Energy recycling

Energy recycling is the energy recovery process of utilizing energy that would normally be wasted, usually by converting it into electricity or thermal energy. Undertaken at manufacturing facilities, power plants, and large institutions such as hospitals and universities, it significantly increases efficiency, thereby reducing energy costs and greenhouse gas pollution simultaneously. The process is noted for its potential to mitigate global warming profitably.^[1] This work is usually done in the form of combined heat and power (also called cogeneration) or waste heat recovery.

Forms of energy recycling

Waste heat recovery is a process that captures excess heat that would normally be discharged at manufacturing facilities and converts it into electricity and steam, or returns energy to the manufacturing process in the form of heated air, water, glycol, or oil.^[2] A "waste heat recovery boiler" contains a series of water-filled tubes placed throughout the area where heat is released. When high-temperature heat meets the boiler, steam is produced, which in turn powers a turbine that creates electricity. This process is similar to that of other fired boilers, but in this case, waste heat replaces a traditional flame. No fossil fuels are used in this process. Metals, glass, pulp and paper, silicon and other production plants are typical locations where waste heat recovery can be effective.^[1]

Waste heat recovery from air conditioning is also used as an alternative to wasting heat to the atmosphere from chiller plants. Heat recovered in summer from chiller plants is stored in Thermalbanks^[3] in the ground and recycled back to the same building in winter via a heat pump to provide heating without burning fossil fuels. This elegant approach saves energy - and carbon - in both seasons by recycling summer heat for winter use.

Combined heat and power (CHP), also called cogeneration, is, according to the U.S. Environmental Protection Agency, “an efficient, clean, and reliable approach to generating electricity and heat energy from a single fuel source. By installing a CHP system designed to meet the thermal and electrical base loads of a facility, CHP can greatly increase the facility's operational efficiency and decrease energy costs. At the same time, CHP reduces the emission of greenhouse gases, which contribute to global climate change.” When electricity is produced on-site with a CHP plant, excess heat is recycled to produce both processed heat and additional power.^[4][5]

Enabling technologies: Heat pumps and thermal energy storage are classes of technologies that can enable the recycling of energy that would otherwise be inaccessible due to a temperature that is too low for utilization or a time lag between when the energy is available and when it is needed. While enhancing the temperature of available renewable thermal energy, heat pumps have the additional property of leveraging electrical power (or in some cases mechanical or thermal power) by using it to extract additional energy from a low quality source (such as seawater, lake water, the ground, the air, or waste heat from a process).

Thermal storage technologies allow heat or cold to be stored for periods of time ranging from hours or overnight to interseasonal, and can involve storage of sensible energy (i.e. by changing the temperature of a medium) or latent energy (i.e. through phase changes of a medium, such between water and slush or ice). Short-term thermal storages can be used for peak-shaving in district heating or electrical distribution systems. Kinds of renewable or alternative energy sources that can be enabled include natural energy (e.g. collected via solar-thermal collectors, or dry cooling towers used to collect winter's cold), waste energy (e.g. from HVAC equipment, industrial processes or power plants), or surplus energy (e.g. as seasonally from hyropower projects or intermittently from wind farms). The Drake Landing Solar Community (Alberta, Canada) is illustrative. borehole thermal energy storage allows the community to get 97% of its year-round heat from solar collectors on the garage roofs, which most of the heat collected in summer.^[6][7] Types of storages for sensible energy include insulated tanks, borehole clusters in substrates ranging from gravel to bedrock, deep aquifers, or shallow lined pits that are insulated on top. Some types of storage are capable of storing heat or cold between opposing seasons (particularly if very large), and some storage applications require inclusion of a heat pump. Latent heat is typically stored in ice tanks or what are called phase-change materials (PCMs).

Current system

Both waste heat recovery and CHP constitute "decentralized" energy production, which is in contrast to traditional "centralized" power generated at large power plants run by regional utilities.^[5] The “centralized” system has an average efficiency of 34 percent, requiring about three units of fuel to produce one unit of power.^[8] By capturing both heat and power, CHP and waste heat recovery projects have higher efficiencies.

A 2007 Department of Energy study found the potential for 135,000 megawatts of CHP in the U.S.,^[9] and a Lawrence Berkley National Laboratory study identified about 64,000 megawatts that could be obtained from industrial waste energy, not counting CHP.^[10] These studies suggest about 200,000 megawatts—or 20% -- of total power capacity that could come from energy recycling in the U.S. Widespread use of energy recycling could therefore reduce global warming emissions by an estimated 20 percent.^[11] Indeed, as of 2005, about 42 percent of U.S. greenhouse gas pollution came from the production of electricity and 27 percent from the production of heat.^[12][13]

Advocates contend that recycled energy costs less and has lower emissions than most other energy options in current use.^[14]

Currently RecyclingEnergy Int. Corp. takes advantage of recycling energy in heat recovery ventilation and latent heat pump and CHCP.^[15]

History

Perhaps the first modern use of energy recycling was done by Thomas Edison. His 1882 Pearl Street Station, the world’s first commercial power plant, was a CHP plant, producing both electricity and thermal energy while using waste heat to warm neighboring buildings.^[16] Recycling allowed Edison’s plant to achieve approximately 50 percent efficiency.

By the early 1900s, regulations emerged to promote rural electrification through the construction of centralized plants managed by regional utilities. These regulations not only promoted electrification throughout the countryside, but they also discouraged decentralized power generation, such as CHP. They even went so far as to make it illegal for non-utilities to sell power.^[17]

By 1978, Congress recognized that efficiency at central power plants had stagnated and sought to encourage improved efficiency with the Public Utility Regulatory Policies Act (PURPA), which encouraged utilities to buy power from other energy producers. CHP plants proliferated, soon producing about 8 percent of all energy in the U.S.^[18] However, the bill left implementation and enforcement up to individual states, resulting in little or nothing being done in many parts of the country.

In 2008 Tom Casten, chairman of Recycled Energy Development, said that "We think we could make about 19 to 20 percent of U.S. electricity with heat that is currently thrown away by industry."^[19]

Outside the U.S., energy recycling is more common. Denmark is probably the most active energy recycler, obtaining about 55% of its energy from CHP and waste heat recovery. Other large countries, including Germany, Russia, and India, also obtain a much higher share of their energy from decentralized sources.^[18][19]

References

v t e Recycling Materials Aluminium Asphalt Concrete Copper Cotton Energy Ferrous metals Glass Gypsum Motor oil Paint Paper Plastic Refrigerant Scrap Timber Vegetable oil Water Products Appliances Batteries Bottles PET bottles Computers Fluorescent lamps Lumber Mobile phones Ships Textiles Tires Vehicles Apparatus Bins Blue bags Blue boxes Codes Collection Materials recovery facility Waste sorting Countries Brazil Canada Ireland Japan The Netherlands United Kingdom Northern Ireland United States Concepts Dematerialization Downcycling Eco-industrial park Ecodesign Extended producer responsibility Freecycling Industrial ecology Industrial metabolism Material flow analysis Precycling Product stewardship Recursive recycling Recycling (ecological) Resource recovery Reuse Upcycling Urban lumberjacking Waste hierarchy Waste minimisation Waste picking Zero waste See also Composting Container deposit legislation Dumpster diving Ethical consumerism Freeganism Simple living Waste Waste-to-energy Waste collection Waste legislation Waste management Waste management concepts Environment portal Category by country by material by product organizations Commons

v t e Environmental technology Appropriate technology Clean technology Environmental design Environmental impact assessment Sustainable development Sustainable technology Pollution Air pollution (control dispersion modeling) Industrial ecology Solid waste treatment Waste management Water (agricultural wastewater treatment industrial wastewater treatment sewage treatment waste-water treatment technologies water purification) Renewable energy Alternative energy Efficient energy use Energy development Energy recovery Fuel (alternative fuel biofuel carbon negative fuel hydrogen technologies) List of energy storage projects Renewable energy (commercialization) Sustainable energy Transportation (electric vehicle hybrid vehicle) Conservation Birth control Building (green natural sustainable architecture) Conservation biology Conservation ethic Ecoforestry Environmental preservation Environmental remediation Green computing Permaculture Recycling