Rover P3

Rover 60
Rover 75
P3 series

Rover 75 6-light saloon
registered November 1948
Overview
Manufacturer The Rover Company Limited
Production

1948–1949 9,111 produced

  • 60 1,274
  • 75 7,837
Designer Gordon Bashford
Body and chassis
Body style
  • 4-door 6-light saloon
  • 4-door 4-light sports saloon
Layout FR layout
Powertrain
Engine
  • 1.6 L Straight-4
  • 2.1 L Straight-6
Transmission 4-speed manual
Dimensions
Wheelbase 110 in (2,794 mm)
Length 172 in (4,400 mm)[1]
Width 65 in (1,700 mm)[1]
Height 63 in (1,600 mm)[1]
Curb weight 3,000 lb (1,400 kg) approx
Chronology
Predecessor Rover 16
Successor Rover 75 (P4)

The Rover P3 series were 1.6 and 2.0-litre cars produced by the The Rover Company Limited in 1948 and 1949 known as the Rover 60 and Rover 75.

For the post-war market Rover had a new engine that had been in preparation since the late 1930s with overhead inlet and side exhaust valves. It was made in two versions for the car, the Rover 60 had a four-cylinder unit of 1595 cc and the Rover 75 had a six-cylinder version of 2103 cc. The gearbox and traditional Rover freewheel were kept unchanged from the previous model.

To go with the engine a new car was prepared. Although the body was similar in styling to the Rover 12 and 16, many of the body panels were in fact new but the wings and bonnet from the 12 were carried over. The car was 0.5 inch (12 mm) wider outside than the 16 but by making better use of space this translated to 2.5 inches (60 mm) inside. It was 4.5 inches (115 mm) shorter in the wheelbase. Also new, and a first for a Rover, was independent front suspension but the brakes remained a hydraulic/mechanical hybrid system. Rather than having a complete chassis, the new frame, which was a box section, was stopped short of the rear axle and the rear semi-elliptic springs were attached to the body. This allowed the rear axle travel to be increased and an improved ride resulted.

Two body styles were available, a six light saloon and four light sports saloon.

The cars were expensive at £1080 for the Rover 60 and £1106 for the Rover 75, and with early post-war production problems and material shortages it was never intended that the cars would be produced in large numbers. Eventually, 1274 of 60 and 7837 75 models were made before the car was replaced by the all-new Rover 75 (P4) at the end of September 1949.

The engine and gearbox from the car were also used as the basis for those in the original Land Rover Series. About six "75" models were produced with triple SU carburettors – a throw back to Rover's pre-war 'Speed' performance models; one survivor has an over-bored 2,400 cc engine; the basis of the Marauder 100 engine.


References

  1. ↑ 1.0 1.1 1.2 "Second Hand car guide supplement", Practical Motorist 6 (68), April 1960: 768–769
Wikimedia Commons has media related to Rover P3.

Further reading