Nerf bar

A 2002 Ford Explorer Sport Trac with black nerf bars.

A nerf bar is a tubular device fitted to the side of a racecar, typically single-seat race cars that compete on asphalt or dirt oval tracks. A "nerf" is a small, sometimes intentional, collision between two cars in which one driver bumps the other to facilitate a successful pass. The nerf bar protects the sides of the vehicles and also keeps their tires from becoming entangled. If fast-spinning tires come in contact with each other, one or both of the cars may lose control or even become airborne. Used on Asphalt Modifieds such as used in the NASCAR Whelen Modified Series^{[citation needed]}.

A more commercial application of the nerf bar is for convenience purposes on a pickup truck or sport utility vehicle. It may act as a step to ease entry and exit from the vehicle, or to help prevent damage to the vehicle when crossing rocks off-road. Nerf bars can also be used to double as side bull bars on off-road vehicles^{[citation needed]}.

The term is sometimes applied to the foot-rests on a motorcycle. Nerf bars are typically made from either stainless steel, chrome or powder-coated steel, although there are considerable variations in style and design^{[citation needed]}. On quad bikes nerf bars are used to help stop the wheels of two machines becoming entangled.

They are also variously known as step bars, boss bars, tube steps, step rails, truck steps, or step tubes^{[citation needed]}.

Typically if they are being used to slide over rocks and past trees they are built with thicker tubing and attached directly to the truck's frame rails rather than the body. Being attached to the frame can allow them to support the entire weight of the vehicle and even be used as a jack point to change a tire. They are not called Nerf Bars any more and instead are called Sliders, Rock Bars, or another variation of the two^{[citation needed]}.

Hot Rod Application of the Nerf Bar

The hot rod world will sometimes use a much smaller version of a racing nerf bar. It may be only about 6 inches tall and utilized in the front and rear of a hot rod in place of the traditional bumper. The hot rod nerf bar is attached to the ends of the frame rails and typically chromed. Hot rod nerf bars provide little protection and typically do not qualify as a bumper in most states.

Look up nerf bar in Wiktionary, the free dictionary.