, Modern Thermodynamics, John Wiley & Sons, 1998, ISBN 0-471-97393-9
Hsieh, Jui Sheng, Engineering Thermodynamics, Prentice-Hall Inc., Englewood Cliffs, New Jersey 07632, 1993. ISBN 0-13-275702-8
Stanley M. Walas, Phase Equilibria in Chemical Engineering, Butterworth Publishers, 1985. ISBN 0-409-95162-5
M. Aznar, and A. Silva Telles, A Data Bank of Parameters for the Attractive Coefficient of the Peng–Robinson Equation of State, Braz. J. Chem. Eng. vol. 14 no. 1 São Paulo Mar. 1997, ISSN 0104-6632
An introduction to thermodynamics by Y. V. C. Rao
The corresponding-states principle and its practice: thermodynamic, transport and surface properties of fluids by Hong Wei Xiang

External links

http://www.ccl.net/cca/documents/dyoung/topics-orig/eq_state.html

This article is issued from Wikipedia - version of the Wednesday, November 25, 2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.

Real gas

Models

van der Waals model

Redlich–Kwong model

Berthelot and modified Berthelot model

Dieterici model

Clausius model

Virial model

Peng–Robinson model

Wohl model

Beattie–Bridgeman model

Benedict–Webb–Rubin model

See also

References

External links