Kite line

From Wikipedia, the free encyclopedia

Kites have a wing and a kite line (line), or sometimes more than one line. Kite systems may have more than one kite and more than one kite line.

Successful kiting in particular kite applications depends in large part on the kite line's specifications and handling. The integrity of kite lines is affected by wear, reeling, contact with chemicals, loss of strength from knottings, ultraviolet rays of the sun, repeated cycles of use, and damaging actions during use. There are historically classic specifications of kite lines. Kite lines for small toy kites differ greatly from kite lines used for kite tugs that pull commercial cargo ships across the ocean. Sport kites using kite lines two or three or four lines at a time have a need for very low stretch. Single-line recreation kite lines may do well with stretchy kite lines. Kite fighting kites' main tether lines have sharp glass particles bonded to the line. Kite lines misused or abused can cause injury to persons and property. Kite lines vary in pricing and availability. Repair of a particular line has its own arts. Reeling, handling, and storage methods differ for lines depending on the kite applications. Kite lines terminate at the kite's wing/bridle at one end and at some kite mooring at the other end; the mooring is to some object anchor that provides the tug or tension against the resultant of the lift and drag forces of the kite; the anchor is always powered by something even if that something is the Earth's moving surface relative to the air for air kites; a running human kite operator is the source of human powering.

Kite-line parameters

Depending on the kite application and kite system needs, selecting a kite line will consider one or more of the following parameters: availability, base material, color, density, mass per length, size, manufacturer's reports, serial number or product number, diameter, cross-section shape, tensile strength new, aged tensile strength, resistance damage from chemicals, defects, safety factor, resistance to damage from solar radiation (UV stabilization), electrical conductivity, optical conductivity, heat conductivity, moisture intake from water (via humidity, rain, contact with liquid water), buoyancy in water, abrasion resistance, nature of manufacturer's line joins, feel, degradation from knotting, terminal methods, elasticity, structure, signal transmission capacity, visibility to radar, performance over time, maintenance actions, effect on performance from hours of use, drag, negative lift, auxiliary line uses, performance when being reeled under tension, performance when tensed line touches itself, action upon breaking, memory, veil, sleeving, inspectability, surface finish, reaction to heat and cold, taper (as wanted), flexibility, reeling behavior, breaking strength, critical diameter, reliability, test-results portfolio, visibility, twist, plasticity, safety, price. Toy kites sold with a manufacturer's selected line makes the decision easy; the decision is more challenging for custom kite applications. The design and handling of the piano-wire kite line for the high-altitude meteorological observations (1749–1933) was a keen engineering process.[1][2][3][4][5][6][7][8]

Kite lines for children's toy kites

To avoid burns and cuts, kite lines for children toy kites are frequently soft, fuzzy, cotton twine.

Kite lines for sport control kites

Lack of stretch or stable line length for control authority is an advantage of special control lines. Melting point is considered when controlling a kite for kite fighting; lower cost cotton line can melt a crossed expensive synthetic line. Kite lines Dyeing kite lines for show and control line management can occur at a line factory or by a user.[9]

Kite lines for high altitude attempts

Historically, high altitude kite flights were made by atmospheric scientists and meteorologists in the late 19th to early 20th centuries. Routine flights around the world were made using steel wire with single kites and kite trains. The highest recorded flight was made by a German meteorological station at Lindenberg in 1919. It is reported that the top kite reached 31,955 ft above the launch point. The line was over 20 km of high tensile steel piano wire with a breaking strength varying between 134 and 225 kg.[10] In 2000 the single-line single-kite altitude world record for kiting was made using a kite line of woven Kevlar line 3/32 inch in diameter at 270 pound breaking-strength. The kite was described by Richard Synergy in his account of the flight, as employing an angle of attack device to limit line tension to 100 lbs. This gives a safety factor of almost 3 to 1 if the breaking strength of this line is 270 lb.[11] More recent high altitude kite flights by Robert Moore and his team in Australia[12] have been made using Dyneema, a braided Ultra High Molecular Weight Polyethylene (UHMWPE) line, and the identically structured line, Spectra. Both these lines are stronger and lighter than Kevlar for a given diameter. One of the most important characteristics of line for high altitude kite flying is small diameter and high strength to weight ratio. The greatest barrier to high altitude kite flights is aerodynamic line drag.[13] The use of Dyneema over an extended period has shown that it is highly resistant to ultra violet degradation in comparison to Kevlar.[14] Richard Crawford, a high altitude flyer from the USA, made an attempt on the world single kite altitude record using a 220 lb test, Technora line manufactured by Twinline. He reported that he flew a delta kite to approximately 6,500 ft in September 2008.[15][16]

Kite lines for specialized applications

When a kite application does not fit a common purpose, then specialized kite lines are used. Setting specific records under controlled conditions allows kite operators or competitors to choose kite lines with high specificity and without excessive safety factors.

The short kite line called the hang loop for the free-flying kite hang gliders has received special engineering attention; the further main kite-lines from the hang loop to the pilot's harness are also highly specialized in design.[17]

When maximizing performance for large kites; E. D. Archibald was the first to use piano wire for kiting.[18]

Flatland kiting hang gliders with 3000' of tow line holding the manned hang glider kite takes special care to specify. Protecting the kite line from ground abrasion is considered.[19]

Want to fly an indoor kite without wind? The indoor no-wind kite operator need not worry about line breaks causing damages to downwind property. The choice of line can be very specialized here.

When the kite line is to be invisible, a clear translucent fine thread is chosen.

Making kite lines visible for night flying occurs in short-line and long line applications. Line lights is one solution sometimes used. Lines that carry light is another. Lights on the ground shining on stunt kites and their lines occurs. Flying Kites at Night

Spider silk and their kite line for their "ballooning" (mechanical kiting)

Biologists began using the term "ballooning" for spiderling mechanical kiting.[20][21] Another spider silk for the bridge thread is frequently kited. And another thread of the spider is used as a drag line from which spiders frequently swing in the breeze, getting deflected before landing. Humans have used spider silk for making kites.[22]

Safety for kite lines

Fit the kite line to the kite application; handle the line as needed to avoid hazards, accidents, and injury to persons and property. The operator of a kite system is fully responsible for damages done by the operation of his or her kite system; this includes the kite line. Pre-flight plan and pre-flight the kite line; avoid surprises. Piano wire is appropriate for certain applications, but totally inappropriate for recreational or sport kite flying. Fishing monofilament line is not used for most hobby, recreational, or sport power kiting because of its stretch, breaking behavior, and thinness; avoid it unless there is a very special application involved. Metal wire can conduct static and current electricity; avoid metal wires unless a professional scientific or industrial engineer approves the line for a specific purpose. Gloves, proper reel choices, goggles, guards, tension limiters, and other safety devices help to reduce accidents. Ability to de-power a kite's lift and drag is a part of sound kite systems. Tensed line can act as razors. Moving lines can cut through flesh too easily. Fatalities too often occur from kite line abuse. Keep kite lines in good condition. Realize that knots weaken kite line. Keep kite lines dry and clean. Log any wear and use of the line; replace lines as needed. Choose a safety factor when designing a line for an application. Avoid flying in the rain or stormy weather changes.[23][24][25][26][27]

See also

External links

References

  1. "Meteorological Kites Scientific Kites of the Industrial Revolution by M. Robinson". Kitehistory.com. Retrieved 3 January 2012. 
  2. "Course 104 – Kite Lines". Awindofchange.com. Retrieved 3 January 2012. 
  3. "Knots and Hitches for Kite Flying James S. Aber". Geospectra.net. Retrieved 3 January 2012. 
  4. Lines and Winders
  5. "Sport and Stunt kite flying line". Windstarkites.com. Retrieved 3 January 2012. 
  6. Mechanical Cable and Wire Rope
  7. "Kite history in Germany". Kites.org. 1 August 1919. Retrieved 3 January 2012. 
  8. "Knight Precision Wire". Knight Precision Wire. 24 June 2010. Retrieved 3 January 2012. 
  9. whitecat (3 July 2008). "Through my lens: dyeing kite strings Ahmedabad". Whitecatsg.blogspot.com. Retrieved 3 January 2012. 
  10. "Lindenberg – historical world attitude record in 1919". Kites.org. 1 August 1919. Retrieved 3 January 2012. 
  11. New World Record!
  12. http://www.kitesite.com.au/kiterecord/index.html
  13. "Mechanical, physical and environmental properties of Dyneema, Ultra-high-molecular-weight polyethylene or UHMWPE fiber, Synthetic fibers, Fibers | Matbase – Material Properties Database". Matbase. Retrieved 3 January 2012. 
  14. "Gallery – Kitelife Magazine". Kitelife.com. Retrieved 3 January 2012. 
  15. "Distributors of Kevlar®, Technora®, and Spectra® based lines – coated Kevlar®". TwinLine. Retrieved 3 January 2012. 
  16. "How To Get The Right Hang Height by Mike Meier". Willswing.com. 26 October 2000. Retrieved 3 January 2012. 
  17. "Aerobotics. Kites and Meteorology". Ctie.monash.edu.au. Retrieved 3 January 2012. 
  18. "Tow Tech Supply". Mojosgear.com. 25 July 2008. Retrieved 3 January 2012. 
  19. 20.0 20.1 "Spiders by Ann R. Heinrichs. Google Books. She observes that the so called ballooning is like a kite or balloon; she is mechanically correct about the kite part, as no true balloon is ever formed by the spider as told in the other references". Google Books. Retrieved 3 January 2012. 
  20. 21.0 21.1 "Flying Spiders over Texas! Coast to Coast. Chad B., Texas State University Undergrad: He correctly describes the mechanical kiting of spider "ballooning"". Snerdey.com. Retrieved 3 January 2012. 
  21. mol smith. "The Spider's Web". Microscopy-uk.org.uk. Retrieved 3 January 2012. 
  22. Electric Line Safety.
  23. "Kite Safety". Awindofchange.com. Retrieved 3 January 2012. 
  24. Kites & Kids
  25. "3rd Avenue Kiteboarding Safety Guidelines". Sfba.org. Retrieved 3 January 2012. 
  26. by Hifliercanada. "Best Breezes. Essay: "Kite Lines Contribute to Tragic Helicopter Accident in Philippines"". Best-breezes.squarespace.com. Retrieved 3 January 2012. 
This article is issued from Wikipedia. The text is available under the Creative Commons Attribution/Share Alike; additional terms may apply for the media files.