Plastigauge

From Wikipedia, the free encyclopedia

Plastigauge is a measuring tool used for measuring plain bearing clearances, such as engines. Other uses include marine drive shaft bearings, turbine housing bearings, pump and pressure system bearings, shaft end-float, flatness and clearance in pipe-flanges and cylinder heads. Wherever it is required to determine the separation between hidden surfaces. Plastigauge was introduced to US retail sales in 1948.[1]

Plastigauge consists of a strip of soft material with precise known dimensions and deformation characteristics. This is sandwiched between a clean bearing surface on a shaft and the bearing shell itself. The plastigauge flattens after the bearing cap is tightened. The dimensional clearance is then determined by comparing the amount that the gauge material has flattened using a template. Letter designation describes the range of measurement use for each gauge. PL-A (0.001" - 0.007 in. (0.025mm-0.175mm)), PL-B (0.004" - 0.010 in. (0.100mm-0.250mm)), PL-C (0.007" - 0.020 in. (0.175mm-0.500mm)), PL-D (0.020" - 0.040 in. (0.500mm-1.00mm)), PL-E (0.030" - 0.070 in. (0.75mm-1.75mm)), PL-X Plastigauge (0.018mm - 0.045mm)

[2]

Plastigauge is a registered trademark of Plastigauge Ltd., West Sussex, United Kingdom.

References

  1. ↑ "Plastic Rod Checks Bearings". Popular Mechanics: 113. March 1948. 
  2. ↑ Gardiner, Bill (September 24, 1988). "Owner believes1 '84 Horizon a lost cause after 'repair'". Toronto Star (Toronto, Ont.). Retrieved 9 January 2010. 


External links


This article is issued from Wikipedia. The text is available under the Creative Commons Attribution/Share Alike; additional terms may apply for the media files.