Modulational instability

In the field of nonlinear optics, modulational instability is a phenomenon whereby deviations from an optical waveform are reinforced by nonlinearity, leading to the generation of spectral-sidebands and the eventual breakup of the waveform into a train of pulses.[1]

Contents

Initial instability and gain

Modulation instability only happens under certain circumstances. The most important condition is anomalous group velocity dispersion, whereby pulses with shorter wavelengths travel with higher group velocity than pulses with longer wavelength.[1] (This condition assumes a focussing Kerr nonlinearity, whereby refractive index increases with optical intensity.) There is also a threshold power, below which no instability will be seen.[1]

The instability is strongly dependent on the frequency of the perturbation. At certain frequencies, a perturbation will have little effect, whilst at other frequencies, a perturbation will grow exponentially. The overall gain spectrum can be derived analytically, as is shown below. Random perturbations will generally contain a broad range of frequency components, and so will cause the generation of spectral sidebands which reflect the underlying gain spectrum.

The tendency of a perturbing signal to grow makes modulation instability a form of amplification. By tuning an input signal to a peak of the gain spectrum, it is possible to create an optical amplifier.

Mathematical derivation of gain spectrum

The gain spectrum can be derived [1] by starting with a model of modulation instability based upon the Nonlinear Schrödinger equation

\frac{\partial A}{\partial z}%2Bi\beta_2\frac{\partial^2A}{\partial t^2}=i\gamma|A|^2A

which describes the evolution of a slowly varying envelope A with time t and distance of propagation z. The model includes group velocity dispersion described by the parameter \beta_2, and Kerr nonlinearity with magnitude \gamma. A waveform of constant power P is assumed. This is given by the solution

A = \sqrt{P}e^{i\gamma Pz}

where the oscillatory e^{i\gamma Pz} phase factor accounts for the difference between the linear refractive index, and the modified refractive index, as raised by the Kerr effect. The beginning of instability can be investigated by perturbing this solution as

A = \left(\sqrt{P}%2B\epsilon\left(t,z\right)\right)e^{i\gamma Pz}

where \epsilon\left(t,z\right) is the perturbation term (which, for mathematical convenience, has been multiplied by the same phase factor as A). Substituting this back into the Nonlinear Schrödinger equation gives a perturbation equation of the form

\frac{\partial \epsilon}{\partial z}%2Bi\beta_2\frac{\partial^2\epsilon}{\partial t^2}=i\gamma P \left(\epsilon%2B\epsilon^*\right)

where the perturbation has been assumed to be small, such that \epsilon^2\approx 0. Instability can now be discovered by searching for solutions of the perturbation equation which grow exponentially. This can be done using a trial function of the general form

\epsilon=c_1 e^{i k_m z - i \omega_m t} %2B c_2 e^{- i k_m z %2B i \omega_m t}

where \omega_m and k_m are the frequency and wavenumber of a perturbation, and c_1 and c_2 are constants. The Nonlinear Schrödinger equation is constructed by removing the carrier wave of the light being modelled, and so the frequency of the light being perturbed is formally zero. Therefore \omega_m and k_m don't represent absolute frequencies and wavenumbers, but the difference between these and those of the initial beam of light. It can be shown that the trial function is valid, subject to the condition

k_m = \pm\sqrt{\beta_2^2\omega_m^4 %2B 2 \gamma P \beta_2 \omega_m^2}

This dispersion relation is vitally dependent on the sign of the term within the square root, as if positive, the wavenumber will be real, corresponding to mere oscillations around the unperturbed solution, whilst if negative, the wavenumber will become imaginary, corresponding to exponential growth and thus instability. Therefore, instability will occur when

\beta_2^2\omega_m^2 %2B 2 \gamma P \beta_2 < 0

This condition describes both the requirement for anomalous dispersion (such that \beta_2 is negative) and the requirement that a threshold power be exceeded. The gain spectrum can be described by defining a gain parameter as g \equiv \Im\left[2|k_m|\right], so that the power of a perturbing signal grows with distance as P \propto e^{g z}. The gain is therefore given by

g = \begin{cases} 2\sqrt{-\beta_2^2\omega_m^4-2\gamma P \beta_2\omega_m^2} &;\, -\beta_2^2\omega_m^2 - 2 \gamma P \beta_2 > 0 \\ 0 &;\, -\beta_2^2\omega_m^2 - 2 \gamma P \beta_2 \leq 0\end{cases}

where as noted above, \omega_m is the difference between the frequency of the perturbation and the frequency of the initial light.

Breakup

The waveform will eventually breakup into a train of pulses.[1]

References

  1. ^ a b c d e Agrawal, Govind P. (1995). Nonlinear fiber optics (2nd ed.). San Diego (California): Academic Press. ISBN 0-12-045142-5.