SpinRite

SpinRite

SpinRite 6.0
Developer(s)	Gibson Research Corporation
Initial release	1988
Stable release	6.0 / June 7, 2004 (2004-06-07)
Preview release	none (none) [±]
Written in	x86 assembly language
Operating system	Included FreeDOS (doesn't use OS of host PC) runnable from DOS
Platform	Any PC
Size	0.169 MB executable, 1.40 MB bootable disk image with FreeDOS OS
Available in	English
Type	Hard Disk Recovery
License	Proprietary
Website	GRC.com SpinRite Website

SpinRite is a computer software program for scanning magnetic data storage devices such as hard disks, recovering data from them and refreshing their surfaces. The first version was released in 1988. Version 6.0, still current as of August 2013, was released in 2004.^[1] SpinRite may be run from a bootable media on a PC-compatible computer, independent of any operating system installed.

History

Steve Gibson stated during episode 410 of Security Now! that he originally wrote SpinRite as a hard drive interleave tool. ^[2] At the time SpinRite was designed, hard drives often had a defect list printed on the nameplate, listing known bad sectors discovered at the factory. In changing the drive's interleave, SpinRite needed to be able to remap these physical defects into different logical sectors. SpinRite therefore gained its data recovery and testing capabilities as a side-effect of its original purpose. Gibson states that today, drive interleave is no longer an issue, but the data recovery features of SpinRite proved to be so useful that it evolved into the data recovery tool that it is today.

Features

SpinRite tests the data surfaces of writeable magnetic disks, including IDE, SATA, and floppy disks. It analyses their contents and can refresh the magnetic disk surfaces to allow them to operate more reliably.

SpinRite attempts to recover data from hard disks with damaged portions that may not be readable via the operating system. When the program encounters a sector with errors that cannot be corrected by the disk drive's error-correcting code, it tries to read the sector up to 2000 times, in order to determine, by comparing the successive results, the most probable value of each bit. The data is then saved onto a new block on the same disk; it cannot be saved elsewhere. In this respect SpinRite differs from most data recovery software, which usually provides (and recommends) an option to save the recovered data onto another disk, or onto a separate partition on the same disk.

Gibson Research Corporation claims their SpinRite software will diagnose the quality of a disk drive, and make it work as reliably as possible with future use. Its developer, Steve Gibson, says his software was specifically designed to fix sector problems. However, if a hard drive's circuit board, drive motors or other mechanical parts are defective, or there is systemic file system corruption, SpinRite may be of little or no help.^[3] In fact, regarding mechanical issues no purely software-based solution would be sufficient to overcome the problem. When a hard drive has begun to develop mechanical faults, a program like SpinRite may sometimes be able to extend its usable life for long enough to carry out successful file recovery with other specialized software.

SpinRite is declared by its developer to have certain unique features,^[4] such as disabling of disk write caching, disabling of auto-relocation, compatibility with disk compression, identification of the "data-to-flux-reversal encoder-decoder" used in a drive, and separate testing of buffered and unbuffered disk read performance. Another important feature is direct hardware-level access,^[5] whereby the drive's internal controller interacts directly with the program, rather than through the operating system. This, in turn, allows dynamic head repositioning, whereby, when reading a faulty sector, the reading head is deliberately moved backwards and forwards many times, by varying amounts, in the hope that each time it returns to the sector, it may come to rest in a slightly different position. By performing statistical analysis on the succession of results thus obtained, SpinRite is, according to its maker, often able to "reconstruct" data from damaged sectors; and even in those cases in which complete reconstruction proves impossible, SpinRite is able to extract all intact bits from a partially damaged sector, and to copy them to a new block, thereby minimizing the amount of data lost.^[6]

Certain claims made by SpinRite's makers have proved controversial. The program's claimed ability to "refresh" aging drives has been met with particular scepticism, while its "recovery" of sectors marked as damaged by the file system controller is considered by some to be undesirable and ultimately counter-productive.^[7]

SpinRite is written in x86 assembly language, and runs on any PC-compatible computer (as long as it is capable of running MS-DOS—virtually all can), regardless of the operating system actually installed. It can operate on any attached storage device with a compatible interface.^[8] Drives in computers with incompatible processors can be tested by attaching the drive to a compatible computer.^[9] Spinrite is distributed as a Microsoft Windows executable program which can create a bootable floppy disk or CD-ROM containing both the FreeDOS MS-DOS-compatible operating system and the Spinrite program itself. Version 6 is compatible with hard disks containing any logical volume management or file system such as FAT16 or 32, NTFS, Ext3 as well as other Linux file systems, HFS+ For Mac OS X, Tivo and others, as it operates only on the disk itself.

SpinRite 2.0, circa 1991.

Version 6 is rather different from previous versions. It offers full access to the entire disk surface regardless of partitioning, Self-Monitoring, Analysis, and Reporting Technology (S.M.A.R.T.) parameters and control of partial scanning within a specified percentage range. Version 5 was limited to AT Attachment (PATA, IDE) hard drives; version 6 may, on suitable motherboards, work on newer Serial ATA (SATA) and USB hard drives, and with any other type of drive—SCSI, 1394/Firewire—that can be made visible to MS-DOS through the addition of controller BIOS or add-on DOS drivers.^[9]

The price as of December 2012 was US$89. Documentation may be downloaded free of charge from the SpinRite website.

Issues

Solid state drives

Spinrite can be run and is very effective on SSDs, but only in level 1 or 2 mode, and not in any higher mode, since writing to the SSD reduces its performance over time. In episode 194 of the podcast Security Now! Gibson said that he "can see absolutely no possible benefit to running SpinRite on a solid-state drive." and later "SpinRite is all about mechanics and magnetics, neither of which exist , by design, in an SSD.".^[10] However, in episode 338 Gibson clarified "it is actually detrimental because [solid-state drives] don't like to be written.", but also pointing out that a read-only run could beneficial: "SpinRite's Level 1 is a read-only scan, and doing that on an SSD makes a lot of sense. Do a read-only scan of an SSD, it'll show the SSD's controller that it's got a problem reading a sector, and then it'll map that out or rewrite it in order to strengthen that sector, if possible. So that ends up being a value for SpinRite on solid-state drives." ^[11] Also, Gibson posted on his website that "SpinRite is seeing many successes [...] with non-spinning solid-state (thumb) drives!".^[12]

S.M.A.R.T. on SATA drives

While SATA drives are supported, SATA controllers that include a processor and diagnostic software can limit SpinRite's ability to obtain and display S.M.A.R.T. data ("thin controller" SATA controllers do not have this limitation). This data monitor does not affect SpinRite's recovery and diagnostics ability; S.M.A.R.T. data when available helps long-term disk maintenance and failure prediction.^[13] GRC said in 2006 that this issue would be resolved in version 6.1, anticipated to be a free-of-charge upgrade for SpinRite 6.0 users.^[13] As of November 2012 version 6.0 was the current version.^[14][15]

Large drives

SpinRite error on large drives

In certain cases, Spinrite can only analyze somewhere between the first 128 gigabytes and 1024 gigabytes of a drive depending on whether the drive has 512 bytes per sector or 4096 bytes per sector, and depending on the BIOS in use.

SpinRite uses cylinder-head-sector method when addressing the hard drive. This 28-bit addressing scheme is broken down as:

1. Cylinder (16-bits): 0–65535
2. Head (4-bits): 0–15
3. Sector (8-bits): 0–255

This limits SpinRite to access a maximum of 268,435,456 sectors. Once SpinRite reaches track number 65,535 it will experience a division-by-zero error and halt with an error message. This appears to be due to a restriction of the FreeDOS operating system (an MS-DOS clone) supplied with Spinrite; it has been reported that it has problems with very large drives, and that using, say, the Microsoft version of MS-DOS known as Windows 98 DOS 7, Spinrite will test the entire drive.^[16][17]

A December 2011 page on the Spinrite Web site says that an anomaly, which was named the "Roger anomaly" after its discoverer, is due to an error in the BIOS of some motherboards which does not affect normal use and hence may not be discovered.^[18] This is sometimes resolved in a later BIOS update; a motherboard with this problem will not work with Spinrite, but drives can be temporarily relocated to any other motherboard where "SpinRite will almost certainly agree to operate without trouble".^[18] Drive size is not mentioned as a factor.

Future

In July 2013, Steve Gibson stated that he was actively working on a minor update to SpinRite that will bring with it many features to update its compatibility with modern hardware; among these being use of direct PCI bus access rather than the BIOS for accessing the disk, ability to boot on Mac systems (requiring an update to the keyboard input driver), fixes to the FreeDOS kernel to address issues users have had, and the use of various memory management tricks on x86 processors to allow access to large disk transfer buffers while in real mode, improving performance.

Gibson also vaguely discussed SpinRite 7, which he says will be "a complete rewrite", addressing frequently requested features such as recovery of specific files or directories and optimization for use on SSD devices.

SpinRite on Mac

In his Security Now podcast 408, Steve Gibson announced that he had SpinRite running on his Macbook Air and would release a Mac-compatible version in the future. All SpinRite customers up to and including version 6 would be able to upgrade free of charge.^[19] As Apple Macs use EFI instead of BIOS, Spinrite will not run on a Mac. However, it can be run in a virtual machine under OSX (and other operating systems) to scan a drive which is not the OS drive^[20] This has been reported to work, but to be unusably slow.^[21] Spinrite can operate on a Mac disk if it is removed and connected temporarily to a PC.

See also

• List of data recovery software
• S.M.A.R.T.

References