Drafting water

From Wikipedia, the free encyclopedia

Fire engine drafting

The term drafting water refers to the use of suction to move a liquid such as water from a vessel or body of water below the intake of a suction pump. A rural fire department or farmer might draft water from a pond as the first step in moving the water elsewhere. A suction pump creates a partial vacuum (a "draft") and the atmospheric pressure on the water's surface forces the water into the pump, usually via a rigid pipe (sometimes called a "dry hydrant") or a semi-rigid "hard suction hose".^[1]^[2]

Standard atmospheric pressure is 101 kPa (14.7 lbf/in²) and that can only raise water to a theoretical maximum of 10.3 metres (33.9 ft). Depending on application, fire department pumps lift water 6 to 10 metres (20 to 30 ft).

Medium diameter hard suction hose, with attached strainer, for use with wildland firefighting apparatus.

To reduce drafting friction and obtain a larger flow or higher lift, a larger cross-section of suction hose is employed. For example, using a 5 inch (127 mm) hose, a pump that could lift 500 US gallons per minute (30 L/s) up 23 feet (7 m) would only be able to lift the same amount of water 12.5 feet (4 m) through a 3.5 inch (76 mm) hose. Fire engines are often seen carrying two or three 10 foot (3 m) lengths of suction hose, but the longer the lift, the lower the flow, for a fixed diameter suction hose and a given pump. Multiple relays could be used if the need arises, with a suction pump drafting up to 10 metres (30 ft), and discharging at great distances.

It is also possible to use a gravity siphon to draft water for a small lift, and this technique is often used in forest fire suppression, where portable reservoirs of 1,000 to 3,000 US gallons (5 to 10 m³) are filled with water and small hoses are used downhill of the tanks. The nozzle pressure is proportional to its distance below the reservoir surface. Forty-three percent of the distance, in feet, is approximately the number of pounds per square inch pressure (e.g., 100 feet lower: 43 psi). The tank may itself be gravity-fed through hoses from a nearby water source, or by pumps or helicopters delivering water from further away.

References

↑ Corbett, Glenn. Fire Engineering's Handbook for Firefighter I and II. p. 434.
↑ Lowell Fire Department. Drafting Drill.

v t e Firefighting

Personnel	Fire chief Fire captain Fire marshal Fire police Handcrew Station officer Volunteer fire department Women in firefighting

Facilities	Fire department Fire lookout tower Fire station

Apparatus	Airport Crash Fire chief's vehicle Rescue pumper Quint Tender

Equipment	Bunker gear Escape chair Fire apparatus Fire extinguisher Fire hose Fire hydrant Fire retardant Fire shelter Fireman's switch Flame retardant Fog nozzle Hard suction hose Hazmat suit Heat detector Nomex PASS SCBA Siren Smoke detector Thermal imaging camera

Terminology	Dead man zone Deluge gun Draft Fire classes Fire control Fire safety Fire triangle Fireman's carry Firewall Flash fire Forcible entry Gaseous fire suppression Stop, drop and roll Structure fire Two-in, two-out Ventilation

Wildfires	Glossary of wildland fire terms Aerial firefighting Fire lookout Helitack Hotshot crew Smokejumper Suppression

Miscellaneous	Fire engine red Fire camp Fire photography Fire protection engineering Firefighting worldwide History of firefighting International Association of Fire Fighters International Firefighters' Day List of firefighting films Muster Saint Florian World Police and Fire Games

This article is issued from Wikipedia. The text is available under the Creative Commons Attribution/Share Alike; additional terms may apply for the media files.

Drafting water

References

See also