South African Class MG 2-6-6-2
South African Class MG 2-6-6-2 ex CSAR Mallet 2-6-6-2 | |
---|---|
SAR Class MG no. 1628, ex CSAR no. 1024, circa 1912 | |
Type and origin | |
Power type | Steam |
Designer | Central South African Railways |
Builder | American Locomotive Company |
Serial number | 49124 [1] |
Model | CSAR Mallet |
Build date | 1911 |
Total produced | 1 |
Specifications | |
Configuration | 2-6-6-2 Mallet |
Gauge | 3 ft 6 in (1,067 mm) Cape gauge |
Leading wheel diameter | 28.5 in (724 mm) |
Driver diameter |
51 in (1,300 mm) front driver set 46 in (1,170 mm) rear driver set |
Trailing wheel diameter | 28.5 in (724 mm) |
Wheelbase |
Total: 66 ft 9 in (20.345 m) Engine: 9 ft 2 in (2.794 m) front driver set 8 ft 4 in (2.540 m) rear driver set 41 ft 6 in (12.649 m) total Tender: 4 ft 7 in (1.397 m) bogie 17 ft 11 in (5.461 m) total |
Length | 74 ft 10.25 in (22.816 m) |
Height | 12 ft 10.875 in (3.934 m) |
Frame | Bar frame |
Axle load | 15.175 long tons (15.4 t) on 6th driver |
Weight on drivers | 88.375 long tons (89.8 t) |
Locomotive weight | 103.1 long tons (104.8 t) |
Tender weight | 50.35 long tons (51.2 t) |
Locomotive and tender combined weight | 153.95 long tons (156.4 t) |
Tender type |
2 axle bogie 34 in (864 mm) wheels |
Fuel type | Coal |
Fuel capacity | 10 long tons (10.2 t) |
Water capacity | 4,000 imp gal (18,000 l) |
Boiler |
6 ft 0.125 in (1.832 m) inside diameter 20 ft 4.125 in (6.201 m) inside length 7 ft 11.5 in (2.426 m) pitch |
Boiler pressure | 200 psi (1,380 kPa) |
Firegrate area | 49.5 sq ft (4.599 m2) |
Heating surface: – Tubes |
269 tubes 2.25 in (57.1 mm) diameter 3,223 sq ft (299.426 m2) |
– Firebox | 160.5 sq ft (14.911 m2) |
– Total | 3,383.5 sq ft (314.337 m2) |
Cylinders | Four |
High-pressure cylinder size |
18 in (457 mm) bore 26 in (660 mm) stroke |
Low-pressure cylinder size |
28.5 in (724 mm) bore 28 in (711 mm) stroke |
Valve gear | Walschaerts [2] |
Performance figures | |
Tractive effort | 45,200 lbf (201 kN) at 50% pressure |
Career | |
Operator(s) |
Central South African Railways South African Railways [1] |
Class | Class MG |
Number in class | 1 |
Number(s) | CSAR 1024, SAR 1628 [1][3] |
Delivered | 1911 |
First run | 1911 |
Withdrawn | 1927 |
The South African Class MG 2-6-6-2 of 1911 is a South African steam locomotive from the pre-Union era in the Transvaal.
In 1911 the Central South African Railways placed an experimental Mallet articulated compound steam locomotive with a 2-6-6-2 wheel arrangement in service. In 1912, when it was assimilated into the South African Railways, it was renumbered and classified as the sole Class MG.[1][2][3]
Manufacturer
A single experimental locomotive was included with the order for nine Mallet articulated compound steam locomotives that were delivered to the Central South African Railways (CSAR) by the American Locomotive Company (ALCO) in 1911. It was similar to the other nine locomotives, but used saturated steam, had a mechanical stoker and the coupled wheels on the leading engine unit were of a 5 inches (127 millimetres) larger diameter than those of the trailing engine unit. It had Walschaerts valve gear and was numbered 1024.[1][2][3]
Compound expansion
In a compound locomotive steam is expanded in phases. After being expanded in a high pressure cylinder and having then lost pressure and given up part of its heat, it is exhausted into a larger volume low pressure cylinder for secondary expansion, after which it is exhausted through the smokebox. By comparison, in the more usual arrangement of simple expansion, steam is expanded just once in any one cylinder before being exhausted through the smokebox.[1][4]
In the compound Mallet locomotive, the rear set of coupled wheels are driven by the smaller high pressure cylinders which are fed steam from the steam dome. Their spent steam is then fed to the larger low pressure cylinders that drive the front set of coupled wheels.[1][2]
Characteristics
Apart from having a different boiler, there were three major differences between this locomotive and the other nine that were built and delivered at the same time.[2]
Saturated steam
Firstly, it was not equipped with a superheater although superheated locomotives had already been proven to be more economic and superior in performance.[1][2]
Coupled wheels
The second difference was that the front set of coupled wheels was of a larger diameter than the rear set. In theory this configuration was to result in improved acceleration, with the rear engine unit providing the traction. It was also believed that the difference in frequency between the front and rear cylinder exhaust beats would result in a more even pressure in the receiver pipe and therefore improved steam flow, although exactly how this was to come about was not clear. It was the only South African articulated locomotive to have coupled wheels of different diameters.[1][2]
The unorthodox driving wheel configuration did not have the expected results and, in comparison with the other nine engines, the locomotive proved to be inferior in performance.[1]
Mechanical stoker
Thirdly, this was the first South African locomotive to be equipped with a mechanical stoker. This device, of the "Street" type, consisted of a coal crusher, hand-fed by the fireman, that was fitted to the front left hand side of the tender footplate and driven by a small steam engine mounted behind the hand brake column.[1][2]
The crushed coal then fell by gravity into a chute which led to a receiving bin that was fitted below the back buffer beam of the locomotive, from where it was picked up by a bucket elevator travelling in large tubes. The full buckets were carried up in the left-hand-side tube mounted on the back of the firebox, were discharged into a central receiver and then travelled down the right hand side tube.[1]
The bucket belt was driven by another small steam engine, mounted on the left side of the firebox near the top, and the main shaft of this engine had adjustable cams which operated three steam cocks that supplied steam jets to the coal delivery orifices. From the central receiver, a cone-shaped tray directed the coal to the right, centre or left sides as required, while the cam-operated steam jets blew the coal into the firebox.[1]
It was a very complicated, cumbersome and extremely noisy arrangement that required the fireman to attend to two auxiliary engines and feed the crusher, in addition to his normal duties. The mechanical stoker was removed and the locomotive was converted to hand firing soon after being placed in service.[1][2]
Service
The Union of South Africa was established on 31 May 1910, in terms of the South Africa Act, enacted by the Parliament of the United Kingdom. One of the clauses in the Act required that the three Colonial Government railways, the Cape Government Railways, the Natal Government Railways and the CSAR, also be united under one single administration to control and administer the railways, ports and harbours of the Union. While the South African Railways (SAR) came into existence in 1910, the actual classification and renumbering of all the rolling stock of the three constituent railways required careful planning and was only implemented with effect from 1 January 1912.[3][5]
In 1912 this locomotive was renumbered 1628 and classified as Class MG on the SAR. It joined the experimental Class MD and the Class MF on the coal traffic line between Witbank and Germiston and remained there until it was withdrawn from service in 1927.[1][2][3]
Liveries illustrated
The main picture shows Class MG number 1628 in its original lined SAR livery. It was later repainted in the more well known plain black SAR livery.
-
No. 1628 in plain black SAR livery, circa 1920
See also
- Articulated locomotive numbering and classification
- List of South African locomotive classes
- Mallet locomotive
- South African Class MD 2-6-6-2
- South African Class ME 2-6-6-2
- South African Class MF 2-6-6-2
- South African Class MH 2-6-6-2
- South African locomotive history
- The 2-6-6-2 Mallet
References
|
- ↑ 1.0 1.1 1.2 1.3 1.4 1.5 1.6 1.7 1.8 1.9 1.10 1.11 1.12 1.13 1.14 Holland, D.F. (1972). Steam Locomotives of the South African Railways, Volume 2: 1910-1955 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 16–18, 140. ISBN 978-0-7153-5427-8.
- ↑ 2.0 2.1 2.2 2.3 2.4 2.5 2.6 2.7 2.8 2.9 Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. p. 87. ISBN 0869772112.
- ↑ 3.0 3.1 3.2 3.3 3.4 Classification of S.A.R. Engines with Renumbering Lists, issued by the Chief Mechanical Engineer’s Office, Pretoria, January 1912, pp. 9, 12, 16, 47 (Reprinted in April 1987 by SATS Museum, R.3125-6/9/11-1000)
- ↑ Compounding Steam Engines
- ↑ The South African Railways - Historical Survey. Editor George Hart, Publisher Bill Hart, Sponsored by Dorbyl Ltd., Published c. 1978, p. 25.