Snipe (wood machining)

From Wikipedia, the free encyclopedia

Snipe, in woodworking, is a noticeably deeper cut on the leading and/or trailing end of a board after having passed through a thickness planer or jointer. Its cause, in a jointer, is an out-feed table which is set too low relative to the cutter head, or in a thickness planer, an unnecessarily high setting of the Bed rollers of the in-feed table or a pressure bar which is set too high. ^[1] The term has its origin in forestry where it is applied to a sloping surface or bevel cut on the fore end of a log to ease dragging. (OED)

References

↑ http://newtowoodworking.com/snipe/

Woodworking

Introduction

Forms

List of woods

Softwood	Cedar Pine Spruce

Hardwood	Ash Aspen Balsa Birch Cherry Elm Hazel Linden/ Lime/ Basswood Mahogany Maple Oak Teak Walnut

Tools

Saws	Backsaw Bandsaw Bow saw Bucksaw Chainsaw Circular saw Coping saw Crosscut saw Frame saw Fretsaw Jigsaw Miter saw Rip saw Veneer saw Whipsaw

Other	Abrasives Axe Adze Chisel Drawknife Drill List of timber framing tools Mallet Mitre box Moulding plane Plane Rasp Sandpaper Vise Wood scribe Workbench

Geometry

Joints	Birdsmouth Bridle Butt Butterfly Coping Crown of Thorns Dados Dovetail Finger Groove Halved Hammer-headed tenon Knee Lap Mason's mitre Miter Mortise and tenon Rabbet Scarf Splice Tongue and groove

Profiles	Bead Bevel Chamfer Ogee Ogive

Treatments

Organizations

Conversion

Category
Commons
WikiProject

This article is issued from Wikipedia. The text is available under the Creative Commons Attribution/Share Alike; additional terms may apply for the media files.