Pattern 1908 and 1912 cavalry swords
The 1908 Pattern Cavalry Trooper's Sword (and the 1912 Pattern, the equivalent for officers) was the last service sword issued to the cavalry of the British Army. It has been called [1][2] the most effective cavalry sword ever designed, although ironically its introduction occurred as swords finally became obsolete as military weapons. In use, it, like other thrust-centric cavalry swords, is best described as a one-handed lance, due to its relative lack of utility for anything but the charge. In fact, the closely related US Model 1913 Cavalry Saber was issued with only a saddle scabbard, as it was not considered to be of much use to a dismounted cavalryman.
In military circles there had long been the debate over whether the use of the point or the edge was the better method of attack for a cavalryman. In the Napoleonic period, British cavalry doctrine as shaped by John Gaspard Le Marchant favoured the cut, resulting in the dramatically curved Pattern 1796 light cavalry sabre. With the introduction of the 1822 patterns, the British Army adopted a series of “cut and thrust” swords with slightly curved blades which were theoretically stiff enough for a thrust. The 1822 swords and their descendants were inevitably compromises and not ideal for either cutting or thrusting, but the Army considered the adaptability to be of more importance. By contrast the 1908 pattern was designed from the outset purely to give point (thrust) from horseback.
The sword has lived on as the ceremonial sword for the British, Canadian and Australian cavalry units.
Design of the 1908 Pattern
With the introduction of the 1908 sword, however, the era of the compromise design was over. The 1908 sword was purely optimized for thrusting. The skewer-like blade had a thick "T" cross-section, much narrower but thicker than a traditional blade design making it far stiffer in the “weak” axis for a given weight so as to resist buckling in the thrust. The blade ended in a sharp "spear" point. The large, sheet steel bowl guard gave considerable protection to the hand. The rounded rectangular section chequered grip was of a semi-pistol configuration. Although not as extreme as modern fencing pistol or orthopedic grips, this design caused the blade to naturally align with the arm when the arm was extended, in position for a charge using the point. A thumb stop was indented on top of the grip, just behind the guard. The large pommel helped to keep the point of balance of the sword close to the guard, balancing the sword for its length.
The original official specification called, once again, for a “cut and thrust” blade and the final 18 inches (460 mm) of the blade was theoretically supposed to be sharpened, but little more than lip-service was paid to cutting ability. The straight blade prevented the slicing action of a curved sabre and the concussive force would be compromised by the hilt-biased balance. Furthermore the narrow blade was weak in the cutting axis, and the pistol grip with specialised thumb placement, ideal for thrusting, was awkward for the cut.
The length of the blade at just over 35 inches (890 mm) was said to be able to match the reach of the lance (still in use with some armies at the turn of the 20th Century) or the bayonet with the sword arm fully extended.
King Edward VII described the sword as "hideous" when the pattern was submitted to him for formal approval, and had to be persuaded of its utility before eventually conceding the point.
1912 Pattern Cavalry Officer's Sword
Whereas swords for troopers and NCOs were issued by the Army, officer's swords were privately purchased by the officers themselves. Until 1912, officers continued to carry their pierced "honeysuckle" hilted or three-bar hilted cut-and-thrust swords. The three-bar hilt was officially discontinued for light cavalry officers in 1896, in which year it was required that they adopt the heavy cavalry form. However army regulations also stated that on the introduction of a new pattern an officer's sword need not be replaced until his existing one was no longer serviceable; use of the three-bar hilt thus continued well into the 20th century.
In 1912 however, an officer's pattern was introduced which mirrored that carried by the men. The 1912 Pattern cavalry officer's sword is of the same basic form as the 1908 trooper's version, but in a more decorative form. The blade, plain for troopers, was usually engraved or etched (although during World War I expediency sometimes led to plain blades being fitted to officer's swords). The grip is of the same form, but the chequered rubber or bakelite grip was replaced by grey ribbed shark skin, bound with German-silver wire. The pommel, plain on the trooper's version, was chequered and decorated.
On the front of the bowl guard, the 1912 sword had an engraved floral pattern, mimicking the honeysuckle pattern which had been common on officer's swords throughout the 19th Century.
Variants
The Army of India variant of the 1908 sword featured a smaller grip to match the generally smaller hands of cavalry troopers recruited in the sub-continent.
As private purchases, officer's swords sometimes showed some variation from the standard pattern. Occasionally whole regiments would have their own variation on the theme. In particular, the fashion-conscious officers of the 10th Royal Hussars carried a bizarre version combining the pistol grip and blade of the 1912 pattern with a three-bar hilt from their earlier 1821 Pattern Light Cavalry sword, giving a unique but decidedly odd effect.
Criticism
Although the 1908 and 1912 patterns can be seen as the penultimate expressions of the thrusting cavalry sword (the U.S. Army adopted its similar Patton saber in 1913), a century after the sword's effective obsolescence for military purposes, the debate over the relative virtues of the edge and the point remained. John Gaspard le Marchant, the great trainer and leader of British cavalry at the turn of the 19th Century, felt that the weapon employed in the charge was almost irrelevant, as the shock value stemmed from the momentum of the combined horse and rider. The sword came into its own during the “desultory” encounters after the charge, for which a slashing sword was best suited. The British cavalry’s last pure cutting sword, the spectacularly curved Pattern 1796 light cavalry sabre, was a design resulting from a collaboration between Le Marchant and Henry Osborn (a noted Birmingham-based sword manufacturer of the time).
The most compelling criticism of use of the point in cavalry combat, however, lies in the possibility of it becoming the victim of its own success. With the force of a fast-moving horse and rider behind it, a well-aimed sword thrust would certainly achieve considerable penetration, even up to the hilt. As the horse and rider passed the unfortunate recipient of the thrust, the sword would be very difficult to drag clear of the body, leaving the rider at best disarmed or at worst unhorsed or with a broken wrist.
The Patton Saber
The U.S. Army's Model 1913 cavalry saber had a large, basket-shaped hilt mounting a straight, double-edged, thrusting blade designed for use by heavy cavalry. Generally known as the “Patton” saber, after its designer Lieutenant (later General) George S. Patton, it may have been influenced by the British 1908 and 1912 Patterns. But Patton himself was predominantly influenced by French swordsmanship and French sword theory and design. Following the 1912 Olympics Patton went to France twice to study under French Master Swordsmen. His manual and cavalry sword use theories grew out of his training and experience in France.
See also
- 1796 Heavy Cavalry Sword
- 1897 Pattern British Infantry Officer's Sword
- Gothic Hilted British Infantry Swords (1822, 1827, 1845, 1854 and 1892 Patterns)
- Pattern 1796 light cavalry sabre
- John Le Marchant (British Army cavalry officer)
References
External links
- British Military Swords
- Anne S. K. Brown Military Collection, Brown University Library 105 British military swords, dating from the 17th century to the early 20th century, from the Cyril Mazansky Collection, on permanent display at the Annmary Brown Memorial.
- Gieves & Hawkes Swords