Piaggio P.7

From Wikipedia, the free encyclopedia

The P.7 afloat. When at rest, the aircraft floated up to its wings on its watertight fuselage with its hydroplanes submerged beneath it and its wings resting on the water.

The P.7 as it appeared from above while afloat.

The P.7 ashore, displaying the hydroplanes it used instead of floats.

The Piaggio P.7, also known as the Piaggio-Pegna P.c.7, was an Italian racing seaplane designed and built by Piaggio for the 1929 Schneider Trophy race.

Design and development

Seeking to avoid the aerodynamic drag induced by floats in seaplanes of floatplane design, Ing Giovanni Pegna of the Piaggio company designed a very unusual seaplane to represent Italy in the 1929 Schneider Trophy race. A cantilever shoulder-wing monoplane known both as the Piaggio P.7 and the Piaggio-Pegna P.c.7, his design floated up to its wings on its long, slender, watertight fuselage with the wings resting on the water, and employed twin high-incidence hydrofoils to get itself off the water during take-off runs.^[1]

Sources differ on the P.7's engine; it is described both as an Isotta-Fraschini Special V6 rated at 723 kilowatts (980 horsepower)^{[citation needed]} and as an Isotta-Fraschini AS-5 rated at 745 kilowatts (1,000 horsepower).^[2] The engine was connected both to a two-bladed, automatic variable-pitch tractor propeller by a long metal shaft and by another shaft to a smaller marine propeller, similar to those used on motorboats, mounted beneath the aircraft's tail. To take off, the pilot would start the engine with the flight propeller feathered and the normal carburettor air intake closed and use a clutch to engage the tail propeller and get the aircraft moving through the water. The two hydrofoils, mounted beneath the fuselage on struts connected to the fuselage just forward of the wings similar to the way in which floats were mounted on floatplanes, would cause the P.7 to rise out of the water almost immediately. After the aircraft had risen on its hydrofoils and the flight propeller had cleared the water, the pilot would open the carburettor air intake, again employ the clutch to disengage the marine propeller, and use another clutch to engage the flight propeller, which automatically would switch from feathered to flight pitch. Driven by its flight propeller, the aircraft then would engage in a conventional take-off, riding on its submerged hydrofoils until it reached take-off speed.^[1]

Without the aerodynamic drag induced by floats or the weight they added to an aircraft, Pegna projected that the P.7 would reach high speeds. Sources differ on the speeds he predicted, claiming both 580 km/h (360 mph)^{[citation needed]} and 700 km/h (434.7 mph).^[3]

Testing

Piaggio manufactured one P.7 and turned it over to the Italian Schneider Trophy racing team. Although some pilots refused to fly the aircraft, the Italian Schneider team's Tommaso Dal Molin conducted some water tests on Lake Garda in northern Italy. The spray the hydroplanes generated made it difficult to see during take-off, and persistent problems with both clutches ensued. The aircraft never became airborne.^[1]

Not ready in time, the P.7 was excluded from the 1929 Schneider Trophy race, in which a Macchi M.52R and two Macchi M.67 seaplanes represented Italy. Piaggio and Pegna abandoned plans to build a second P.7.^[1]

Operators

Italy

Specifications

Data from Italian Civil and Military aircraft 1930-1945.^[1]^[4]

General characteristics

Crew: 1
Length: 8.8583 m (29 ft 0.75 in)
Wingspan: 6.76 m (22 ft 2 in)
Height: 2.451 m (8 ft 0.5 in)
Wing area: 9.83 m² (105.8 sq ft)
Empty weight: 1,403 kg (3,093 lb)
Gross weight: 1,682 kg (3,709 lb)
Powerplant: 1 × Isotta-Fraschini V-12 liquid-cooled piston engine, 630 kW (850 hp)

Sources differ, claiming both that the P.7's engine was an Isotta-Fraschini Special V6 rated at 723 kW (970 hp)^{[citation needed]} and an Isotta-Fraschini AS-5 rated at 745 kW (999 hp)^[1] Performance

Maximum speed: 600 km/h; 324 kn (373 mph)

Sources differ on the P.7's projected maximum speed, claiming both 580 km/h (360 mph)^{[citation needed]} and 700 km/h (434.7 mph).^[1]

Notes

↑ 1.0 1.1 1.2 1.3 1.4 1.5 1.6 Vašiček, Aviation History, September 2002, p. 35.
↑ Per Vašiček, Aviation History, September 2002, p. 35.
↑ Per Vašiček, Aviation History, September 2002, p. 35, who says the aircraft mounted the Isotta-Fraschini AS-5 engine.
↑ Thompson, Jonathan W. (1963). Italian Civil and Military aircraft 1930-1945 (1st ed.). New York: Aero Publishers Inc. pp. 218–219. ISBN 0-8168-6500-0.

References

Wikimedia Commons has media related to Piaggio P.7.

Vašiček, Radko. "When Seaplanes Ruled the Sky." Aviation History, September 2002.

v t e Piaggio aircraft

Piaggio	Fn.350 P.2 P.3 P.6 P.7 P.8 P.9 P.10 P.11 P.12 P.16 P.23M P.23R P.32 P.50 P.108 P.111 P.119 P.133 P.136 P.148 P.149 P.150 P.166 P.180 P1XX (under development)

Piaggio-Douglas	PD.808

Piaggio-Pegna	P.c.7

Piaggio-Selex	P.1HH

v t e Lists relating to aviation

General	Aircraft manufacturers Aircraft engines manufacturers Gliders Airlines defunct Airports Civil authorities Museums Registration prefixes Rotorcraft manufacturers Timeline

Military	Air forces Weapons Experimental Missiles Unmanned

Accidents/incidents	Commercial airliners by location Fatalities by death toll General aviation Military

Records	Airspeed Altitude Distance Endurance Firsts Large Most-produced aircraft Most-produced rotorcraft

This article is issued from Wikipedia. The text is available under the Creative Commons Attribution/Share Alike; additional terms may apply for the media files.