Lathe faceplate

From Wikipedia, the free encyclopedia

Dog plate and conventional plate

Unusual slotted faceplate

A lathe faceplate is the basic workholding accessory for a wood or metal turning lathe. It is a circular metal (usually cast iron) plate which fixes to the end of the lathe spindle. The workpiece is then clamped to the faceplate, typically using t-nuts in slots in the faceplate, or less commonly threaded holes in the faceplate itself.

The faceplate may be attached to the lathe in several ways: the two most common are a thread and a precision cone arrangement or threaded studs and a circular recess fitting a flange on the end of the spindle. Increasingly common is the camlock arrangement where shaped studs and cams replace threaded studs for rapid exchanging of the faceplate with other accessories, such as three or four jaw chucks.

The faceplate was the ancestor of lathe chucks, an arrangement of three or more adjustable 'dogs' bolted to the faceplate providing a primitive chuck arrangement. The smaller plate in the upper photo is specifically a 'dog face' with slots intended to hold a bent tail dog while the work itself was supported on centers. The larger plate to the right simply provides a variety of ways by which work can be bolted or clamped to the plate. The slotted plate on the lower photo accepts wedged holders which can be used to fasten the work to the plate. The plates were expendibles, so it was not unusual as shown in both photos for a machinist to drill additional holes in the plates for attaching work that could not otherwise be attached. While the Dog plates were usually fairly small regardless of the lathe size, the classic face plate is usually matched to the maximum diameter that the lathe will swing.

It may seem that the faceplate is a primitive accessory superseded by precision chucks, but its inherent flexibility (almost any shape can be attached to a faceplate with care and the right fixings) and the possibility of achieving great accuracy by careful setting up make it an essential for the well equipped lathe.

For certain specialist jobs, temporary or special faceplates can be made, perhaps in wood or light alloy, that can be machined or adapted for difficult workholding jobs. One example might be attaching thin sheet metal to a wooden faceplate using woodscrews, allowing the trepanning of holes, with the tool cutting into the sacrificial faceplate material.

Machining and computing

Computer-aided engineering	2.5D CAD CAM G-code Numerical control (NC and CNC) Stewart platform

Drilling and threading	Die head Drill Drill bit Drill bit shank Drill bit sizes Drilling List of drill and tap sizes Tap and die Tap wrench Threading

Grinding and lapping	Abrasive Angle grinder Bench grinder Coated abrasives Cylindrical grinder Diamond plate Flick grinder Grinding Grinding dresser Grinding machine Grinding wheel Jig grinder Lapping Sanding Sharpening stone Spark testing Surface grinder Tool and cutter grinder

Machining	Boring Broaching Electrical discharge machining Electrochemical machining Electron beam machining Endmill Engraving Facing Hobbing Jig borer Machine tool Machining Metal lathe Milling cutter Milling machine Pantograph Photochemical machining Planer Reamer Shaper Turning Ultrasonic machining

Machine tooling	Angle plate Chuck Collet Fixture Indexing head Jig Lathe center Machine taper Magnetic base Mandrel Rotary table Wiggler

Terminology	Cutting fluid Machining vibrations Speeds and feeds Swarf Tolerance Tool and die making Tramp oil

This article is issued from Wikipedia. The text is available under the Creative Commons Attribution/Share Alike; additional terms may apply for the media files.

Lathe faceplate

See also