Density altitude

Density altitude is the altitude in the International Standard Atmosphere at which the air density would be equal to the actual air density at the place of observation, or, in other words, the height when measured in terms of the density of the air rather than the distance from the ground. "Density Altitude" is the pressure altitude adjusted for non-standard temperature.

Both an increase in temperature and, to a much lesser degree, humidity will cause an increase in density altitude. Thus, in hot and humid conditions, the density altitude at a particular location may be significantly higher than the true altitude.

Contents 1 Aircraft safety 2 Calculation 3 References and notes 4 See also 5 External links

Aircraft safety

Air density is perhaps the single most important factor affecting aircraft performance. It has a direct bearing on:^[1]

• The lift generated by the wings — reduction in air density reduces the wing's lift.
• The efficiency of the propeller or rotor — which for a propeller (effectively an airfoil) behaves similarly to lift on wings.
• The power output of the engine — power output depends on oxygen intake, so the engine output is reduced as the equivalent "dry air" density decreases and produces even less power as moisture displaces oxygen in more humid conditions.

Aircraft taking off from a "hot and high" airport such as the Quito Airport or Mexico City are at a significant aerodynamic disadvantage. The following effects result from a density altitude which is higher than the actual physical altitude:^[1]

• The aircraft will accelerate slower on takeoff as a result of reduced power production.
• The aircraft will need to achieve a higher true airspeed to attain the same lift - this implies both a longer takeoff roll and a higher true airspeed which must be maintained when airborne to avoid stalling.
• The aircraft will climb slower as the result of reduced power production and lift.

Due to these performance issues, a plane's takeoff weight may need to be lowered or takeoffs may need to be scheduled for cooler times of the day. Wind direction and runway slope may need to be taken into account.

Calculation

Density altitude can be calculated from atmospheric pressure and temperature (assuming dry air).

where

density altitude in feet

atmospheric (static) pressure

standard sea level atmospheric pressure (1013.25 hPa ISA or 29.92126 US))

true (static) air temperature in kelvins (K) [add 273.15 to the Celsius (°C)] figure

ISA standard sea level air temperature in kelvins (K) (288.15 K)

0.234969

Note that the leading coefficient is the ratio of the ISA sea level temperature (288.15 K) to ISA Temperature Lapse Rate (6.5 K/km), converted into feet.

National Weather Service Equation

The National Weather Service uses the following dry-air approximation of the above equation in their standards.

where

density altitude in feet

Is the station pressure (atmospheric static pressure) in inches of mercury (inHg)

T is the station temperature (atmospheric temperature) in Fahrenheit (F)

Note that the NWS standard specifies that the density altitude should be rounded to the nearest 100 feet.

Easy formula to calculate density altitude from pressure altitude

This is an easier formula to calculate (with great approximation) density altitude from pressure altitude ..and International Standard Atmosphere temperature deviation

Density altitude in feet = pressure altitude in feet + (120 x (OAT - ISA_temperature))

Where:

OAT = Outside air temperature in °C

ISA_temperature = 15 °C - (1.98 °C/1000 ft × actual altitude in thousands of feet)

References and notes

 This article incorporates public domain material from the United States Government document "Pilot's Handbook of Aeronautical Knowledge".

See also

• Outside air temperature
• Barometric formula
• List of longest runways

External links

• Density Altitude Calculator
• Density Altitude influence on aircraft performance
• Newbyte Atmospheric Calculator, Android Version