PackBits

From Wikipedia, the free encyclopedia

PackBits is a fast, simple lossless compression scheme for run-length encoding of data.

Apple introduced the PackBits format with the release of MacPaint on the Macintosh computer. This compression scheme is one of the types of compression that can be used in TIFF-files. TGA-files also use this RLE compression scheme, but treats data stream as pixels instead of bytes.

A PackBits data stream consists of packets with a one-byte header followed by data. The header is a signed byte; the data can be signed, unsigned, or packed (such as MacPaint pixels).

In the following table, n is the value of the header byte as a signed integer.

Header byte Data following the header byte
0 to 127 (1 + n) literal bytes of data
-1 to -127 One byte of data, repeated (1 n) times in the decompressed output
-128 No operation (skip and treat next byte as a header byte)

Note that interpreting 0 as positive or negative makes no difference in the output. Runs of two bytes adjacent to non-runs are typically written as literal data. It should also be noted that there is no way based on the PackBits data to determine the end of the data stream; that is to say, one must already know the size of the compressed or uncompressed data before reading a PackBits data stream to know where it ends.

Apple Computer (see the external link) provides this short example of packed data: FE AA 02 80 00 2A FD AA 03 80 00 2A 22 F7 AA

The following code, written in Microsoft VBA, unpacks the data:

Sub UnpackBitsDemo()
   Dim File As Variant
   Dim MyOutput As String
   Dim Count As Long
   Dim i As Long, j As Long
 
   File = "FE AA 02 80 00 2A FD AA 03 80 00 2A 22 F7 AA"
   File = Split(File, " ")
 
   For i = LBound(File) To UBound(File)
      Count = Application.WorksheetFunction.Hex2Dec(File(i))
      Select Case Count
      Case Is >= 128
         Count = 256 - Count 'Two's Complement
         For j = 0 To Count 'zero-based
            MyOutput = MyOutput & File(i + 1) & " "
         Next j
         i = i + 1 'Adjust the pointer
      Case Else
         For j = 0 To Count 'zero-based
            MyOutput = MyOutput & File(i + j + 1) & " "
         Next j
         i = i + j 'Adjust the pointer
      End Select
   Next i
 
   Debug.Print MyOutput
   'AA AA AA 80 00 2A AA AA AA AA 80 00 2A 22 AA AA AA AA AA AA AA AA AA AA'
End Sub

External links

This article is issued from Wikipedia. The text is available under the Creative Commons Attribution/Share Alike; additional terms may apply for the media files.