Polymyxin

Polymyxins are antibiotics,[1] with a general structure consisting of a cyclic peptide with a long hydrophobic tail. They disrupt the structure of the bacterial cell membrane by interacting with its phospholipids. They are produced by the Gram-positive bacterium Bacillus polymyxa[2] and are selectively toxic for Gram-negative bacteria due to their specificity for the lipopolysaccharide molecule that exists within many Gram-negative outer membranes.

Polymyxins B and E (also known as colistin) are used in the treatment of Gram-negative bacterial infections. The global problem of advancing antimicrobial resistance has led to a renewed interest in their use recently.[3]

Polymyxin M is also known as "mattacin".[4]

Contents

Mechanism of action

After binding to lipopolysaccharide (LPS) in the outer membrane of Gram-negative bacteria, polymyxins disrupt both the outer and inner membranes. The hydrophobic tail is important in causing membrane damage, suggesting a detergent-like mode of action.

Removal of the hydrophobic tail of polymyxin B yields polymyxin nonapeptide, which still binds to LPS but no longer kills the bacterial cell. However, it still detectably increases the permeability of the bacterial cell wall to other antibiotics, indicating that it still causes some degree of membrane disorganization.

Gram-negative bacteria can develop resistance to polymyxins through various modifications of the LPS structure that inhibit the binding of polymyxins to LPS.[5]

Clinical use

Polymyxin antibiotics are relatively neurotoxic and nephrotoxic[6] and are usually used only as a last resort if modern antibiotics are ineffective or are contraindicated. Typical uses are for infections caused by strains of multidrug-resistant Pseudomonas aeruginosa or carbapenemase-producing Enterobacteriaceae.

Polymyxins are not absorbed from the gastrointestinal tract, and, therefore, another route of administration must be chosen, e.g., parenteral (often intravenously) or by inhalation.

Polymyxins have less effect on Gram positive organisms, and are sometimes combined with other agents (as with Trimethoprim/polymyxin) to broaden the effective spectrum.

Use in biomedical research

Polymyxins are used to neutralize or absorb LPS-contaminating samples that are intended for use in, e.g., immunological experiments. Minimization of LPS contamination can be important because LPS can evoke strong reactions from immune cells and, therefore, distort experimental results.

By increasing permeability of the bacterial membrane system, polymyxin is also used in clinical work to increase release of secreted toxins, such as Shiga toxin from Escherichia coli.[7]

See also

References

  1. ^ Dixon RA, Chopra I (November 1986). "Polymyxin B and polymyxin B nonapeptide alter cytoplasmic membrane permeability in Escherichia coli". J. Antimicrob. Chemother. 18 (5): 557–563. doi:10.1093/jac/18.5.557. PMID 3027012. http://jac.oxfordjournals.org/cgi/pmidlookup?view=long&pmid=3027012. 
  2. ^ MeSH Polymyxins
  3. ^ Falagas ME, Grammatikos AP, Michalopoulos A. Potential of old-generation antibiotics to address current need for new antibiotics. Expert Rev Anti Infect Ther. 2008; 6(5):593-600 PMID 18847400
  4. ^ Martin NI, Hu H, Moake MM et al. (April 2003). "Isolation, structural characterization, and properties of mattacin (polymyxin M), a cyclic peptide antibiotic produced by Paenibacillus kobensis M". J. Biol. Chem. 278 (15): 13124–13132. doi:10.1074/jbc.M212364200. PMID 12569104. http://www.jbc.org/cgi/pmidlookup?view=long&pmid=12569104. 
  5. ^ Tran AX, Lester ME, Stead CM et al. (August 2005). "Resistance to the antimicrobial peptide polymyxin requires myristoylation of Escherichia coli and Salmonella typhimurium lipid A". J. Biol. Chem. 280 (31): 28186–28194. doi:10.1074/jbc.M505020200. PMID 15951433. http://www.jbc.org/cgi/pmidlookup?view=long&pmid=15951433. 
  6. ^ Falagas ME, Kasiakou SK (February 2006). "Toxicity of polymyxins: a systematic review of the evidence from old and recent studies". Crit Care 10 (1): R27. doi:10.1186/cc3995. PMC 1550802. PMID 16507149. http://ccforum.com/content/10/1/R27. 
  7. ^ Yokoyama et al. 2000. FEMS Microbiol. Lett. 192:139-144.

Further reading

  • Giuliani A, Pirri G, Nicoletto S (2007). "Antimicrobial peptides: an overview of a promising class of therapeutics". Cent. Eur. J. Biol. 2 (1): 1–33. doi:10.2478/s11535-007-0010-5. 
  • Pirri G, Giuliani A, Nicoletto S, Pizutto L, Rinaldi A (2009). "Lipopeptides as anti-infectives: a practical perspective". Cent. Eur. J. Biol. 4 (3): 258–273. doi:10.2478/s11535-009-0031-3.