Gordon Dam

From Wikipedia, the free encyclopedia
Gordon Dam
Location SW Tasmania, Australia
Coordinates 42°43′50″S 145°58′35″E / 42.73056°S 145.97639°E / -42.73056; 145.97639Coordinates: 42°43′50″S 145°58′35″E / 42.73056°S 145.97639°E / -42.73056; 145.97639
Opening date 1978
Owner(s) Hydro Tasmania
Dam and spillways
Type of dam Arch dam
Impounds Gordon River
Length 192 m (630 ft)
Height 140 m (459 ft)
Width (base) 18 m (59 ft)
Reservoir
Creates Lake Gordon
Total capacity 12.5 km3 (3.0 cu mi)
Surface area 272 km2 (105 sq mi)
Power station
Turbines 3 × 144 MW
Installed capacity 432 MW
Website
http://www.hydro.com.au

The Gordon Dam (also known as Gordon River Dam), is a double curvature arch dam on the Gordon River in Tasmania, Australia. The dam has a length of 192 m (630 ft), and a height of 140 m (459 ft),[1] making it the tallest dam in Tasmania and the fifth-tallest in Australia.[2]

Water from the dam drops 183 m (600 ft) underground into its power station, where three turbines of 144 MW generates up to 432 MW of power, covering about 13% of the electricity demand of Tasmania.[3] The first two turbines were commissioned in 1978, before the third was commissioned a decade later in 1988.[4]

The power station is fuelled by water from Lake Gordon. Water from Lake Pedder is also drawn into Lake Gordon through the McPartlans Pass Canal at 42°50′51″S 146°11′45″E / 42.84750°S 146.19583°E / -42.84750; 146.19583 (McPartlans Pass Canal).

History

In 1963, the Federal Government of Australia provided a A$5 million grant to Tasmania's Hydro-Electric Commission to build the Gordon River Road from Maydena into the Gordon River area in the South West Wilderness region.[5] Construction was underway by 1964, and within three years, the Tasmanian State Parliament approved the Gordon River Power Development with little in house opposition in 1967.

The completed Gordon Dam was the only dam built on the Gordon River, despite the support of Tasmanian politicians such as Eric Reece, Robyn Gray, and others to build the Franklin Dam further downstream.

The dam was designed with Dr. Sergio Guidici as the chief engineer. He went on to be involved with the design of the Crotty Dam in the West Coast Range, one of the last significant dams created by Hydro Tasmania during its unabated dam-building era.

  • Shaft connecting the third turbine to the rotor. The bearing at the top supports the load of the shaft and turbine, the bottom bearing is primarily for alignment.

  • Main shut off butterfly valve for second turbine.

  • Stator and rotor for second turbine. The clear port in the foreground allows the view of bearing lubricant.

See also

Wikimedia Commons has media related to Gordon Dam.

References

  1. ↑ "Gordon_Power_Station Fact Sheet". hydro.com.au. 
  2. ↑ "Australia's Highest Dams" (pdf). The Australian National Committee on Large Dams Incorporated. Retrieved 2008-04-07. "The five tallest dams listed in order of decreasing height are: Dartmouth Dam, 180m, Victoria; Thomson River Dam, 166m, Victoria; Talbingo Dam, 162m, NSW; Warragamba Dam, 142m, NSW; Gordon Dam, 140m, Tasmania" 
  3. ↑ "The Gordon Catchment". 
  4. ↑ "Engineers Australia". National Engineering Landmark explanatory pdf. 
  5. ↑ Thompson, Peter (1981) Power In Tasmania ACF ISBN 0-85802-064-5 pp.19
Gordon Power Development
Hydroelectric
Non-hydroelectric
This article is issued from Wikipedia. The text is available under the Creative Commons Attribution/Share Alike; additional terms may apply for the media files.