PDMS stamp

Sarfus image of streptavidin deposited by soft lithography with PDMS stamp.

PDMS stamps are pieces of polydimethylsiloxane (PDMS), a silicone, that have been patterned usually against a master to form a relief pattern used in soft lithography. This PDMS stamp can be used in either its current form as a relief surface for techniques such as microcontact printing or can also be attached to an external source by tubing so that liquid may be passed through channels on its surface. In this second case it will often be laminated to a surface so that chemistry can be performed on that surface producing a pattern of the PDMS stamp on to the surface. Alternatively a PDMS stamp can be laminated to a second piece of PDMS to form a contained device. It is possible to pattern PDMS with nanometre resolution. Many techniques have been developed to modify the basic setups to perform a range of tasks such as assays on small volumes. These kinds of devices are often referred to as microfluidic devices. Because of the small dimensions of these devices flow is laminar not turbulent which can lead to many useful properties; however, this reduces the ability of fluid streams to mix.

A new concept of PDMS stamp for multiplexing: the macrostamp

The main drawback of microcontact printing for biomedical application is that it is not possible to print different molecules with one stamp. To print different (bio)molecules in one step, a new concept is proposed : the macrostamp.[1] It is a stamp composed of dots. The space between the dots corresponds to the space between the wells of a microplate. Then, it is possible to ink, dry and print in one step different molecules.

A new PDMS stamp : the Magnetic Stamp

To apply a homogeneous pressure during the printing step, a magnetic force is used. For that, the stamp is sensitive to a magnetic field by injecting iron powder into a second layer of PDMS. This force can be adjusted for nano and micro-patterns.[2] Fully automated micro contact printing equipment was developed. It consists of the steps of the micro contact printing process : loading, inking, drying, printing, alignment, cleaning, unloading. A pipeting module is used to deposit some drop of liquids like ethanol.[3] This equipment is named InnoSTAMP40.[4]

References

  1. ↑ Helene LALO, Jean-Christophe Cau, Christophe Thibault, Nathalie Marsaud, Childerick Severac, Christophe Vieu, "Microscale multiple biomolecules printing in one step using a PDMS macrostamp", Microelectronic Engineering, Volume 86, Issues 4–6, April–June 2009, Pages 1428–1430
  2. ↑ Jean-Christophe Cau, Lafforgue Ludovic, Nogues Marie, Lagraulet Adriana, Paveau Vincent, "Magnetic field assisted microcontact printing: A new concept of fully automated and calibrated process", Microelectronic Engineering,Volume 110, October 2013, Pages 207–214|DOI: 10.1016/j.mee.2013.03.164
  3. ↑ "Transfer printing of sub-100 nm nanoparticles by soft lithography with solvent mediation", Aline Cerf, Christophe Vieu, Colloids and Surfaces A: Physicochemical and Engineering Aspects, Volume 342, Issues 1–3, 15 June 2009, Pages 136–140
  4. ↑ InnoSTAMP40, Innopsys