Energy returned on energy invested

In physics, energy economics and ecological energetics, energy returned on energy invested (EROEI or ERoEI); or energy return on investment (EROI), is the ratio of the amount of usable energy acquired from a particular energy resource to the amount of energy expended to obtain that energy resource.^[1][2]

When the EROEI of a resource is less than or equal to one, that energy source becomes an "energy sink", and can no longer be used as a primary source of energy.

Non-manmade energy inputs

The natural or original sources of energy are not usually included in the calculation of energy invested, only the human-applied sources. For example in the case of biofuels the solar insolation driving photosynthesis is not included, and the energy used in the stellar synthesis of fissile elements is not included for nuclear fission. The energy returned includes usable energy and not wastes such as heat, although depending on source and application, waste heat is used in district heating and water desalination, these cogeneration plants however are rare, globally, and thus usually excluded in EROEI analysis of energy sources.

Relationship to net energy gain

EROEI and Net energy (gain) measure the same quality of an energy source or sink in numerically different ways. Net energy describes the amounts, while EROEI measures the ratio or efficiency of the process. They are related simply by

or

For example given a process with an EROEI of 5, expending 1 unit of energy yields a net energy gain of 4 units. The break-even point happens with an EROEI of 1 or a net energy gain of 0.

Low carbon power

Pickard reports EROEI estimates for monocrystalline silicon photovoltaics by four groups in the range of 2.2 to 8.8.^[3] It should be noted that EROEI is a function of the solar irradiation level and the type of PV technology; it also depends on methodology and system boundary assumptions. Raugei, Fullana-i-Palmer and Fthenakis show EROEI in the range of 5.9 to 11.8 and 19 to 39 for the major commercial PV types in South European installations.^[4] The low range assumes that primary energy and electricity are of the same quality, whereas the high range (19-39) is calculated by converting the electricity output of PV to primary energy as recommended by the IEA PVPS Task 12 LCA Methodology Guidelines.^[5] Furthermore, Fthenakis determined the EROEI to be as high as 60 for the least energy consuming thin-film PV technology installations in the U.S. Southwest.^[6]

In 2006, according to the Danish Wind Energy Association, the EROEI of wind energy in North America and Europe is about 20:1.^[7]

A 2013 book calculated the EROEI of spanish photovoltaic systems using actual data from the spanish government. Their result was an EROEI of 2.45. ^[8]

Economic influence of EROEI

EROI — Ratio of Energy Returned on Energy Invested. Assuming, amongst other things, "Nuclear" depended upon diffusion enrichment which was still used in the US at the time of publication - Murphy & Hall 2010. In 2013 however, the last uranium diffusion plant in the world, at Paducah, closed down.^[9] Only newer more efficient technology is now used.

High per-capita energy use has been considered desirable as it is associated with a high standard of living based on energy-intensive machines. A society will generally exploit the highest available EROEI energy sources first, as these provide the most energy for the least effort. Then progressively lower quality ores or energy resources are used as the higher-quality ones are either exhausted or in use, for example, wind turbines positioned in the windiest areas.

In regard to fossil fuels, when oil was originally discovered, it took on average one barrel of oil to find, extract, and process about 100 barrels of oil. That ratio has declined steadily over the last century to about three barrels gained for one barrel used up in the U.S. (and about ten for one in Saudi Arabia). ^[12]

Although many qualities of an energy source matter (for example oil is energy-dense and transportable, while wind is variable), when the EROEI of the main sources of energy for an economy fall energy becomes more difficult to obtain and its value rises relative to other resources and goods. Therefore the EROEI gains importance when comparing energy alternatives. Since expenditure of energy to obtain energy requires productive effort, as the EROEI falls an increasing proportion of the economy has to be devoted to obtaining the same amount of net energy.

Since the invention of agriculture, humans have increasingly used exogenous sources of energy to multiply human muscle-power. Some historians have attributed this largely to more easily exploited (i.e. higher EROEI) energy sources, which is related to the concept of energy slaves. Thomas Homer-Dixon ^[13] argues that a falling EROEI in the Later Roman Empire was one of the reasons for the collapse of the Western Empire in the fifth century CE. In "The Upside of Down" he suggests that EROEI analysis provides a basis for the analysis of the rise and fall of civilisations. Looking at the maximum extent of the Roman Empire, (60 million) and its technological base the agrarian base of Rome was about 1:12 per hectare for wheat and 1:27 for alfalfa (giving a 1:2.7 production for oxen). One can then use this to calculate the population of the Roman Empire required at its height, on the basis of about 2,500–3,000 calories per day per person. It comes out roughly equal to the area of food production at its height. But ecological damage (deforestation, soil fertility loss particularly in southern Spain, southern Italy, Sicily and especially north Africa) saw a collapse in the system beginning in the 2nd century, as EROEI began to fall. It bottomed in 1084 when Rome's population, which had peaked under Trajan at 1.5 million, was only 15,000. Evidence also fits the cycle of Mayan and Cambodian collapse too. Joseph Tainter^[14] suggests that diminishing returns of the EROEI is a chief cause of the collapse of complex societies, this has been suggested as caused by peak wood in early societies. Falling EROEI due to depletion of high quality fossil fuel resources also poses a difficult challenge for industrial economies.

Tim Garrett links EROEI and inflation directly, based on a thermodynamic analysis of historical world energy consumption (Watts) and accumulated global wealth (US dollars). This economic growth model indicates that global EROEI is the inverse of global inflation over a given time interval. Because the model aggregates supply chains globally, local EROEI is outside its scope.^[15]

Oil sands

Because much of the energy required for producing oil from oil or tar sands (bitumen) comes from low value fractions separated out by the upgrading process, there are two ways to calculate EROEI, the higher value given by considering only the external energy inputs and the lower by considering all energy inputs, including self generated. See: Oil sands#Input energy^[16] "utilized detailed energy production and consumption data reported by oil sands producers from 1970 to 2010 to examine trends in historical energy returns from oil sands extraction. " They argued that by 2010, NERs (net energy returns) from oil sands mining and in situ operations had become significantly more energy efficient since 1970 although the NER remained significantly less efficient than conventional oil production. NERs from the oil sands, grew from "1.0 GJ/GJ in 1970 (entirely from the Suncor mining operation) to 2.95 GJ/GJ in 1990 and then to 5.23 GJ/GJ in 2010." ^[17]

EROEI under rapid growth

A related recent concern is energy cannibalism where energy technologies can have a limited growth rate if climate neutrality is demanded. Many energy technologies are capable of replacing significant volumes of fossil fuels and concomitant green house gas emissions. Unfortunately, neither the enormous scale of the current fossil fuel energy system nor the necessary growth rate of these technologies is well understood within the limits imposed by the net energy produced for a growing industry. This technical limitation is known as energy cannibalism and refers to an effect where rapid growth of an entire energy producing or energy efficiency industry creates a need for energy that uses (or cannibalizes) the energy of existing power plants or production plants.^[18]

The solar breeder overcomes some of these problems. A solar breeder is a photovoltaic panel manufacturing plant which can be made energy-independent by using energy derived from its own roof using its own panels. Such a plant becomes not only energy self-sufficient but a major supplier of new energy, hence the name solar breeder. Research on the concept was conducted by Centre for Photovoltaic Engineering, University of New South Wales, Australia.^[19][20] The reported investigation establishes certain mathematical relationships for the solar breeder which clearly indicate that a vast amount of net energy is available from such a plant for the indefinite future.^[21] The solar module processing plant at Frederick, Maryland^[22] was originally planned as such a solar breeder. In 2009 the Sahara Solar Breeder Project was proposed by the Science Council of Japan as a cooperation between Japan and Algeria with the highly ambitious goal of creating hundreds of GW of capacity within 30 years.^[23] Theoretically breeders of any kind can be developed. In practice, nuclear breeder reactors are the only large scale breeders that have been constructed as of 2014, with the 600 MWe BN-600 and 800 MWe BN-800 reactor, the two largest in operation.

Criticism of EROEI

Measuring the EROEI of a single physical process is unambiguous, but there is no agreed-upon standard on which activities should be included in measuring the EROEI of an economic process. In addition, the form of energy of the input can be completely different from the output. For example, energy in the form of coal could be used in the production of ethanol. This might have an EROEI of less than one, but could still be desirable due to the benefits of liquid fuels.

How deep should the probing in the supply chain of the tools being used to generate energy go? For example, if steel is being used to drill for oil or construct a nuclear power plant, should the energy input of the steel be taken into account, should the energy input into building the factory being used to construct the steel be taken into account and amortized? Should the energy input of the roads which are used to ferry the goods be taken into account? What about the energy used to cook the steelworker's breakfasts? These are complex questions evading simple answers. A full accounting would require considerations of opportunity costs and comparing total energy expenditures in the presence and absence of this economic activity.

However, when comparing two energy sources a standard practice for the supply chain energy input can be adopted. For example, consider the steel, but don't consider the energy invested in factories deeper than the first level in the supply chain.

Energy return on energy invested does not take into account the factor of time. Energy invested in creating a solar panel may have consumed energy from a high power source like coal, but the return happens very slowly, i.e. over many years. If energy is increasing in relative value this should favour delayed returns. Some believe this means the EROEI measure should be refined further.

Conventional economic analysis has no formal accounting rules for the consideration of waste products that are created in the production of the ultimate output. For example, differing economic and energy values placed on the waste products generated in the production of ethanol makes the calculation of this fuel's true EROEI extremely difficult.

EROEI is only one consideration and may not be the most important one in energy policy. Energy independence (reducing international competition for limited natural resources), decrease of greenhouse gas emissions (including carbon dioxide and others), and affordability could be more important, particularly when considering secondary energy sources. While a nation's primary energy source is not sustainable unless it has a use rate less than or equal to its replacement rate, the same is not true for secondary energy supplies. Some of the energy surplus from the primary energy source can be used to create the fuel for secondary energy sources, such as for transportation.

Richards and Watt propose an Energy Yield Ratio for photovoltaic systems as an alternative to EROEI (which they refer to as Energy Return Factor). The difference is that it uses the design lifetime of the system, which is known in advance, rather than the actual lifetime. This also means that it can be adapted to multi-component systems where the components have different lifetimes.^[24]

See also

• Embodied energy
• Emergy
• Energy balance
• Energy cannibalism
• Jevons paradox 1880s observation of the efficiency effect multiplier
• Khazzoom-Brookes Postulate 1980s updating of Jevons paradox
• Cost of electricity by source-Levelized cost of energy

References

Further reading

• Heinberg, Richard (2003). The Party's Over: Oil, War, and the Fate of Industrial Societies. Gabriola, BC: New Society Publishers. ISBN 0-86571-482-7. 
• Gupta, Ajay K; Hall, Charles A.S (2011). "A Review of the Past and Current State of EROI Data". Sustainability 3 (10): 1796–1809. doi:10.3390/su3101796. Retrieved 25 March 2012. 

External links

• World-Nuclear.org, World Nuclear Association study on EROEI with assumptions listed.
• Web.archive.org, Wayback Archive of OilAnalytics.org, "EROI as a Measure of Energy Availability"
• EOearth.org, Energy return on investment (EROI)
• EOearth.org, Net energy analysis
• H2-pv.us, Essay on H2-PV Breeder Synergies

Bioenergy Biofuels Alcohol Algae fuel Bagasse Babassu oil Biobutanol Biodiesel Biogas Biogasoline Corn stover Ethanol cellulosic mixtures Methanol Stover Corn stover Straw Cooking oil Vegetable oil Wood gas Energy from foodstock Barley Cassava Grape Hemp Maize Oat Palm oil Potato Rapeseed Rice Sorghum bicolor Soybean Sugarcane Sugar beet Sunflower Wheat Yam Non-food energy crops Arundo Big bluestem Camelina Chinese tallow Duckweed Jatropha curcas Millettia pinnata Miscanthus giganteus Switchgrass Wood fuel Technology Bioconversion Biomass heating systems Biorefinery Fischer–Tropsch process Industrial biotechnology Pellets mill stove Thermal depolymerization Concepts Cellulosic ethanol commercialization Energy content of biofuel Energy crop Energy forestry EROEI Food vs. fuel Issues Sustainable biofuel