NASA Paresev

Paresev
Paresev 1 in landing, 1962
Role Flexible-wing research glider
Manufacturer NASA
First flight 1962




The Paresev (Paraglider Research Vehicle) was an experimental NASA glider aircraft based upon the kite-parachute studies by NASA engineer Francis Rogallo.

Between 1961 and 1965 the ability of the Rogallo wing (also called "Parawing") to descend a payload such as the Gemini space capsule safely from high altitude to ground was studied.[1][2] The Paresev was a test vehicle used to learn how to control this parachute-wing for a safe landing at a normal airfield.

Publicity on the Paresev and the Ryan XV-8 "Flying Jeep" aircraft inspired hobbyists to adapt Rogallo's flexible wing airfoil onto elementary hang gliders leading to the most successful hang glider configuration in history.

Development

Paresev 1-A with tow plane
Paresev 1-B under aerotow.
United States Gemini's Paresev glider in flight with tow cable.

NASA experimented with the flexible Rogallo wing, which they renamed the Parawing, in order to evaluate it as a recovery system for the Gemini space capsules and recovery of used Saturn rocket stages.[3][4] Under a directive by Paul Bikle, NASA engineer Charles Richards in 1961–1962 designed the collapsible four-tube Rogallo wing used in the Paresev. The Paresev series included wing configurations that were tightly foldable from the nose plate for easy transport, using initially a cloth sail and later one of Dacron.

The Parasev sail and cross-spreader beam format first flown on February 5, 1961 was seen 14 months later in the April 1963 maiden flight of the Mike Burns Skiplane, as he had closely studied NASA literature;[5] Burns later helped make airworthy the ski-kite-glider of Australian John Dickenson that also embodied mechanics of the two-lobe four-beam wing designed earlier by Charles Richards.[6]

The Richard's aluminum-tubed two-lobed Paresev wing configuration evolved to the sharp-nosed, low-sweep standard Rogallos of the 1960s and early 1970s, coupled with variations of the triangle control frame used in hang gliders as far back as the 1900s, if not earlier. Data developed by NASA in the late 1950s fed both the Charles Richards team and a different Ryan Aeronautical team that produced the Fleep. The Fleep used the four-beam two-lobed wing and influenced Barry Hill Palmer, builder and pilot of the first hang glider based on the Rogallo wing. The rigid-tubed Paresev used a cantilevered cross-beam but did not use a kingpost.[7]

Note that the "paraglider" involved in the early 1960s experiments is very different from the sport glider of today used by practitioners of paragliding.

Design and construction

The Paresev 1A and 1B were unpowered; the "fuselage" was an open framework fabricated of welded 4130 steel tubing, called a "space frame". The keel and leading edges of the wing were constructed of 2.5-inch-diameter (64 mm) aluminium tubing. The leading edge sweep angle was held constant at 50 degrees by a rigid spreader bar. Additional wing structure fabricated from steel tubing ensured structural integrity.

The basic vehicle was slightly more than 11 ft (3.4 m) high from the top of the paraglider's wing to the ground, while the length of the center keel was 15 ft (4.6 m). Total weight was about 600 lb (270 kg)[8] On August 24, 1962, seven weeks after the project was initiated, the team rolled out the Paresev 1.[9]

Control

The Paresev was controlled by moving the tensionally hung pilot's and fuselage's mass relative to the position of the wing. This mass-shifting was effected by tilting the wing from side to side and fore and aft by using a control stick in front of the pilot that descended from the wing above. Another version translated the same weight-shift control via cables.[1] As the Paresev was towed in a kite mode, it usually rose from the ground at about 46 mph (74 km/h) and had a maximum air speed of about 65 mph (105 km/h). [10] The Paresev control pendulum weight-shift control system was presaged by a published patent,[11] an early use of the hung pilot behind a cable-stayed triangle control bar in 1908[12] in the territory of Breslau, and then also by control wing of George Spratt in the 1920s.[13]

Variants

Paresev flight log (NOTE – This log is incomplete*): Paresev Flight Log

* The Paresev vehicle was flown 341 times. Thompson made numerous ground-tow flights and claimed about 60 air-tow flights. Peterson claimed 228 flights (ground and air tows). Grissom made two flights. Champine made four flights. Kleuver made at least eight flights. It is unknown how many times Armstrong, Hetzel, and Slayton flew.

Operational history

NASA Parasev 1A at the Udvar Hazy Center

The Paresev completed nearly 350 flights during a research program that ran from 1962 until 1964.[15][16] Using the fully flexible parawing or the tube-stiffened paraglider of the Paresev 1A, 1B, 1C as an alternate to spacecraft recovery was deemed too unreliable upon unfolding so round parachutes for water landings were used instead. The Paresev and other flexible-wing projects such as the Ryan XV-8 stopped being funded by NASA on 1965. Although Rogallo wrote about, modeled, and spoke about recreational applications including hang gliding, NASA was not in the business of applying Rogallo's family of airfoils to personal aircraft such as kites, hang gliders, and powered light aircraft.

The Paresev was transferred to the Smithsonian National Air and Space Museum located in Washington, D.C. for display.

Test pilots

Tow aircraft

Specifications

Data from

General characteristics

Performance


See also

References

  1. ↑ 1.0 1.1 Aviation News article
  2. ↑ Re-entry glider
  3. ↑ Space Flight Revolution -article by NASA
  4. ↑ In 1965 Jack Swigert, who would later be one of the Apollo 13 astronauts, softly landed a full-scale Gemini capsule using a Rogallo wing stiffened with inflatable tubes along the wing’s edges.
  5. ↑ Sky Sport, pgs 39-43, 1989, article
  6. ↑ Paresev
  7. ↑ A 33 page evaluation of two versions of the Paresev hang glider by "Preliminary Flight Evaluation of Two Unpowered Manned Paragliders" written by Barrison F. Layton, Jr., and Milton O. Thompson in National Aeronautics and Space Administration's Technical [vvvvvv Note D-1826] is open to the public and can be freely copied and distributed. Author(s): Layton, G. P., Jr.; Thompson, M. O.
  8. ↑ Specifications
  9. ↑ Construction & dated NASA images
  10. ↑ Abstract: Flight tests of unpowered, manned paragliders. NASA Center: Dryden Flight Research Center Publication Year: 1963 Added to NTRS: 2006-11-06 Accession Number: 63N14429; Document ID: 19630004553; Report Number: NASA-TN-D-1826 NAS-TN-D-1826
  11. ↑ U.S. Patent 376937, filed in 1887, William Beeson of Montana, USA
  12. ↑ Nitsch Collection
  13. ↑ Early Spratt Aircraft
  14. ↑ 14.0 14.1 14.2 14.3 Paresev index: Paresev Photo Gallery Contact Sheet
  15. ↑ Total of 350 flights performed
  16. ↑ Paresev project description
  17. ↑ Apgar Champine, biography: Robert Apgar Champine
  18. ↑ Neil Armstrong - Test flies the Paresev
  19. ↑ Bruce Peterson

External links

Wikimedia Commons has media related to NASA Paresev.