Stall Turn
The Hammerhead Turn, Stall Turn, or Fieseler is an aerobatics turn-around maneuver.
Description
Enter at full power and maximum airspeed. Pull the aircraft up through a quarter loop into a vertical climb. The speed will decay but before upward motion stops firmly apply full rudder to yaw the aircraft through a cartwheel of 180° until the nose is straight down. Dive vertically to the same altitude as the maneuver started, then pull out, exiting in the opposite direction.[1]
Flying technique
The timing of applying full rudder is critical. If instigated too soon it results in a wingover. If instigated too late the plane will fall into a sideslip or else enter a tailslide which most aircraft are restricted from doing.
Instigating the pivot requires airflow over the rudder. In high powered planes propeller slipstream will provide this, but planes with smaller engines need to apply rudder sooner[2] c. 40 knots.
This maneuver demands there be no rolling at all but when airflow is minimal ailerons become ineffective. So as soon as the yaw is established reduce throttle to prevent the aircraft from rolling due to engine torque. Do not open the throttle again until the dive when sufficient airspeed has been gained for aileron control.[1] Reduced throttle will also prevent gyroscopic precession from pitching the nose up.
Another problem in this maneuver is that higher lift from the faster moving outside wing will roll the airplane to the left. Most pilots find holding forward right stick necessary throughout the pivot.[2]
SAR reversal
This maneuver has also been called the search and rescue reversal. SAR Helicopters fly this when hunting survivors or submarines for it brings the aircraft directly back along the same course to verify the target. The maneuver doesn't require visual meteorological conditions (VMC) if the pilot is proficient at maintaining altitude by keeping the lateral acceleration ball centered, for any uncoordinated lateral acceleration will induce spatial disorientation.[citation needed]