Black and burst
Black and Burst also known as bi-level sync and black burst is an analogue signal used in broadcasting. It consists of a video signal with a blacked-out picture.[1] It is used to synchronise video signals together to put them on the same timing plane. It allows vertical timing that allows synchronous switching between two video signals. Black/Burst also locks the colour phase between signals. The burst section of the waveform allows the phase relationship of the two signals to be timed together by sending pulses to the internal oscillators of the equipment.
History
PAL is a broadcast transmission standard for Europe, and from this standard the Black/Burst analogue reference was created. Black and Burst became common when the PAL video format became standard in Europe, then became the most commonly used reference signal. It is commonly used today, it is sometimes referred to as a SD reference but this has no relevance to SD-SDI.
Black and Burst is now a predecessor to Tri Level Sync also known as HD reference. Please see Genlock
Waveform
Its natural waveform is a negative pulse of 300mv also known as the front porch followed by 10 cycles of the colour sub carrier of PAL video,the frequency of the sub carrier is 4.43361875MHZ.[2] This is also known as the back porch. as the back porch This is also known as the burst.
The front porch (-300) takes 4 microseconds and the back porch (burst) 8 microseconds, Each line of video take 64 microseconds and its line frequency is 15625 Hz
-
Here you can see the sub carrier 'burst'.
References
- ↑ Michael Talbot-Smith (1 January 1994). Audio Engineer's Reference Book. Focal Press. ISBN 978-0-7506-0386-7.
- ↑ TV and Video Engineers Handbook, Third Edition - Eugene Trundle. Page 14. 1999 ISBN 0-7506-4194-0 Newnes Press