Tunnel broker
| IPv6 transition mechanisms |
|---|
| Standards Track |
| Experimental |
| Informational |
|
| Drafts |
| Deprecated |
|
In the context of computer networking, a tunnel broker is a service which provides a network tunnel. These tunnels can provide encapsulated connectivity over existing infrastructure to another infrastructure.
There are a variety of tunnel brokers, including IPv4 tunnel brokers, though most commonly the term is used to refer to an IPv6 tunnel broker as defined in RFC:3053.
IPv6 tunnel brokers typically provide IPv6 tunnels to sites or end users over IPv4. In general, IPv6 tunnel brokers offer so called 'protocol 41' or proto-41 tunnels. These are tunnels where IPv6 is tunneled directly inside IPv4 packets by having the protocol field set to '41' (IPv6) in the IPv4 packet. In the case of IPv4 tunnel brokers IPv4 tunnels are provided to users by encapsulating IPv4 inside IPv6 as defined in RFC:2473.
Automated configuration
Configuration of IPv6 tunnels is usually done using the Tunnel Setup Protocol (TSP), or using Tunnel Information Control protocol (TIC). A client capable of this is AICCU (Automatic IPv6 Connectivity Client Utility). In addition to IPv6 tunnels TSP can also be used to set up IPv4 tunnels.
NAT Issues
Proto-41 tunnels (direct IPv6 in IPv4) may not operate well situated behind NATs. One way around this is to configure the actual endpoint of the tunnel to be the DMZ on the NAT-utilizing equipment. Another method is to either use AYIYA or TSP, both of which send IPv6 inside UDP packets, which is able to cross most NAT setups and even firewalls.
A problem that still might occur is that of the timing-out of the state in the NAT machine. As a NAT remembers that a packet went outside to the Internet it allows another packet to come back in from the Internet that is related to the initial proto-41 packet. When this state expires, no other packets from the Internet will be accepted. This therefore breaks the connectivity of the tunnel until the user's host again sends out a packet to the tunnel broker.
Dynamic Endpoints
When the endpoint isn't a static IP address, the user, or a program, has to instruct the tunnel broker to update the endpoint address. This can be done using the tunnel broker's web site or using an automated protocol like TSP or Heartbeat, as used by AICCU. In the case of a tunnel broker using TSP, the client automatically restarting the tunnel will cause the endpoint address and port to be updated.